Class 11 Chemistry - Chapter Hydrogen NCERT Solutions | Describe the structure of the common for

Justify the position of hydrogen in the periodic table on the basis of its electronic configuration.

Compare the structures of H₂O and H₂O₂.

Write chemical reactions to show the amphoteric nature of water.

Arrange the following

(i) CaH₂, BeH₂ and TiH₂ in order of increasing electrical conductance.

(ii) LiH, NaH and CsH in order of increasing ionic character.

(iii) H-H, D-D and F-F in order of increasing bond dissociation enthalpy.

(iv) NaH, MgH₂ and H₂O in order of increasing reducing property.

Discuss the principle and method of softening of hard water by synthetic ion-exchange resins.

What do you understand by the term “non-stoichiometric hydrides”? Do you expect this type of the hydrides to be formed by alkali metals? Justify your answer.

What is meant by 'demineralised' water and how can it be obtained?

What causes the temporary and permanent hardness of water?

How does H₂O₂ behave as a bleaching agent?

Why does hydrogen occur in a diatomic form rather than in a monoatomic form under normal conditions?

How do you account for the formation of ethane during chlorination of methane?

What are hybridisation states of each carbon atom in the following compounds ?

(i) CH₂=C=O,

(ii) CH₃CH=CH₂,

(iii) (CH₃)₂CO,

(iv) CH₂=CHCN,

(v) C₆H₆

What will be the minimum pressure required to compress 500 dm³ of air at 1 bar to 200 dm³ at 30°C?

What are the common physical and chemical features of alkali metals?

Calculate the molecular mass of the following:
(i) H₂O
(ii) CO₂
(iii) CH₄

Assign oxidation number to the underlined elements in each of the following species:

(a) NaH₂PO₄

(b) NaHSO₄

(c) H₄P₂O₇

(d) K₂MnO₄

(e) CaO₂

(f) NaBH₄

(g) H₂S₂O₇

(h) KAl(SO₄)₂.12 H₂O

What is the basic theme of organisation in the periodic table?

Explain the formation of a chemical bond.

Choose the correct answer. A thermodynamic state function is a quantity
(i) used to determine heat changes
(ii) whose value is independent of path
(iii) used to determine pressure volume work
(iv) whose value depends on temperature only.

A liquid is in equilibrium with its vapour in a sealed container at a fixed temperature. The volume of the container is suddenly increased.
a) What is the initial effect of the change on vapour pressure?
b) How do rates of evaporation and condensation change initially?
c) What happens when equilibrium is restored finally and what will be the final vapour pressure?

Describe the shapes of BF₃ and  BH₄^-. Assign the hybridisation of boron in these species.

What are allotropes? Sketch the structure of two allotropes of carbon namely diamond and graphite. What is the impact of structure on physical properties of two allotropes?

Draw the cis and trans structures of hex-2-ene. Which isomer will have higher b.p. and why?

Explain why pure liquids and solids can be ignored while writing the equilibrium constant expression?

Pressure is determined as force per unit area of the surface. The SI unit of pressure, Pascal is as shown below:

1Pa = 1N m^–2

If mass of air at sea level is 1034 g cm^–2, calculate the pressure in Pascal.

The pH of milk, black coffee, tomato juice, lemon juice and egg white are 6.8, 5.0, 4.2, 2.2 and 7.8 respectively. Calculate corresponding hydrogen ion concentration in each.

Calculate the molarity of a solution of ethanol in water in which the mole fraction of ethanol is 0.040 (assume the density of water to be one).

Similar to electron diffraction, neutron diffraction microscope is also used for the determination of the structure of molecules. If the wavelength used here is 800 pm, calculate the characteristic velocity associated with the neutron.

Why is a solution of potassium hydroxide used to absorb carbon dioxide evolved during the estimation of carbon present in an organic compound?

What are hybridisation states of each carbon atom in the following compounds ?

(i) CH₂=C=O,

(ii) CH₃CH=CH₂,

(iii) (CH₃)₂CO,

(iv) CH₂=CHCN,

(v) C₆H₆