Class 11 Chemistry - Chapter Hydrogen NCERT Solutions | Discuss the consequences of high enthalp

Justify the position of hydrogen in the periodic table on the basis of its electronic configuration.

Compare the structures of H₂O and H₂O₂.

Write chemical reactions to show the amphoteric nature of water.

Arrange the following

(i) CaH₂, BeH₂ and TiH₂ in order of increasing electrical conductance.

(ii) LiH, NaH and CsH in order of increasing ionic character.

(iii) H-H, D-D and F-F in order of increasing bond dissociation enthalpy.

(iv) NaH, MgH₂ and H₂O in order of increasing reducing property.

Discuss the principle and method of softening of hard water by synthetic ion-exchange resins.

What do you understand by the term “non-stoichiometric hydrides”? Do you expect this type of the hydrides to be formed by alkali metals? Justify your answer.

What is meant by 'demineralised' water and how can it be obtained?

What causes the temporary and permanent hardness of water?

How does H₂O₂ behave as a bleaching agent?

Why does hydrogen occur in a diatomic form rather than in a monoatomic form under normal conditions?

How do you account for the formation of ethane during chlorination of methane?

What are hybridisation states of each carbon atom in the following compounds ?

(i) CH₂=C=O,

(ii) CH₃CH=CH₂,

(iii) (CH₃)₂CO,

(iv) CH₂=CHCN,

(v) C₆H₆

What will be the minimum pressure required to compress 500 dm³ of air at 1 bar to 200 dm³ at 30°C?

What are the common physical and chemical features of alkali metals?

Calculate the molecular mass of the following:
(i) H₂O
(ii) CO₂
(iii) CH₄

Assign oxidation number to the underlined elements in each of the following species:

(a) NaH₂PO₄

(b) NaHSO₄

(c) H₄P₂O₇

(d) K₂MnO₄

(e) CaO₂

(f) NaBH₄

(g) H₂S₂O₇

(h) KAl(SO₄)₂.12 H₂O

What is the basic theme of organisation in the periodic table?

Explain the formation of a chemical bond.

Choose the correct answer. A thermodynamic state function is a quantity
(i) used to determine heat changes
(ii) whose value is independent of path
(iii) used to determine pressure volume work
(iv) whose value depends on temperature only.

A liquid is in equilibrium with its vapour in a sealed container at a fixed temperature. The volume of the container is suddenly increased.
a) What is the initial effect of the change on vapour pressure?
b) How do rates of evaporation and condensation change initially?
c) What happens when equilibrium is restored finally and what will be the final vapour pressure?

How would you explain the lower atomic radius of Ga as compared to Al?

Why does boron trifluoride behave as a Lewis acid?

For the reaction, 2Cl_(g) → Cl_2(g),what are the signs of ΔH and ΔS ?

How is excessive content of CO₂ responsible for global warming?

Considering the elements B, Al, Mg, and K, the correct order of their metallic character is:
(a) B > Al > Mg > K
(b) Al > Mg > B > K
(c) Mg > Al > K > B
(d) K > Mg > Al > B

How can domestic waste be used as manure?

Reaction between N₂ and O_2– takes place as follows:

2N₂ (g)  +  O₂ (g) ↔  2N₂O (g)

If a mixture of 0.482 mol N₂ and 0.933 mol of O₂ is placed in a 10 L reaction vessel and allowed to form N₂O at a temperature for which K_c = 2.0 × 10^–37, determine the composition of equilibrium mixture.

The compound AgF₂ is an unstable compound. However, if formed, the compound acts as a very strong oxidizing agent. Why?

At a certain temperature and total pressure of 10⁵ Pa, iodine vapour contains 40% by volume of I atoms

I_2(g)    ↔    2l _(g)

Calculate K_p for the equilibrium.

In the organic compound CH₂ = CH – CH₂ – CH₂ – C ≡ CH, the pair of hydridised orbitals involved in the formation of: C₂ – C₃ bond is:

(a) sp – sp²

(b) sp – sp³

(c) sp² – sp³

(d) sp³ – sp³