Class 11 Chemistry - Chapter Some Basic Concepts of Chemistry NCERT Solutions | How many significant figures should be p

Calculate the amount of carbon dioxide that could be produced when

(i) 1 mole of carbon is burnt in air.

(ii) 1 mole of carbon is burnt in 16 g of dioxygen.

(iii) 2 moles of carbon are burnt in 16 g of dioxygen.

In a reaction A + B2 → AB2 Identify the limiting reagent, if any, in the following reaction mixtures.

(i) 300 atoms of A + 200 molecules of B

(ii) 2 mol A + 3 mol B

(iii) 100 atoms of A + 100 molecules of B

(iv) 5 mol A + 2.5 mol B

(v) 2.5 mol A + 5 mol B

Which one of the following will have largest number of atoms?

(i) 1 g Au (s)

(ii) 1 g Na (s)

(iii) 1 g Li (s)

(iv) 1 g of Cl2(g)

Chlorine is prepared in the laboratory by treating manganese dioxide (MnO₂) with aqueous hydrochloric acid according to the reaction

4HCl_(aq) + MnO_2(s) → 2H₂O_(l) + MnCl_2(aq) + Cl_2(g)

How many grams of HCl react with 5.0 g of manganese dioxide?

Determine the empirical formula of an oxide of iron which has 69.9% iron and 30.1% dioxygen by mass.

A sample of drinking water was found to be severely contaminated with chloroform, CHCl₃, supposed to be carcinogenic in nature. The level of contamination was 15 ppm (by mass).

(i) Express this in percent by mass.

(ii) Determine the molality of chloroform in the water sample.

Calcium carbonate reacts with aqueous HCl to give CaCl₂ and CO₂ according to the reaction,

CaCO_3(s) + 2 HCl_(aq) → CaCl_2(aq) + CO_2(g) + H₂O_(l)

What mass of CaCO₃ is required to react completely with 25 mL of 0.75 M HCl?

Calculate the mass of sodium acetate (CH₃COONa) required to make 500 mL of 0.375 molar aqueous solution. Molar mass of sodium acetate is 82.0245 g mol^–1

A welding fuel gas contains carbon and hydrogen only. Burning a small sample of it in oxygen gives 3.38 g carbon dioxide, 0.690 g of water and no other products. A volume of 10.0 L (measured at STP) of this welding gas is found to weigh 11.6 g. Calculate

(i) empirical formula,

(ii) molar mass of the gas, and

(iii) molecular formula.

How many significant figures are present in the following?
(i) 0.0025
(ii) 208
(iii) 5005
(iv) 126,000
(v) 500.0
(vi) 2.0034

How do you account for the formation of ethane during chlorination of methane?

What are hybridisation states of each carbon atom in the following compounds ?

(i) CH₂=C=O,

(ii) CH₃CH=CH₂,

(iii) (CH₃)₂CO,

(iv) CH₂=CHCN,

(v) C₆H₆

What will be the minimum pressure required to compress 500 dm³ of air at 1 bar to 200 dm³ at 30°C?

What are the common physical and chemical features of alkali metals?

Assign oxidation number to the underlined elements in each of the following species:

(a) NaH₂PO₄

(b) NaHSO₄

(c) H₄P₂O₇

(d) K₂MnO₄

(e) CaO₂

(f) NaBH₄

(g) H₂S₂O₇

(h) KAl(SO₄)₂.12 H₂O

What is the basic theme of organisation in the periodic table?

Explain the formation of a chemical bond.

Choose the correct answer. A thermodynamic state function is a quantity
(i) used to determine heat changes
(ii) whose value is independent of path
(iii) used to determine pressure volume work
(iv) whose value depends on temperature only.

A liquid is in equilibrium with its vapour in a sealed container at a fixed temperature. The volume of the container is suddenly increased.
a) What is the initial effect of the change on vapour pressure?
b) How do rates of evaporation and condensation change initially?
c) What happens when equilibrium is restored finally and what will be the final vapour pressure?

Justify the position of hydrogen in the periodic table on the basis of its electronic configuration.

Give the IUPAC names of the following compounds:

Write IUPAC names of the following compounds :

Calculate the wavelength, frequency and wave number of a light wave whose period is 2.0 × 10^–10 s.

A vessel of 120 mL capacity contains a certain amount of gas at 35 °C and 1.2 bar pressure. The gas is transferred to another vessel of volume 180 mL at 35 °C. What would be its pressure?

How do you count for the following observations?

(a) Though alkaline potassium permanganate and acidic potassium permanganate both are used as oxidants, yet in the manufacture of benzoic acid from toluene we use alcoholic potassium permanganate as an oxidant. Why? Write a balanced redox equation for the reaction.

(b) When concentrated sulphuric acid is added to an inorganic mixture containing chloride, we get colourless pungent smelling gas HCl, but if the mixture contains bromide then we get red vapour of bromine. Why?

Why is Wurtz reaction not preferred for the preparation of alkanes containing odd number of carbon atoms? Illustrate your answer by taking one example.

Indicate the number of unpaired electrons in: (a) P, (b) Si, (c) Cr, (d) Fe and (e) Kr.

The degree of ionization of a 0.1M bromoacetic acid solution is 0.132. Calculate the pH of the solution and the pK_a of bromoacetic acid.

The first (ΔiH1) and the second (ΔiH) ionization enthalpies (in kJ mol–1) and the (ΔegH) electron gain enthalpy (in kJ mol–1) of a few elements are given below:

Which of the above elements is likely to be :

(a) the least reactive element.

(b) the most reactive metal.

(c) the most reactive non-metal.

(d) the least reactive non-metal.

(e) the metal which can form a stable binary halide of the formula MX₂, (X=halogen).

(f) the metal which can form a predominantly stable covalent halide of the formula MX (X=halogen)?

The species: H₂O, HCO^–₃, HSO^-₄  and NH₃ can act both as Brönsted acids and bases. For each case give the corresponding conjugate acid and base.