Write down the reactions involved during | Class 11 Chemistry Chapter Environmental Chemistry, Environmental Chemistry NCERT Solutions

What do you mean by ozone hole? What are its consequences?

Explain tropospheric pollution in 100 words.

What do you mean by Biochemical Oxygen Demand (BOD)?

Do you observe any soil pollution in your neighbourhood? What efforts will you make for controlling the soil pollution?

Carbon monoxide gas is more dangerous than carbon dioxide gas. Why?

What are the reactions involved for ozone layer depletion in the stratosphere?

What are the major causes of water pollution? Explain.

What would have happened if the greenhouse gases were totally missing in the earth's atmosphere? Discuss.

Statues and monuments in India are affected by acid rain. How?

How can domestic waste be used as manure?

Calculate the amount of carbon dioxide that could be produced when

(i) 1 mole of carbon is burnt in air.

(ii) 1 mole of carbon is burnt in 16 g of dioxygen.

(iii) 2 moles of carbon are burnt in 16 g of dioxygen.

The mass of an electron is 9.1 × 10^–31 kg. If its K.E. is 3.0 × 10^–25 J, calculate its wavelength.

Calculate the wavelength of an electron moving with a velocity of 2.05 × 10⁷ ms^–1.

Balance the following redox reactions by ion – electron method :

(a) MnO₄ ^– (aq) + I ^– (aq) → MnO_{2 (s)} + I_2(s) (in basic medium)

(b) MnO₄ ^– (aq) + SO_{2 (g)} → Mn²⁺ (aq) + HSO₄^– (aq) (in acidic solution)

(c) H₂O_{2 (aq)} + Fe ²⁺ (aq) → Fe³⁺ (aq) + H₂O (l) (in acidic solution)

(d) Cr₂O₇ ^2– + SO_2(g) → Cr³⁺ _(aq) + SO₄^2– (aq) (in acidic solution)

In a process, 701 J of heat is absorbed by a system and 394 J ofwork is done by the system. What is the change in internal energy for the process?

What will be the minimum pressure required to compress 500 dm³ of air at 1 bar to 200 dm³ at 30°C?

In a reaction A + B2 → AB2 Identify the limiting reagent, if any, in the following reaction mixtures.

(i) 300 atoms of A + 200 molecules of B

(ii) 2 mol A + 3 mol B

(iii) 100 atoms of A + 100 molecules of B

(iv) 5 mol A + 2.5 mol B

(v) 2.5 mol A + 5 mol B

At 0°C, the density of a certain oxide of a gas at 2 bar is same as that of dinitrogen at 5 bar. What is the molecular mass of the oxide?

Which one of the following will have largest number of atoms?

(i) 1 g Au (s)

(ii) 1 g Na (s)

(iii) 1 g Li (s)

(iv) 1 g of Cl2(g)

Density of a gas is found to be 5.46 g/dm³ at 27 °C at 2 bar pressure. What will be its density at STP?

How would you convert the following compounds into benzene?

(i) Ethyne         (ii) Ethene          (iii) Hexane

Explain structures of diborane and boric acid.

For the following equilibrium, K_c = 6.3 × 10¹⁴  at 1000 K

NO (g) + O₃ (g) ↔ NO₂ (g) + O₂ (g)

Both the forward and reverse reactions in the equilibrium are elementary bimolecular reactions. What is K_c, for the reverse reaction?

Describe the change in hybridisation (if any) of the Al atom in the following reaction.

Find out the value of K_c for each of the following equilibria from the value of K_p:

(i) 2NOCl (g)  ↔  2NO (g) + Cl₂ (g);                   Kp  =  1.8 × 10^–2 at 500 K

(ii) CaCO₃ (s)  ↔  CaO(s) + CO₂(g);                  Kp  = 167 at 1073 K

In a reaction A + B2 → AB2 Identify the limiting reagent, if any, in the following reaction mixtures.

(i) 300 atoms of A + 200 molecules of B

(ii) 2 mol A + 3 mol B

(iii) 100 atoms of A + 100 molecules of B

(iv) 5 mol A + 2.5 mol B

(v) 2.5 mol A + 5 mol B

Find energy of each of the photons which

(i) correspond to light of frequency 3× 1015 Hz.

(ii) have wavelength of 0.50 Å.

Calculate the number of kJ of heat necessary to raise the temperature of 60.0 g of aluminium from 35°C to 55°C. Molar heat capacity of Al is 24 J mol^–1 K^–1.

A liquid is in equilibrium with its vapour in a sealed container at a fixed temperature. The volume of the container is suddenly increased.
a) What is the initial effect of the change on vapour pressure?
b) How do rates of evaporation and condensation change initially?
c) What happens when equilibrium is restored finally and what will be the final vapour pressure?

Write Lewis symbols for the following atoms and ions:

S and S2–; Al and Al3+; H and H–