Class 11 Chemistry - Chapter Hydrogen NCERT Solutions | Describe the usefulness of water in bios

Justify the position of hydrogen in the periodic table on the basis of its electronic configuration.

Compare the structures of H₂O and H₂O₂.

Write chemical reactions to show the amphoteric nature of water.

Arrange the following

(i) CaH₂, BeH₂ and TiH₂ in order of increasing electrical conductance.

(ii) LiH, NaH and CsH in order of increasing ionic character.

(iii) H-H, D-D and F-F in order of increasing bond dissociation enthalpy.

(iv) NaH, MgH₂ and H₂O in order of increasing reducing property.

Discuss the principle and method of softening of hard water by synthetic ion-exchange resins.

What do you understand by the term “non-stoichiometric hydrides”? Do you expect this type of the hydrides to be formed by alkali metals? Justify your answer.

What is meant by 'demineralised' water and how can it be obtained?

What causes the temporary and permanent hardness of water?

How does H₂O₂ behave as a bleaching agent?

Why does hydrogen occur in a diatomic form rather than in a monoatomic form under normal conditions?

How do you account for the formation of ethane during chlorination of methane?

What are hybridisation states of each carbon atom in the following compounds ?

(i) CH₂=C=O,

(ii) CH₃CH=CH₂,

(iii) (CH₃)₂CO,

(iv) CH₂=CHCN,

(v) C₆H₆

What will be the minimum pressure required to compress 500 dm³ of air at 1 bar to 200 dm³ at 30°C?

What are the common physical and chemical features of alkali metals?

Calculate the molecular mass of the following:
(i) H₂O
(ii) CO₂
(iii) CH₄

Assign oxidation number to the underlined elements in each of the following species:

(a) NaH₂PO₄

(b) NaHSO₄

(c) H₄P₂O₇

(d) K₂MnO₄

(e) CaO₂

(f) NaBH₄

(g) H₂S₂O₇

(h) KAl(SO₄)₂.12 H₂O

What is the basic theme of organisation in the periodic table?

Explain the formation of a chemical bond.

Choose the correct answer. A thermodynamic state function is a quantity
(i) used to determine heat changes
(ii) whose value is independent of path
(iii) used to determine pressure volume work
(iv) whose value depends on temperature only.

A liquid is in equilibrium with its vapour in a sealed container at a fixed temperature. The volume of the container is suddenly increased.
a) What is the initial effect of the change on vapour pressure?
b) How do rates of evaporation and condensation change initially?
c) What happens when equilibrium is restored finally and what will be the final vapour pressure?

The following data are obtained when dinitrogen and dioxygen react together to form different compounds:

Mass of dinitrogen         Mass of dioxygen

(i) 14 g                                  16 g

(ii) 14 g                                 32 g

(iii) 28 g                                 32 g

(iv) 28 g                                 80 g

(a) Which law of chemical combination is obeyed by the above experimental data?Give its statement.

(b) Fill in the blanks in the following conversions:

(i) 1 km = ...................... mm = ...................... pm

(ii) 1 mg = ...................... kg = ...................... ng

(iii) 1 mL = ...................... L = ...................... dm3

One of the reaction that takes place in producing steel from iron ore is the reduction of iron(II) oxide by carbon monoxide to give iron metal and CO₂.

FeO (s) + CO (g) ↔ Fe (s) + CO₂ (g);   Kp = 0.265 atm at 1050K

What are the equilibrium partial pressures of CO and CO₂ at 1050 K if the initial partial pressures are: p_CO= 1.4 atm and P_co2 = 0.80 atm

In Ostwald's process for the manufacture of nitric acid, the first step involves the oxidation of ammonia gas by oxygen gas to give nitric oxide gas and steam. What is the maximum weight of nitric oxide that can be obtained starting only with 10.00 g. of ammonia and 20.00 g of oxygen?

A sample of drinking water was found to be severely contaminated with chloroform, CHCl₃, supposed to be carcinogenic in nature. The level of contamination was 15 ppm (by mass).

(i) Express this in percent by mass.

(ii) Determine the molality of chloroform in the water sample.

A liquid is in equilibrium with its vapour in a sealed container at a fixed temperature. The volume of the container is suddenly increased.
a) What is the initial effect of the change on vapour pressure?
b) How do rates of evaporation and condensation change initially?
c) What happens when equilibrium is restored finally and what will be the final vapour pressure?

What is meant by the conjugate acid-base pair? Find the conjugate acid/base for the following species:

HNO₂,  CN^– ,  HClO₄,  F ^–,  OH^–,  CO^2–₃  and  S^-

Write down the reactions involved during the formation of photochemical smog.

Calculate the standard enthalpy of formation of CH₃OH(l) from the following data:

CH₃OH (l) + 3/2 O₂(g) → CO₂(g) + 2H₂O(l) ;   Δ_rH⁰  = –726 kJ mol^–1

C(g) + O₂(g) → CO₂(g) ;    Δ_cH⁰ = –393 kJ mol^–1

H₂(g) + 1/2 O₂(g) → H₂O(l) ;    Δ_fH⁰ = –286 kJ mol^–1.

Which one of the following statements is incorrect in relation to ionization enthalpy?
(a) Ionization enthalpy increases for each successive electron.
(b) The greatest increase in ionization enthalpy is experienced on removal of electron from core noble gas configuration.
(c) End of valence electrons is marked by a big jump in ionization enthalpy.
(d) Removal of electron from orbitals bearing lower n value is easier than from orbital having higher n value.

Calculate the enthalpy change for the process

CCl₄(g) → C(g) + 4 Cl(g)

and calculate bond enthalpy of C – Cl in CCl₄(g).

Δ_vapH⁰(CCl₄) = 30.5 kJ mol^–1.

Δ_fH⁰ (CCl₄) = –135.5 kJ mol^–1.

Δ_aH⁰ (C) = 715.0 kJ mol^–1 , where Δ_aH⁰ is enthalpy of atomisation

Δ_aH⁰ (Cl₂) = 242 kJ mol^–1