Class 11 Chemistry - Chapter Some Basic Concepts of Chemistry NCERT Solutions | In a reaction A + B2 → AB2 Identify

Calculate the amount of carbon dioxide that could be produced when

(i) 1 mole of carbon is burnt in air.

(ii) 1 mole of carbon is burnt in 16 g of dioxygen.

(iii) 2 moles of carbon are burnt in 16 g of dioxygen.

Which one of the following will have largest number of atoms?

(i) 1 g Au (s)

(ii) 1 g Na (s)

(iii) 1 g Li (s)

(iv) 1 g of Cl2(g)

Chlorine is prepared in the laboratory by treating manganese dioxide (MnO₂) with aqueous hydrochloric acid according to the reaction

4HCl_(aq) + MnO_2(s) → 2H₂O_(l) + MnCl_2(aq) + Cl_2(g)

How many grams of HCl react with 5.0 g of manganese dioxide?

Determine the empirical formula of an oxide of iron which has 69.9% iron and 30.1% dioxygen by mass.

A sample of drinking water was found to be severely contaminated with chloroform, CHCl₃, supposed to be carcinogenic in nature. The level of contamination was 15 ppm (by mass).

(i) Express this in percent by mass.

(ii) Determine the molality of chloroform in the water sample.

Calcium carbonate reacts with aqueous HCl to give CaCl₂ and CO₂ according to the reaction,

CaCO_3(s) + 2 HCl_(aq) → CaCl_2(aq) + CO_2(g) + H₂O_(l)

What mass of CaCO₃ is required to react completely with 25 mL of 0.75 M HCl?

Calculate the mass of sodium acetate (CH₃COONa) required to make 500 mL of 0.375 molar aqueous solution. Molar mass of sodium acetate is 82.0245 g mol^–1

A welding fuel gas contains carbon and hydrogen only. Burning a small sample of it in oxygen gives 3.38 g carbon dioxide, 0.690 g of water and no other products. A volume of 10.0 L (measured at STP) of this welding gas is found to weigh 11.6 g. Calculate

(i) empirical formula,

(ii) molar mass of the gas, and

(iii) molecular formula.

How many significant figures are present in the following?
(i) 0.0025
(ii) 208
(iii) 5005
(iv) 126,000
(v) 500.0
(vi) 2.0034

Dinitrogen and dihydrogen react with each other to produce ammonia according to the following chemical equation:

N2(g) + H2(g) → 2NH3(g)

(i) Calculate the mass of ammonia produced if 2.00 × 103 g dinitrogen reacts with 1.00 × 103 g of dihydrogen.

(ii) Will any of the two reactants remain unreacted?

(iii) If yes, which one and what would be its mass?

How do you account for the formation of ethane during chlorination of methane?

What are hybridisation states of each carbon atom in the following compounds ?

(i) CH₂=C=O,

(ii) CH₃CH=CH₂,

(iii) (CH₃)₂CO,

(iv) CH₂=CHCN,

(v) C₆H₆

What will be the minimum pressure required to compress 500 dm³ of air at 1 bar to 200 dm³ at 30°C?

What are the common physical and chemical features of alkali metals?

Assign oxidation number to the underlined elements in each of the following species:

(a) NaH₂PO₄

(b) NaHSO₄

(c) H₄P₂O₇

(d) K₂MnO₄

(e) CaO₂

(f) NaBH₄

(g) H₂S₂O₇

(h) KAl(SO₄)₂.12 H₂O

What is the basic theme of organisation in the periodic table?

Explain the formation of a chemical bond.

Choose the correct answer. A thermodynamic state function is a quantity
(i) used to determine heat changes
(ii) whose value is independent of path
(iii) used to determine pressure volume work
(iv) whose value depends on temperature only.

A liquid is in equilibrium with its vapour in a sealed container at a fixed temperature. The volume of the container is suddenly increased.
a) What is the initial effect of the change on vapour pressure?
b) How do rates of evaporation and condensation change initially?
c) What happens when equilibrium is restored finally and what will be the final vapour pressure?

Justify the position of hydrogen in the periodic table on the basis of its electronic configuration.

If the photon of the wavelength 150 pm strikes an atom and one of its inner bound electrons is ejected out with a velocity of 1.5 × 10⁷ ms^–1, calculate the energy with which it is bound to the nucleus.

The degree of ionization of a 0.1M bromoacetic acid solution is 0.132. Calculate the pH of the solution and the pK_a of bromoacetic acid.

The ejection of the photoelectron from the silver metal in the photoelectric effect experiment can be stopped by applying the voltage of 0.35 V when the radiation 256.7 nm is used. Calculate the work function for silver metal.

Calculate the pH of the following solutions:

(a) 2 g of TlOH dissolved in water to give 2 litre of solution.

(b) 0.3 g of Ca(OH)₂ dissolved in water to give 500 mL of solution.

(c) 0.3 g of NaOH dissolved in water to give 200 mL of solution.

(d) 1mL of 13.6 M HCl is diluted with water to give 1 litre of solution.

Following results are observed when sodium metal is irradiated with different wavelengths.

Calculate (a) threshold wavelength and, (b) Planck’s constant.

The work function for caesium atom is 1.9 eV. Calculate

(a) the threshold wavelength and

(b) the threshold frequency of the radiation. If the caesium element is irradiated with a wavelength 500 nm, calculate the kinetic energy and the velocity of the ejected photoelectron.

It has been found that the pH of a 0.01M solution of an organic acid is 4.15. Calculate the concentration of the anion, the ionization constant of the acid and its pK_a.

The longest wavelength doublet absorption transition is observed at 589 and 589.6 nm. Calculate the frequency of each transition and energy difference between two excited states.

The first ionization constant of H₂S is 9.1 × 10^–8. Calculate the concentration of HS^– ion in its 0.1M solution. How will this concentration be affected if the solution is 0.1M in HCl also ? If the second dissociation constant of H₂S is 1.2 × 10^–13, calculate the concentration of S^2– under both conditions.

Lifetimes of the molecules in the excited states are often measured by using pulsed radiation source of duration nearly in the nano second range. If the radiation source has the duration of 2 ns and the number of photons emitted during the pulse source is 2.5 × 10¹⁵, calculate the energy of the source.