Class 11 Chemistry - Chapter Hydrogen NCERT Solutions | Arrange the following (i) CaH2, BeH2&
Arrange the following
(i) CaH2, BeH2 and TiH2 in order of increasing electrical conductance.
(ii) LiH, NaH and CsH in order of increasing ionic character.
(iii) H-H, D-D and F-F in order of increasing bond dissociation enthalpy.
(iv) NaH, MgH2 and H2O in order of increasing reducing property.
(i) The electrical conductance of a molecule depends upon its ionic or covalent nature. Ionic compounds conduct, whereas covalent compounds do not.
BeH2 is a covalent hydride. Hence, it does not conduct. CaH2 is an ionic hydride, which conducts electricity in the molten state. Titanium hydride, TiH2 is metallic in nature and conducts electricity at room temperature. Hence, the increasing order of electrical conductance is as follows:
BeH2 < CaH2 < TiH2
(ii) The ionic character of a bond is dependent on the electronegativities of the atoms involved. The higher the difference between the electronegativities of atoms, the smaller is the ionic character.
Electronegativity decreases down the group from Lithium to Caesium. Hence, the ionic character of their hydrides will increase (as shown below).
LiH < NaH < CsH
(iii) Bond dissociation energy depends upon the bond strength of a molecule, which in turn depends upon the attractive and repulsive forces present in a molecule.
The bond pair in D-D bond is more strongly attracted by the nucleus than the bond pair in H-H bond. This is because of the higher nuclear mass of D2. The stronger the attraction, the greater will be the bond strength and the higher is the bond dissociation enthalpy. Hence, the bond dissociation enthalpy of D-D is higher than H-H.
However, bond dissociation enthalpy is the minimum in the case of F-F. The bond pair experiences strong repulsion from the lone pairs present on each F-centre.
Therefore, the increasing order of bond dissociation enthalpy is as follows:
F-F < H-H < D-D
(iv) Ionic hydrides are strong reducing agents. NaH can easily donate its electrons. Hence, it is most reducing in nature.
Both, MgH2 and H2O are covalent hydrides. H2O is less reducing than MgH2 since the bond dissociation energy of H2O is higher than MgH2.
Hence, the increasing order of the reducing property is
H2O < MgH2 < NaH.
More Questions From Class 11 Chemistry - Chapter Hydrogen
- Q:-
Justify the position of hydrogen in the periodic table on the basis of its electronic configuration.
- Q:-
Compare the structures of H2O and H2O2.
- Q:-
Write chemical reactions to show the amphoteric nature of water.
- Q:-
Discuss the principle and method of softening of hard water by synthetic ion-exchange resins.
- Q:-
What do you understand by the term “non-stoichiometric hydrides”? Do you expect this type of the hydrides to be formed by alkali metals? Justify your answer.
- Q:-
What is meant by 'demineralised' water and how can it be obtained?
- Q:-
What causes the temporary and permanent hardness of water?
- Q:-
How does H2O2 behave as a bleaching agent?
- Q:-
Why does hydrogen occur in a diatomic form rather than in a monoatomic form under normal conditions?
- Q:-
Describe the bulk preparation of dihydrogen by electrolytic method. What is the role of an electrolyte in this process?
Popular Questions of Class 11 Chemistry
- Q:-
How do you account for the formation of ethane during chlorination of methane?
- Q:-
What are hybridisation states of each carbon atom in the following compounds ?
(i) CH2=C=O,
(ii) CH3CH=CH2,
(iii) (CH3)2CO,
(iv) CH2=CHCN,
(v) C6H6
- Q:-
What will be the minimum pressure required to compress 500 dm3 of air at 1 bar to 200 dm3 at 30°C?
- Q:-
What are the common physical and chemical features of alkali metals?
- Q:-
Calculate the molecular mass of the following:
(i) H2O
(ii) CO2
(iii) CH4 - Q:-
Assign oxidation number to the underlined elements in each of the following species:
(a) NaH2PO4
(b) NaHSO4
(c) H4P2O7
(d) K2MnO4
(e) CaO2
(f) NaBH4
(g) H2S2O7
(h) KAl(SO4)2.12 H2O
- Q:-
What is the basic theme of organisation in the periodic table?
- Q:-
Explain the formation of a chemical bond.
- Q:-
Choose the correct answer. A thermodynamic state function is a quantity
(i) used to determine heat changes
(ii) whose value is independent of path
(iii) used to determine pressure volume work
(iv) whose value depends on temperature only. - Q:-
A liquid is in equilibrium with its vapour in a sealed container at a fixed temperature. The volume of the container is suddenly increased.
a) What is the initial effect of the change on vapour pressure?
b) How do rates of evaporation and condensation change initially?
c) What happens when equilibrium is restored finally and what will be the final vapour pressure?
Recently Viewed Questions of Class 11 Chemistry
- Q:-
Discuss the principle of estimation of halogens, sulphur and phosphorus present in an organic compound.
- Q:-
Pay load is defined as the difference between the mass of displaced air and the mass of the balloon. Calculate the pay load when a balloon of radius 10 m, mass 100 kg is filled with helium at 1.66 bar at 27°C. (Density of air = 1.2 kg m–3 and R = 0.083 bar dm3 K–1 mol–1).
- Q:-
Express the following in the scientific notation:
(i) 0.0048
(ii) 234,000
(iii) 8008
(iv) 500.0
(v) 6.0012 - Q:-
At 1127 K and 1 atm pressure, a gaseous mixture of CO and CO2 in equilibrium with soild carbon has 90.55% CO by mass
C (s) + CO2 (g) ↔ 2CO (g)
Calculate Kc for this reaction at the above temperature.
- Q:-
Explain the terms Inductive and Electromeric effects. Which electron displacement effect explains the following correct orders of acidity of the carboxylic acids?
(a) Cl3CCOOH > Cl2CHCOOH > ClCH2COOH
(b) CH3CH2COOH > (CH3)2CHCOOH > (CH3)3C.COOH
- Q:-
Reaction between N2 and O2– takes place as follows:
2N2 (g) + O2 (g) ↔ 2N2O (g)
If a mixture of 0.482 mol N2 and 0.933 mol of O2 is placed in a 10 L reaction vessel and allowed to form N2O at a temperature for which Kc = 2.0 × 10–37, determine the composition of equilibrium mixture.
- Q:-
Calculate the enthalpy change on freezing of 1.0 mol of water at 10.0°C to ice at -10.0°C. ΔfusH = 6.03 kJ mol-1 at 0°C.
Cp[H2O(l)] = 75.3 J mol-1 K-1
Cp[H2O(s)] = 36.8 J mol-1 K-1
- Q:-
Predict the formula of the stable binary compounds that would be formed by the combination of the following pairs of elements. (a) Lithium and oxygen
(b) Magnesium and nitrogen
(c) Aluminium and iodine
(d) Silicon and oxygen
(e) Phosphorus and fluorine
(f) Element 71 and fluorine - Q:-
For the following compounds, write structural formulas and IUPAC names for all possible isomers having the number of double or triple bond as indicated :
(a) C4H8 (one double bond)
(b) C5H8 (one triple bond)
- Q:-
Write the expression for the equilibrium constant, Kc for each of the following reactions:
(i) 2NOCl (g) ↔ 2NO (g) + Cl2 (g)
(ii) 2Cu(NO3)2 (s) ↔ 2CuO (s) + 4NO2 (g) + O2 (g)
(iii) CH3COOC2H5(aq) + H2O(l) ↔ CH3COOH (aq) + C2H5OH (aq)
(iv) Fe3+ (aq) + 3OH– (aq) ↔ Fe(OH)3 (s)
(v) I2 (s) + 5F2 ↔ 2IF5
- All Chapters Of Class 11 Chemistry
- All Subjects Of Class 11