Class 11 Chemistry - Chapter The s Block Elements NCERT Solutions | Discuss the various reactions that occur

Compare the alkali metals and alkaline earth metals with respect to

(i) ionization enthalpy

(ii) basicity of oxides and

(iii) solubility of hydroxides.

Compare the solubility and thermal stability of the following compounds of the alkali metals with those of the alkaline earth metals.

(a) Nitrates (b) Carbonates (c) Sulphates.

Comment on each of the following observations:

(a) The mobilities of the alkali metal ions in aqueous solution are Li⁺ <  Na⁺ <  K⁺ <  Rb⁺ < Cs⁺

(b) Lithium is the only alkali metal to form a nitride directly.

(c) E° for M²⁺(aq) (where M = Ca, Sr or Ba) is nearly constant.

Why are lithium salts commonly hydrated and those of the other alkali metal ions usually anhydrous?

State as to why

(a) a solution of Na₂CO₃ is alkaline ?

(b) alkali metals are prepared by electrolysis of their fused chlorides ?

(c) sodium is found to be more useful than potassium ?

When an alkali metal dissolves in liquid ammonia the solution can acquire different colours. Explain the reasons for this type of colour change.

Why is Li₂CO₃ decomposed at a lower temperature whereas Na₂CO₃ at higher temperature?

In what ways lithium shows similarities to magnesium in its chemical behaviour?

Find the oxidation state of sodium in Na₂O₂.

Explain why is sodium less reactive than potassium?

How do you account for the formation of ethane during chlorination of methane?

What are hybridisation states of each carbon atom in the following compounds ?

(i) CH₂=C=O,

(ii) CH₃CH=CH₂,

(iii) (CH₃)₂CO,

(iv) CH₂=CHCN,

(v) C₆H₆

What will be the minimum pressure required to compress 500 dm³ of air at 1 bar to 200 dm³ at 30°C?

Calculate the molecular mass of the following:
(i) H₂O
(ii) CO₂
(iii) CH₄

Assign oxidation number to the underlined elements in each of the following species:

(a) NaH₂PO₄

(b) NaHSO₄

(c) H₄P₂O₇

(d) K₂MnO₄

(e) CaO₂

(f) NaBH₄

(g) H₂S₂O₇

(h) KAl(SO₄)₂.12 H₂O

What is the basic theme of organisation in the periodic table?

Explain the formation of a chemical bond.

Choose the correct answer. A thermodynamic state function is a quantity
(i) used to determine heat changes
(ii) whose value is independent of path
(iii) used to determine pressure volume work
(iv) whose value depends on temperature only.

A liquid is in equilibrium with its vapour in a sealed container at a fixed temperature. The volume of the container is suddenly increased.
a) What is the initial effect of the change on vapour pressure?
b) How do rates of evaporation and condensation change initially?
c) What happens when equilibrium is restored finally and what will be the final vapour pressure?

Justify the position of hydrogen in the periodic table on the basis of its electronic configuration.

Consider the reactions :

2 S₂O^2– _{3 (aq)} + I_2(s) → S₄ O^2– _6(aq) + 2I ^– _(aq)

S₂O^2– _3(aq) + 2Br_2(l) + 5 H₂O_(l) → 2SO^2–_4(aq) + 4Br^–_(aq) + 10H⁺_(aq)

Why does the same reductant, thiosulphate react differently with iodine and bromine ?

Refer to the periodic table given in your book and now answer the following questions:

(a) Select the possible non metals that can show disproportionation reaction.

(b) Select three metals that can show disproportionation reaction.

Consider the following species:

N^3–, O^2–, F^–, Na⁺, Mg²⁺ and Al³⁺

(a) What is common in them?

(b) Arrange them in the order of increasing ionic radii.

What is the basic theme of organisation in the periodic table?

Pressure is determined as force per unit area of the surface. The SI unit of pressure, Pascal is as shown below:

1Pa = 1N m^–2

If mass of air at sea level is 1034 g cm^–2, calculate the pressure in Pascal.

Write the important conditions required for the linear combination of atomic orbitals to form molecular orbitals.

Write chemical reactions to show the amphoteric nature of water.

What are the major differences between metals and non-metals?

Describe the effect of :

a) addition of H₂

b) addition of CH₃OH

c) removal of CO

d) removal of CH₃OH on the equilibrium of the reaction: 2H₂(g) + CO (g) ↔ CH₃OH (g)

The first (ΔiH1) and the second (ΔiH) ionization enthalpies (in kJ mol–1) and the (ΔegH) electron gain enthalpy (in kJ mol–1) of a few elements are given below:

Which of the above elements is likely to be :

(a) the least reactive element.

(b) the most reactive metal.

(c) the most reactive non-metal.

(d) the least reactive non-metal.

(e) the metal which can form a stable binary halide of the formula MX₂, (X=halogen).

(f) the metal which can form a predominantly stable covalent halide of the formula MX (X=halogen)?