Class 11 Chemistry - Chapter Hydrogen NCERT Solutions | Do you expect different products in solu

Justify the position of hydrogen in the periodic table on the basis of its electronic configuration.

Compare the structures of H₂O and H₂O₂.

Write chemical reactions to show the amphoteric nature of water.

Arrange the following

(i) CaH₂, BeH₂ and TiH₂ in order of increasing electrical conductance.

(ii) LiH, NaH and CsH in order of increasing ionic character.

(iii) H-H, D-D and F-F in order of increasing bond dissociation enthalpy.

(iv) NaH, MgH₂ and H₂O in order of increasing reducing property.

Discuss the principle and method of softening of hard water by synthetic ion-exchange resins.

What do you understand by the term “non-stoichiometric hydrides”? Do you expect this type of the hydrides to be formed by alkali metals? Justify your answer.

What is meant by 'demineralised' water and how can it be obtained?

What causes the temporary and permanent hardness of water?

How does H₂O₂ behave as a bleaching agent?

Why does hydrogen occur in a diatomic form rather than in a monoatomic form under normal conditions?

How do you account for the formation of ethane during chlorination of methane?

What are hybridisation states of each carbon atom in the following compounds ?

(i) CH₂=C=O,

(ii) CH₃CH=CH₂,

(iii) (CH₃)₂CO,

(iv) CH₂=CHCN,

(v) C₆H₆

What will be the minimum pressure required to compress 500 dm³ of air at 1 bar to 200 dm³ at 30°C?

What are the common physical and chemical features of alkali metals?

Calculate the molecular mass of the following:
(i) H₂O
(ii) CO₂
(iii) CH₄

Assign oxidation number to the underlined elements in each of the following species:

(a) NaH₂PO₄

(b) NaHSO₄

(c) H₄P₂O₇

(d) K₂MnO₄

(e) CaO₂

(f) NaBH₄

(g) H₂S₂O₇

(h) KAl(SO₄)₂.12 H₂O

What is the basic theme of organisation in the periodic table?

Explain the formation of a chemical bond.

Choose the correct answer. A thermodynamic state function is a quantity
(i) used to determine heat changes
(ii) whose value is independent of path
(iii) used to determine pressure volume work
(iv) whose value depends on temperature only.

A liquid is in equilibrium with its vapour in a sealed container at a fixed temperature. The volume of the container is suddenly increased.
a) What is the initial effect of the change on vapour pressure?
b) How do rates of evaporation and condensation change initially?
c) What happens when equilibrium is restored finally and what will be the final vapour pressure?

The first ionization constant of H₂S is 9.1 × 10^–8. Calculate the concentration of HS^– ion in its 0.1M solution. How will this concentration be affected if the solution is 0.1M in HCl also ? If the second dissociation constant of H₂S is 1.2 × 10^–13, calculate the concentration of S^2– under both conditions.

Calculate the atomic mass (average) of chlorine using the following data:

A 0.02 M solution of pyridinium hydrochloride has pH = 3.44. Calculate the ionization constant of pyridine

A photon of wavelength 4 × 10^–7 m strikes on metal surface, the work function of the metal being 2.13 eV. Calculate

(i) the energy of the photon (eV),

(ii) the kinetic energy of the emission, and

(iii) the velocity of the photoelectron (1 eV= 1.6020 × 10^–19 J).

What are electron deficient compounds? Are BCl₃ and SiCl₄ electron deficient species? Explain.

Write IUPAC names of the following compounds :

Beryllium and magnesium do not give colour to flame whereas other alkaline earth metals do so. Why?

If the position of the electron is measured within an accuracy of + 0.002 nm, calculate the uncertainty in the momentum of the electron. Suppose the momentum of the electron is h/4π_m × 0.05 nm, is there any problem in defining this value.

What is the lowest value of n that allows g orbitals to exist?

If ten volumes of dihydrogen gas react with five volumes of dioxygen gas, how many volumes of water vapour would be produced?