Class 11 Chemistry - Chapter The s Block Elements NCERT Solutions | Comment on each of the following observa

Compare the alkali metals and alkaline earth metals with respect to

(i) ionization enthalpy

(ii) basicity of oxides and

(iii) solubility of hydroxides.

Compare the solubility and thermal stability of the following compounds of the alkali metals with those of the alkaline earth metals.

(a) Nitrates (b) Carbonates (c) Sulphates.

Discuss the various reactions that occur in the Solvay process.

Why are lithium salts commonly hydrated and those of the other alkali metal ions usually anhydrous?

State as to why

(a) a solution of Na₂CO₃ is alkaline ?

(b) alkali metals are prepared by electrolysis of their fused chlorides ?

(c) sodium is found to be more useful than potassium ?

When an alkali metal dissolves in liquid ammonia the solution can acquire different colours. Explain the reasons for this type of colour change.

In what ways lithium shows similarities to magnesium in its chemical behaviour?

Why is Li₂CO₃ decomposed at a lower temperature whereas Na₂CO₃ at higher temperature?

Find the oxidation state of sodium in Na₂O₂.

Explain why is sodium less reactive than potassium?

How do you account for the formation of ethane during chlorination of methane?

What are hybridisation states of each carbon atom in the following compounds ?

(i) CH₂=C=O,

(ii) CH₃CH=CH₂,

(iii) (CH₃)₂CO,

(iv) CH₂=CHCN,

(v) C₆H₆

What will be the minimum pressure required to compress 500 dm³ of air at 1 bar to 200 dm³ at 30°C?

Calculate the molecular mass of the following:
(i) H₂O
(ii) CO₂
(iii) CH₄

Assign oxidation number to the underlined elements in each of the following species:

(a) NaH₂PO₄

(b) NaHSO₄

(c) H₄P₂O₇

(d) K₂MnO₄

(e) CaO₂

(f) NaBH₄

(g) H₂S₂O₇

(h) KAl(SO₄)₂.12 H₂O

What is the basic theme of organisation in the periodic table?

Explain the formation of a chemical bond.

Choose the correct answer. A thermodynamic state function is a quantity
(i) used to determine heat changes
(ii) whose value is independent of path
(iii) used to determine pressure volume work
(iv) whose value depends on temperature only.

A liquid is in equilibrium with its vapour in a sealed container at a fixed temperature. The volume of the container is suddenly increased.
a) What is the initial effect of the change on vapour pressure?
b) How do rates of evaporation and condensation change initially?
c) What happens when equilibrium is restored finally and what will be the final vapour pressure?

Justify the position of hydrogen in the periodic table on the basis of its electronic configuration.

Calculate the mass percent of different elements present in sodium sulphate (Na₂SO₄).

At 700 K, equilibrium constant for the reaction:

H2 (g) + I2 (g) ↔ 2HI (g)

is 54.8. If 0.5 mol L^–1 of HI(g) is present at equilibrium at 700 K, what are the concentration of H₂(g) and I₂(g) assuming that we initially started with HI(g) and allowed it to reach equilibrium at 700K?

A welding fuel gas contains carbon and hydrogen only. Burning a small sample of it in oxygen gives 3.38 g carbon dioxide, 0.690 g of water and no other products. A volume of 10.0 L (measured at STP) of this welding gas is found to weigh 11.6 g. Calculate

(i) empirical formula,

(ii) molar mass of the gas, and

(iii) molecular formula.

Which one of the following statements is incorrect in relation to ionization enthalpy?
(a) Ionization enthalpy increases for each successive electron.
(b) The greatest increase in ionization enthalpy is experienced on removal of electron from core noble gas configuration.
(c) End of valence electrons is marked by a big jump in ionization enthalpy.
(d) Removal of electron from orbitals bearing lower n value is easier than from orbital having higher n value.

Write the names of isotopes of hydrogen. What is the mass ratio of these isotopes?

Indicate the σ and π bonds in the following molecules :

(i) C₆H₆,

(ii) C₆H₁₂,

(iii) CH₂Cl₂,

(iv) CH₂=C=CH₂,

(v) CH₃NO₂,

(vi) HCONHCH₃

Consider the elements:

Cs, Ne, I and F

(a) Identify the element that exhibits only negative oxidation state.

(b) Identify the element that exhibits only postive oxidation state.

(c) Identify the element that exhibits both positive and negative oxidation states.

(d) Identify the element which exhibits neither the negative nor does the positive oxidation state.

If the density of methanol is 0.793 kg L^–1, what is its volume needed for making 2.5 L of its 0.25 M solution?

Arrange the bonds in order of increasing ionic character in the molecules: LiF, K₂O, N₂, SO₂ and ClF₃.

Give condensed and bond line structural formulas and identify the functional group(s) present, if any, for :

(a) 2,2,4-Trimethylpentane

(b) 2-Hydroxy-1,2,3-propanetricarboxylic acid

(c) Hexanedial