Class 11 Chemistry - Chapter Some Basic Concepts of Chemistry NCERT Solutions | Which one of the following will have lar

Calculate the amount of carbon dioxide that could be produced when

(i) 1 mole of carbon is burnt in air.

(ii) 1 mole of carbon is burnt in 16 g of dioxygen.

(iii) 2 moles of carbon are burnt in 16 g of dioxygen.

In a reaction A + B2 → AB2 Identify the limiting reagent, if any, in the following reaction mixtures.

(i) 300 atoms of A + 200 molecules of B

(ii) 2 mol A + 3 mol B

(iii) 100 atoms of A + 100 molecules of B

(iv) 5 mol A + 2.5 mol B

(v) 2.5 mol A + 5 mol B

Chlorine is prepared in the laboratory by treating manganese dioxide (MnO₂) with aqueous hydrochloric acid according to the reaction

4HCl_(aq) + MnO_2(s) → 2H₂O_(l) + MnCl_2(aq) + Cl_2(g)

How many grams of HCl react with 5.0 g of manganese dioxide?

Determine the empirical formula of an oxide of iron which has 69.9% iron and 30.1% dioxygen by mass.

A sample of drinking water was found to be severely contaminated with chloroform, CHCl₃, supposed to be carcinogenic in nature. The level of contamination was 15 ppm (by mass).

(i) Express this in percent by mass.

(ii) Determine the molality of chloroform in the water sample.

Calcium carbonate reacts with aqueous HCl to give CaCl₂ and CO₂ according to the reaction,

CaCO_3(s) + 2 HCl_(aq) → CaCl_2(aq) + CO_2(g) + H₂O_(l)

What mass of CaCO₃ is required to react completely with 25 mL of 0.75 M HCl?

Calculate the mass of sodium acetate (CH₃COONa) required to make 500 mL of 0.375 molar aqueous solution. Molar mass of sodium acetate is 82.0245 g mol^–1

A welding fuel gas contains carbon and hydrogen only. Burning a small sample of it in oxygen gives 3.38 g carbon dioxide, 0.690 g of water and no other products. A volume of 10.0 L (measured at STP) of this welding gas is found to weigh 11.6 g. Calculate

(i) empirical formula,

(ii) molar mass of the gas, and

(iii) molecular formula.

How many significant figures are present in the following?
(i) 0.0025
(ii) 208
(iii) 5005
(iv) 126,000
(v) 500.0
(vi) 2.0034

Dinitrogen and dihydrogen react with each other to produce ammonia according to the following chemical equation:

N2(g) + H2(g) → 2NH3(g)

(i) Calculate the mass of ammonia produced if 2.00 × 103 g dinitrogen reacts with 1.00 × 103 g of dihydrogen.

(ii) Will any of the two reactants remain unreacted?

(iii) If yes, which one and what would be its mass?

How do you account for the formation of ethane during chlorination of methane?

What are hybridisation states of each carbon atom in the following compounds ?

(i) CH₂=C=O,

(ii) CH₃CH=CH₂,

(iii) (CH₃)₂CO,

(iv) CH₂=CHCN,

(v) C₆H₆

What will be the minimum pressure required to compress 500 dm³ of air at 1 bar to 200 dm³ at 30°C?

What are the common physical and chemical features of alkali metals?

Assign oxidation number to the underlined elements in each of the following species:

(a) NaH₂PO₄

(b) NaHSO₄

(c) H₄P₂O₇

(d) K₂MnO₄

(e) CaO₂

(f) NaBH₄

(g) H₂S₂O₇

(h) KAl(SO₄)₂.12 H₂O

What is the basic theme of organisation in the periodic table?

Explain the formation of a chemical bond.

Choose the correct answer. A thermodynamic state function is a quantity
(i) used to determine heat changes
(ii) whose value is independent of path
(iii) used to determine pressure volume work
(iv) whose value depends on temperature only.

A liquid is in equilibrium with its vapour in a sealed container at a fixed temperature. The volume of the container is suddenly increased.
a) What is the initial effect of the change on vapour pressure?
b) How do rates of evaporation and condensation change initially?
c) What happens when equilibrium is restored finally and what will be the final vapour pressure?

Justify the position of hydrogen in the periodic table on the basis of its electronic configuration.

Emission transitions in the Paschen series end at orbit n = 3 and start from orbit n and can be represented as v = 3.29 × 10¹⁵ (Hz) [1/3² – 1/n²]

Calculate the value of n if the transition is observed at 1285 nm. Find the region of the spectrum.

In Rutherford’s experiment, generally the thin foil of heavy atoms, like gold, platinum etc. have been used to be bombarded by the α-particles. If the thin foil of light atoms like aluminium etc. is used, what difference would be observed from the above results?

If the position of the electron is measured within an accuracy of + 0.002 nm, calculate the uncertainty in the momentum of the electron. Suppose the momentum of the electron is h/4π_m × 0.05 nm, is there any problem in defining this value.

Comment on each of the following observations:

(a) The mobilities of the alkali metal ions in aqueous solution are Li⁺ <  Na⁺ <  K⁺ <  Rb⁺ < Cs⁺

(b) Lithium is the only alkali metal to form a nitride directly.

(c) E° for M²⁺(aq) (where M = Ca, Sr or Ba) is nearly constant.

Calculate the wave number for the longest wavelength transition in the Balmer series of atomic hydrogen.

(a) How many sub-shells are associated with n = 4?

(b) How many electrons will be present in the sub-shells having ms value of –1/2 for n = 4?

Which element do you think would have been named by
(i) Lawrence Berkeley Laboratory
(ii) Seaborg’s group?

Discuss the pattern of variation in the oxidation states of
(i) B to Tl and (ii) C to Pb.

The equilibrium constant for the following reaction is 1.6 ×10⁵ at 1024K

H₂(g) + Br₂(g) ↔ 2HBr(g)

Find the equilibrium pressure of all gases if 10.0 bar of HBr is introduced into a sealed container at 1024K.

Justify that the following reactions are redox reactions:

(a) CuO_(s) + H_2(g) → Cu_(s) + H₂O_(g)

(b) Fe₂O_3(s) + 3CO_(g) → 2Fe_(s) + 3CO_2(g)

(c) 4BCl_3(g) + 3LiAlH_4(s) → 2B₂H_6(g) + 3LiCl_(s) + 3 AlCl_{3 (s)}

(d) 2K_(s) + F_2(g) → 2K⁺F^– _(s)

(e) 4 NH_3(g) + 5 O_2(g) → 4NO_(g) + 6H₂O_(g)