Class 11 Chemistry - Chapter States of Matter NCERT Solutions | Explain the physical significance of Van

What will be the minimum pressure required to compress 500 dm³ of air at 1 bar to 200 dm³ at 30°C?

At 0°C, the density of a certain oxide of a gas at 2 bar is same as that of dinitrogen at 5 bar. What is the molecular mass of the oxide?

Density of a gas is found to be 5.46 g/dm³ at 27 °C at 2 bar pressure. What will be its density at STP?

Calculate the temperature of 4.0 mol of a gas occupying 5 dm³ at 3.32 bar.

(R = 0.083 bar dm³ K^–1 mol^–1).

A vessel of 120 mL capacity contains a certain amount of gas at 35 °C and 1.2 bar pressure. The gas is transferred to another vessel of volume 180 mL at 35 °C. What would be its pressure?

Calculate the total pressure in a mixture of 8 g of dioxygen and 4 g of dihydrogen confined in a vessel of 1 dm³ at 27°C. R = 0.083 bar dm³ K^–1 mol^–1.

Calculate the volume occupied by 8.8 g of CO₂ at 31.1°C and 1 bar pressure.

R = 0.083 bar L K^–1 mol^–1.

34.05 mL of phosphorus vapour weighs 0.0625 g at 546 °C and 0.1 bar pressure. What is the molar mass of phosphorus?

2.9 g of a gas at 95 °C occupied the same volume as 0.184 g of dihydrogen at 17 °C, at the same pressure. What is the molar mass of the gas?

What would be the SI unit for the quantity pV²T ²/n?

How do you account for the formation of ethane during chlorination of methane?

What are hybridisation states of each carbon atom in the following compounds ?

(i) CH₂=C=O,

(ii) CH₃CH=CH₂,

(iii) (CH₃)₂CO,

(iv) CH₂=CHCN,

(v) C₆H₆

What are the common physical and chemical features of alkali metals?

Calculate the molecular mass of the following:
(i) H₂O
(ii) CO₂
(iii) CH₄

Assign oxidation number to the underlined elements in each of the following species:

(a) NaH₂PO₄

(b) NaHSO₄

(c) H₄P₂O₇

(d) K₂MnO₄

(e) CaO₂

(f) NaBH₄

(g) H₂S₂O₇

(h) KAl(SO₄)₂.12 H₂O

What is the basic theme of organisation in the periodic table?

Explain the formation of a chemical bond.

Choose the correct answer. A thermodynamic state function is a quantity
(i) used to determine heat changes
(ii) whose value is independent of path
(iii) used to determine pressure volume work
(iv) whose value depends on temperature only.

A liquid is in equilibrium with its vapour in a sealed container at a fixed temperature. The volume of the container is suddenly increased.
a) What is the initial effect of the change on vapour pressure?
b) How do rates of evaporation and condensation change initially?
c) What happens when equilibrium is restored finally and what will be the final vapour pressure?

Justify the position of hydrogen in the periodic table on the basis of its electronic configuration.

What are the common physical and chemical features of alkali metals?

Distinguish between a sigma and a pi bond.

The first ionization constant of H₂S is 9.1 × 10^–8. Calculate the concentration of HS^– ion in its 0.1M solution. How will this concentration be affected if the solution is 0.1M in HCl also ? If the second dissociation constant of H₂S is 1.2 × 10^–13, calculate the concentration of S^2– under both conditions.

The enthalpy of combustion of methane, graphite and dihydrogen at 298 K are, –890.3 kJ mol^–1  , –393.5 kJ mol^–1, and –285.8 kJ mol^–1 respectively. Enthalpy of formation of CH₄(g) will be

(i) –74.8 kJ mol^–1

(ii) –52.27 kJ mol^–1

(iii) +74.8 kJ mol^–1

(iv) +52.26 kJ mol^–1

A certain salt X, gives the following results.

(i) Its aqueous solution is alkaline to litmus.

(ii) It swells up to a glassy material Yon strong heating.

(iii) When conc. H₂SO₄ is added to a hot solution of X, white crystal of an acid Z separates out.

Write equations for all the above reactions and identify X, Y and Z.

Arrange the following metals in the order in which they displace each other from the solution of their salts.

Al, Cu, Fe, Mg and Zn.

Given

N₂(g) + 3H₂(g) → 2NH₃(g) ; Δ_rH⁰ = –92.4 kJ mol^–1

What is the standard enthalpy of formation of NH₃ gas?

What do you understand by the terms:

(i) hydrogen economy

(ii) hydrogenation

(iii) 'syngas'

(iv) water-gas shift reaction

(v) fuel-cell ?

Describe the hybridisation in case of PCl₅. Why are the axial bonds longer as compared to equatorial bonds?

Beryllium and magnesium do not give colour to flame whereas other alkaline earth metals do so. Why?