Class 11 Chemistry - Chapter Some Basic Concepts of Chemistry NCERT Solutions | Calculate the concentration of nitric ac

Calculate the amount of carbon dioxide that could be produced when

(i) 1 mole of carbon is burnt in air.

(ii) 1 mole of carbon is burnt in 16 g of dioxygen.

(iii) 2 moles of carbon are burnt in 16 g of dioxygen.

In a reaction A + B2 → AB2 Identify the limiting reagent, if any, in the following reaction mixtures.

(i) 300 atoms of A + 200 molecules of B

(ii) 2 mol A + 3 mol B

(iii) 100 atoms of A + 100 molecules of B

(iv) 5 mol A + 2.5 mol B

(v) 2.5 mol A + 5 mol B

Which one of the following will have largest number of atoms?

(i) 1 g Au (s)

(ii) 1 g Na (s)

(iii) 1 g Li (s)

(iv) 1 g of Cl2(g)

Chlorine is prepared in the laboratory by treating manganese dioxide (MnO₂) with aqueous hydrochloric acid according to the reaction

4HCl_(aq) + MnO_2(s) → 2H₂O_(l) + MnCl_2(aq) + Cl_2(g)

How many grams of HCl react with 5.0 g of manganese dioxide?

Determine the empirical formula of an oxide of iron which has 69.9% iron and 30.1% dioxygen by mass.

A sample of drinking water was found to be severely contaminated with chloroform, CHCl₃, supposed to be carcinogenic in nature. The level of contamination was 15 ppm (by mass).

(i) Express this in percent by mass.

(ii) Determine the molality of chloroform in the water sample.

Calcium carbonate reacts with aqueous HCl to give CaCl₂ and CO₂ according to the reaction,

CaCO_3(s) + 2 HCl_(aq) → CaCl_2(aq) + CO_2(g) + H₂O_(l)

What mass of CaCO₃ is required to react completely with 25 mL of 0.75 M HCl?

Calculate the mass of sodium acetate (CH₃COONa) required to make 500 mL of 0.375 molar aqueous solution. Molar mass of sodium acetate is 82.0245 g mol^–1

A welding fuel gas contains carbon and hydrogen only. Burning a small sample of it in oxygen gives 3.38 g carbon dioxide, 0.690 g of water and no other products. A volume of 10.0 L (measured at STP) of this welding gas is found to weigh 11.6 g. Calculate

(i) empirical formula,

(ii) molar mass of the gas, and

(iii) molecular formula.

How many significant figures are present in the following?
(i) 0.0025
(ii) 208
(iii) 5005
(iv) 126,000
(v) 500.0
(vi) 2.0034

How do you account for the formation of ethane during chlorination of methane?

What are hybridisation states of each carbon atom in the following compounds ?

(i) CH₂=C=O,

(ii) CH₃CH=CH₂,

(iii) (CH₃)₂CO,

(iv) CH₂=CHCN,

(v) C₆H₆

What will be the minimum pressure required to compress 500 dm³ of air at 1 bar to 200 dm³ at 30°C?

What are the common physical and chemical features of alkali metals?

Assign oxidation number to the underlined elements in each of the following species:

(a) NaH₂PO₄

(b) NaHSO₄

(c) H₄P₂O₇

(d) K₂MnO₄

(e) CaO₂

(f) NaBH₄

(g) H₂S₂O₇

(h) KAl(SO₄)₂.12 H₂O

What is the basic theme of organisation in the periodic table?

Explain the formation of a chemical bond.

Choose the correct answer. A thermodynamic state function is a quantity
(i) used to determine heat changes
(ii) whose value is independent of path
(iii) used to determine pressure volume work
(iv) whose value depends on temperature only.

A liquid is in equilibrium with its vapour in a sealed container at a fixed temperature. The volume of the container is suddenly increased.
a) What is the initial effect of the change on vapour pressure?
b) How do rates of evaporation and condensation change initially?
c) What happens when equilibrium is restored finally and what will be the final vapour pressure?

Justify the position of hydrogen in the periodic table on the basis of its electronic configuration.

The species: H₂O, HCO^–₃, HSO^-₄  and NH₃ can act both as Brönsted acids and bases. For each case give the corresponding conjugate acid and base.

Why is LiF almost insoluble in water whereas LiCl soluble not only in water but also in acetone?

Use molecular orbital theory to explain why the Be2 molecule does not exist.

Calculate the enthalpy change for the process

CCl₄(g) → C(g) + 4 Cl(g)

and calculate bond enthalpy of C – Cl in CCl₄(g).

Δ_vapH⁰(CCl₄) = 30.5 kJ mol^–1.

Δ_fH⁰ (CCl₄) = –135.5 kJ mol^–1.

Δ_aH⁰ (C) = 715.0 kJ mol^–1 , where Δ_aH⁰ is enthalpy of atomisation

Δ_aH⁰ (Cl₂) = 242 kJ mol^–1

At 450K, K_p= 2.0 × 10¹⁰/bar for the given reaction at equilibrium.

2SO₂(g) + O₂(g) ↔ 2SO₃ (g)

What is K_c at this temperature ?

:(i) Write the electronic configurations of the following ions: (a) H^– (b) Na⁺ (c) O^2–(d) F^–

(ii) What are the atomic numbers of elements whose outermost electrons are represented by (a) 3s¹ (b) 2p³ and (c) 3p⁵?

(iii) Which atoms are indicated by the following configurations?

(a) [He] 2s¹ (b) [Ne] 3s² 3p³ (c) [Ar] 4s² 3d¹.

How do you express the bond strength in terms of bond order?

Dihydrogen gas used in Haber’s process is produced by reacting methane from natural gas with high temperature steam. The first stage of two stage reaction involves the formation of CO and H₂. In second stage, CO formed in first stage is reacted with more steam in water gas shift reaction,

CO (g) + H₂O (g) ↔ CO₂ (g) + H₂ (g)

If a reaction vessel at 400°C is charged with an equimolar mixture of CO and steam such that P_CO  = P_H2O = 4.0  bar, what will be the partial pressure of H₂ at equilibrium? K_p= 10.1 at 400°C.

Explain why BeH₂ molecule has a zero dipole moment although the Be–H bonds are polar.

Nitric oxide reacts with Br₂ and gives nitrosyl bromide as per reaction given below:

2NO (g) + Br₂ (g) ↔ 2NOBr (g)

When 0.087 mol of NO and 0.0437 mol of Br₂ are mixed in a closed container at constant temperature, 0.0518 mol of NOBr is obtained at equilibrium. Calculate equilibrium amount of NO and Br₂ .