Among the second period elements the actual ionization enthalpies are in the order
Li < B < Be < C < O < N < F < Ne.
Explain why
(i) Be has higher ΔiH than B
(ii) O has lower ΔiH than N and F?
(i) Symmetry factor can be used for explaining higher ionization enthalpy of Be than B. The electronic configuration of Be is more symmetrical than that of B because both the occupied orbitals are filled in the case of Be while B has one half filled orbital in the 2p subshell. So during the process of ionization, the electron to be removed from beryllium atom is a 2s-electron, whereas the electron to be removed from boron atom is a 2p-electron. Now, 2s-electrons are more strongly attached to the nucleus than 2p-electrons and p orbital are also at slightly higher energy than the s orbital. Therefore, more energy is required to remove a 2s-electron of beryllium than that required to remove a 2p-electron of boron. Hence, beryllium has higher ΔiH than boron.
(ii) According to symmetry factor, nitrogen has all the three 2p orbitals half filled while oxygen has one filled and two half filled orbitals in 2p subshell. In nitrogen, the three 2p-electrons of nitrogen occupy three different atomic orbitals. However, in oxygen, two of the four 2p-electrons of oxygen occupy the same 2p-orbital. This results in increased electron-electron repulsion in oxygen atom. As a result, the energy required to remove the fourth 2p-electron from oxygen is less as compared to the energy required to remove one of the three 2p-electrons from nitrogen. Hence, oxygen has lower ΔiH than nitrogen.
Fluorine contains one electron and one proton more than oxygen. As the electron is being added to the same shell, the increase in nuclear attraction (due to the addition of a proton) is more than the increase in electronic repulsion (due to the addition of an electron). Therefore, the valence electrons in fluorine atom experience a more effective nuclear charge than that experienced by the electrons present in oxygen. As a result, more energy is required to remove an electron from fluorine atom than that required to remove an electron from oxygen atom. Hence, oxygen has lower ΔiH than fluorine.
Write the general outer electronic configuration of s-, p-, d- and f- block elements.
Considering the elements B, Al, Mg, and K, the correct order of their metallic character is:
(a) B > Al > Mg > K
(b) Al > Mg > B > K
(c) Mg > Al > K > B
(d) K > Mg > Al > B
What is the basic difference between the terms electron gain enthalpy and electronegativity?
What do you understand by isoelectronic species? Name a species that will be isoelectronic with each of the following atoms or ions.
(i) F–
(ii) Ar
(iii) Mg2+
(iv) Rb+
Considering the elements B, C, N, F, and Si, the correct order of their non-metallic character is:
(a) B > C > Si > N > F
b) Si > C > B > N > F
(c) F > N > C > B > Si
d) F > N > C > Si > B
Assign the position of the element having outer electronic configuration
(i) ns2 np4 for n = 3 (ii) (n - 1)d2 ns2 for n = 4, and (iii) (n - 2) f7 (n - 1)d1 ns2 for n = 6, in the periodic table.
How does atomic radius vary in a period and in a group? How do you explain the variation?
Use the periodic table to answer the following questions.
(a) Identify an element with five electrons in the outer subshell.
(b) Identify an element that would tend to lose two electrons.
(c) Identify an element that would tend to gain two electrons.
(d) Identify the group having metal, non-metal, liquid as well as gas at the room temperature.
Considering the elements F, Cl, O and N, the correct order of their chemical reactivity in terms of oxidizing property is:
(a) F > Cl > O > N
(b) F > O > Cl > N
(c) Cl > F > O > N
(d) O > F > N > Cl
On the basis of quantum numbers, justify that the sixth period of the periodic table should have 32 elements.
How do you account for the formation of ethane during chlorination of methane?
What are hybridisation states of each carbon atom in the following compounds ?
(i) CH2=C=O,
(ii) CH3CH=CH2,
(iii) (CH3)2CO,
(iv) CH2=CHCN,
(v) C6H6
What will be the minimum pressure required to compress 500 dm3 of air at 1 bar to 200 dm3 at 30°C?
What are the common physical and chemical features of alkali metals?
Calculate the molecular mass of the following:
(i) H2O
(ii) CO2
(iii) CH4
Assign oxidation number to the underlined elements in each of the following species:
(a) NaH2PO4
(b) NaHSO4
(c) H4P2O7
(d) K2MnO4
(e) CaO2
(f) NaBH4
(g) H2S2O7
(h) KAl(SO4)2.12 H2O
Explain the formation of a chemical bond.
Choose the correct answer. A thermodynamic state function is a quantity
(i) used to determine heat changes
(ii) whose value is independent of path
(iii) used to determine pressure volume work
(iv) whose value depends on temperature only.
A liquid is in equilibrium with its vapour in a sealed container at a fixed temperature. The volume of the container is suddenly increased.
a) What is the initial effect of the change on vapour pressure?
b) How do rates of evaporation and condensation change initially?
c) What happens when equilibrium is restored finally and what will be the final vapour pressure?
Justify the position of hydrogen in the periodic table on the basis of its electronic configuration.
The enthalpies of all elements in their standard states are:
(i) unity
(ii) zero
(iii) < 0
(iv) different for each element
A certain salt X, gives the following results.
(i) Its aqueous solution is alkaline to litmus.
(ii) It swells up to a glassy material Yon strong heating.
(iii) When conc. H2SO4 is added to a hot solution of X, white crystal of an acid Z separates out.
Write equations for all the above reactions and identify X, Y and Z.
Does the number of moles of reaction products increase, decrease or remain same when each of the following equilibria is subjected to a decrease in pressure by increasing the volume?
(a) PCl5 (g) ↔ PCl3 (g) + Cl2 (g)
(b) CaO (s) + CO2 (g) ↔ CaCO3 (s)
(c) 3Fe (s) + 4H2O (g) ↔ Fe3O4 (s) + 4H2 (g)
The equilibrium constant expression for a gas reaction is,
Write the balanced chemical equation corresponding to this expression.
Write the significance/applications of dipole moment.
Given the standard electrode potentials,
K+/K = -2.93V, Ag+/Ag = 0.80V,
Hg2+/ Hg = 0.79V
Mg2+/ Mg = -2.37V. Cr3+/ Cr = -0.74V
Arrange these metals in their increasing order of reducing power.
In Milikan’s experiment, static electric charge on the oil drops has been obtained by shining X-rays.
If the static electric charge on the oil drop is –1.282 × 10–18C, calculate the number of electrons present on it.
How much copper can be obtained from 100 g of copper sulphate (CuSO4)?
The electron energy in hydrogen atom is given by En = (–2.18 × 10–18)/n2 J. Calculate the energy required to remove an electron completely from the n = 2 orbit. What is the longest wavelength of light in cm that can be used to cause this transition?
A sample of pure PCl5 was introduced into an evacuated vessel at 473 K. After equilibrium was attained, concentration of PCl5 was found to be 0.5 × 10–1 mol L–1. If value of Kc is 8.3 × 10–3, what are the concentrations of PCl3 and Cl2 at equilibrium?
PCl5 (g) ↔ PCl3 (g) + Cl2(g)
Thank you for giving us Stasfied answer
I have question can anyone pls solve it: Why does BeCl2 exist but not BeH2?