Class 11 Chemistry - Chapter Equilibrium NCERT Solutions | Write the expression for the equilibrium

Assuming complete dissociation, calculate the pH of the following solutions:

(a) 0.003 M HCl

(b) 0.005 M NaOH

(c) 0.002 M HBr

(d) 0.002 M KOH

A liquid is in equilibrium with its vapour in a sealed container at a fixed temperature. The volume of the container is suddenly increased.
a) What is the initial effect of the change on vapour pressure?
b) How do rates of evaporation and condensation change initially?
c) What happens when equilibrium is restored finally and what will be the final vapour pressure?

The pH of a sample of vinegar is 3.76. Calculate the concentration of hydrogen ion in it.

The ionization constant of acetic acid is 1.74 x 10^-5. Calculate the degree of dissociation of acetic acid in its 0.05 M solution. Calculate the concentration of acetate ion in the solution and its pH.

Dihydrogen gas is obtained from natural gas by partial oxidation with steam as per following endothermic reaction:

CH₄ (g) + H₂O (g) ↔ CO (g) + 3H₂ (g)

(a) Write as expression for Kp for the above reaction.

(b) How will the values of Kp and composition of equilibrium mixture be affected by

  (i) increasing the pressure

  (ii) increasing the temperature

  (iii) using a catalyst ?

At 700 K, equilibrium constant for the reaction:

H2 (g) + I2 (g) ↔ 2HI (g)

is 54.8. If 0.5 mol L^–1 of HI(g) is present at equilibrium at 700 K, what are the concentration of H₂(g) and I₂(g) assuming that we initially started with HI(g) and allowed it to reach equilibrium at 700K?

At 473 K, equilibrium constant K_c for decomposition of phosphorus pentachloride, PCl₅ is 8.3 ×10^-3. If decomposition is depicted as,

PCl₅ (g) ↔  PCl₃ (g) + Cl₂ (g)          Δ_rH⁰ = 124.0 kJ mol^–1

(a) write an expression for Kc for the reaction.

(b) what is the value of Kc for the reverse reaction at the same temperature ?

(c) what would be the effect on K_c if (i) more PCl5 is added (ii) pressure is increased (iii) the temperature is increased ?

Find out the value of K_c for each of the following equilibria from the value of K_p:

(i) 2NOCl (g)  ↔  2NO (g) + Cl₂ (g);                   Kp  =  1.8 × 10^–2 at 500 K

(ii) CaCO₃ (s)  ↔  CaO(s) + CO₂(g);                  Kp  = 167 at 1073 K

Ionic product of water at 310 K is 2.7 x 10^-14. What is the pH of neutral water at this temperature?

Reaction between N₂ and O_2– takes place as follows:

2N₂ (g)  +  O₂ (g) ↔  2N₂O (g)

If a mixture of 0.482 mol N₂ and 0.933 mol of O₂ is placed in a 10 L reaction vessel and allowed to form N₂O at a temperature for which K_c = 2.0 × 10^–37, determine the composition of equilibrium mixture.

How do you account for the formation of ethane during chlorination of methane?

What are hybridisation states of each carbon atom in the following compounds ?

(i) CH₂=C=O,

(ii) CH₃CH=CH₂,

(iii) (CH₃)₂CO,

(iv) CH₂=CHCN,

(v) C₆H₆

What will be the minimum pressure required to compress 500 dm³ of air at 1 bar to 200 dm³ at 30°C?

What are the common physical and chemical features of alkali metals?

Calculate the molecular mass of the following:
(i) H₂O
(ii) CO₂
(iii) CH₄

Assign oxidation number to the underlined elements in each of the following species:

(a) NaH₂PO₄

(b) NaHSO₄

(c) H₄P₂O₇

(d) K₂MnO₄

(e) CaO₂

(f) NaBH₄

(g) H₂S₂O₇

(h) KAl(SO₄)₂.12 H₂O

What is the basic theme of organisation in the periodic table?

Explain the formation of a chemical bond.

Choose the correct answer. A thermodynamic state function is a quantity
(i) used to determine heat changes
(ii) whose value is independent of path
(iii) used to determine pressure volume work
(iv) whose value depends on temperature only.

Justify the position of hydrogen in the periodic table on the basis of its electronic configuration.

Write reactions to justify amphoteric nature of aluminium.

Give reasons:

(i) Conc. HNO₃ can be transported in aluminium container.

(ii) A mixture of dilute NaOH and aluminium pieces is used to open drain.

(iii) Graphite is used as lubricant.

(iv) Diamond is used as an abrasive.

(v) Aluminium alloys are used to make aircraft body.

(vi) Aluminium utensils should not be kept in water overnight.

(vii) Aluminium wire is used to make transmission cables.

A certain salt X, gives the following results.

(i) Its aqueous solution is alkaline to litmus.

(ii) It swells up to a glassy material Yon strong heating.

(iii) When conc. H₂SO₄ is added to a hot solution of X, white crystal of an acid Z separates out.

Write equations for all the above reactions and identify X, Y and Z.

How do you account for the formation of ethane during chlorination of methane?

Explain the terms Inductive and Electromeric effects. Which electron displacement effect explains the following correct orders of acidity of the carboxylic acids?

(a) Cl₃CCOOH > Cl₂CHCOOH > ClCH₂COOH

(b) CH₃CH₂COOH > (CH₃)₂CHCOOH > (CH₃)₃C.COOH

Rationalise the given statements and give chemical reactions :

(i) Lead(II) chloride reacts with Cl₂ to give PbCl₄.

(ii) Lead(IV) chloride is highly unstable towards heat.

(iii) Lead is known not to form an iodide, PbI₄.

Write balanced equations for:

(i) BF₃ + LiH →

(ii) B₂H₆ + H₂O →

(iii) NaH + B₂H₆ →

(iv) H₃BO₃ 

(v) Al + NaOH →

(vi) B₂H₆ + NH₃ →

An ion with mass number 37 possesses one unit of negative charge. If the ion contains 11.1% more neutrons than the electrons, find the symbol of the ion.

The following data are obtained when dinitrogen and dioxygen react together to form different compounds:

Mass of dinitrogen         Mass of dioxygen

(i) 14 g                                  16 g

(ii) 14 g                                 32 g

(iii) 28 g                                 32 g

(iv) 28 g                                 80 g

(a) Which law of chemical combination is obeyed by the above experimental data?Give its statement.

(b) Fill in the blanks in the following conversions:

(i) 1 km = ...................... mm = ...................... pm

(ii) 1 mg = ...................... kg = ...................... ng

(iii) 1 mL = ...................... L = ...................... dm3

What is the basic difference between the terms electron gain enthalpy and electronegativity?