Nitric oxide reacts with Br2 and gives n | Class 11 Chemistry Chapter Equilibrium, Equilibrium NCERT Solutions

For the following equilibrium, K_c = 6.3 × 10¹⁴  at 1000 K

NO (g) + O₃ (g) ↔ NO₂ (g) + O₂ (g)

Both the forward and reverse reactions in the equilibrium are elementary bimolecular reactions. What is K_c, for the reverse reaction?

Find out the value of K_c for each of the following equilibria from the value of K_p:

(i) 2NOCl (g)  ↔  2NO (g) + Cl₂ (g);                   Kp  =  1.8 × 10^–2 at 500 K

(ii) CaCO₃ (s)  ↔  CaO(s) + CO₂(g);                  Kp  = 167 at 1073 K

A liquid is in equilibrium with its vapour in a sealed container at a fixed temperature. The volume of the container is suddenly increased.
a) What is the initial effect of the change on vapour pressure?
b) How do rates of evaporation and condensation change initially?
c) What happens when equilibrium is restored finally and what will be the final vapour pressure?

What is the equilibrium concentration of each of the substances in the equilibrium when the initial concentration of ICl was 0.78 M ?

2ICl (g)  ↔  I₂ (g) + Cl₂ (g);     Kc = 0.14

A sample of pure PCl5 was introduced into an evacuated vessel at 473 K. After equilibrium was attained, concentration of PCl5 was found to be 0.5 × 10^–1 mol L^–1. If value of Kc is 8.3 × 10^–3, what are the concentrations of PCl₃ and Cl₂ at equilibrium?

PCl₅ (g) ↔ PCl₃ (g) + Cl₂(g)

Ethyl acetate is formed by the reaction between ethanol and acetic acid and the equilibrium is represented as:

CH₃COOH (l) + C₂H₅OH (l) ↔ CH₃COOC₂H₅ (l) + H₂O (l)

(i) Write the concentration ratio (reaction quotient), Q_c, for this reaction (note: water is not in excess and is not a solvent in this reaction)

(ii) At 293 K, if one starts with 1.00 mol of acetic acid and 0.18 mol of ethanol, there is 0.171 mol of ethyl acetate in the final equilibrium mixture. Calculate the equilibrium constant.

(iii) Starting with 0.5 mol of ethanol and 1.0 mol of acetic acid and maintaining it at 293 K, 0.214 mol of ethyl acetate is found after sometime. Has equilibrium been reached?

The first ionization constant of H₂S is 9.1 × 10^–8. Calculate the concentration of HS^– ion in its 0.1M solution. How will this concentration be affected if the solution is 0.1M in HCl also ? If the second dissociation constant of H₂S is 1.2 × 10^–13, calculate the concentration of S^2– under both conditions.

The reaction,

CO(g) + 3H₂(g) ↔ CH₄(g) + H₂O(g)

is at equilibrium at 1300 K in a 1L flask. It also contain 0.30 mol of CO, 0.10 mol of H₂ and 0.02 mol of H₂O and an unknown amount of CH₄ in the flask. Determine the concentration of CH₄ in the mixture. The equilibrium constant, K_c for the reaction at the given temperature is 3.90.

At 700 K, equilibrium constant for the reaction:

H2 (g) + I2 (g) ↔ 2HI (g)

is 54.8. If 0.5 mol L^–1 of HI(g) is present at equilibrium at 700 K, what are the concentration of H₂(g) and I₂(g) assuming that we initially started with HI(g) and allowed it to reach equilibrium at 700K?

The ionization constant of dimethylamine is 5.4 x 10^-4. Calculate its degree of ionization in its 0.02 M solution. What percentage of dimethylamine is ionized if the solution is also 0.1 M in NaOH?

Calculate the amount of carbon dioxide that could be produced when

(i) 1 mole of carbon is burnt in air.

(ii) 1 mole of carbon is burnt in 16 g of dioxygen.

(iii) 2 moles of carbon are burnt in 16 g of dioxygen.

The mass of an electron is 9.1 × 10^–31 kg. If its K.E. is 3.0 × 10^–25 J, calculate its wavelength.

Calculate the wavelength of an electron moving with a velocity of 2.05 × 10⁷ ms^–1.

Balance the following redox reactions by ion – electron method :

(a) MnO₄ ^– (aq) + I ^– (aq) → MnO_{2 (s)} + I_2(s) (in basic medium)

(b) MnO₄ ^– (aq) + SO_{2 (g)} → Mn²⁺ (aq) + HSO₄^– (aq) (in acidic solution)

(c) H₂O_{2 (aq)} + Fe ²⁺ (aq) → Fe³⁺ (aq) + H₂O (l) (in acidic solution)

(d) Cr₂O₇ ^2– + SO_2(g) → Cr³⁺ _(aq) + SO₄^2– (aq) (in acidic solution)

In a process, 701 J of heat is absorbed by a system and 394 J ofwork is done by the system. What is the change in internal energy for the process?

What will be the minimum pressure required to compress 500 dm³ of air at 1 bar to 200 dm³ at 30°C?

In a reaction A + B2 → AB2 Identify the limiting reagent, if any, in the following reaction mixtures.

(i) 300 atoms of A + 200 molecules of B

(ii) 2 mol A + 3 mol B

(iii) 100 atoms of A + 100 molecules of B

(iv) 5 mol A + 2.5 mol B

(v) 2.5 mol A + 5 mol B

At 0°C, the density of a certain oxide of a gas at 2 bar is same as that of dinitrogen at 5 bar. What is the molecular mass of the oxide?

Which one of the following will have largest number of atoms?

(i) 1 g Au (s)

(ii) 1 g Na (s)

(iii) 1 g Li (s)

(iv) 1 g of Cl2(g)

Density of a gas is found to be 5.46 g/dm³ at 27 °C at 2 bar pressure. What will be its density at STP?

How would you convert the following compounds into benzene?

(i) Ethyne         (ii) Ethene          (iii) Hexane

Explain structures of diborane and boric acid.

Describe the change in hybridisation (if any) of the Al atom in the following reaction.

In a reaction A + B2 → AB2 Identify the limiting reagent, if any, in the following reaction mixtures.

(i) 300 atoms of A + 200 molecules of B

(ii) 2 mol A + 3 mol B

(iii) 100 atoms of A + 100 molecules of B

(iv) 5 mol A + 2.5 mol B

(v) 2.5 mol A + 5 mol B

Find energy of each of the photons which

(i) correspond to light of frequency 3× 1015 Hz.

(ii) have wavelength of 0.50 Å.

Calculate the number of kJ of heat necessary to raise the temperature of 60.0 g of aluminium from 35°C to 55°C. Molar heat capacity of Al is 24 J mol^–1 K^–1.

Write Lewis symbols for the following atoms and ions:

S and S2–; Al and Al3+; H and H–

Calculate the amount of carbon dioxide that could be produced when

(i) 1 mole of carbon is burnt in air.

(ii) 1 mole of carbon is burnt in 16 g of dioxygen.

(iii) 2 moles of carbon are burnt in 16 g of dioxygen.

While sulphur dioxide and hydrogen peroxide can act as oxidising as well as reducing agents in their reactions, ozone and nitric acid act only as oxidants. Why?

Addition of HBr to propene yields 2-bromopropane, while in the presence of benzoyl peroxide, the same reaction yields 1-bromopropane. Explain and give mechanism.