Class 11 Chemistry - Chapter Some Basic Concepts of Chemistry NCERT Solutions | Round up the following upto three signif

Calculate the amount of carbon dioxide that could be produced when

(i) 1 mole of carbon is burnt in air.

(ii) 1 mole of carbon is burnt in 16 g of dioxygen.

(iii) 2 moles of carbon are burnt in 16 g of dioxygen.

In a reaction A + B2 → AB2 Identify the limiting reagent, if any, in the following reaction mixtures.

(i) 300 atoms of A + 200 molecules of B

(ii) 2 mol A + 3 mol B

(iii) 100 atoms of A + 100 molecules of B

(iv) 5 mol A + 2.5 mol B

(v) 2.5 mol A + 5 mol B

Which one of the following will have largest number of atoms?

(i) 1 g Au (s)

(ii) 1 g Na (s)

(iii) 1 g Li (s)

(iv) 1 g of Cl2(g)

Chlorine is prepared in the laboratory by treating manganese dioxide (MnO₂) with aqueous hydrochloric acid according to the reaction

4HCl_(aq) + MnO_2(s) → 2H₂O_(l) + MnCl_2(aq) + Cl_2(g)

How many grams of HCl react with 5.0 g of manganese dioxide?

Determine the empirical formula of an oxide of iron which has 69.9% iron and 30.1% dioxygen by mass.

A sample of drinking water was found to be severely contaminated with chloroform, CHCl₃, supposed to be carcinogenic in nature. The level of contamination was 15 ppm (by mass).

(i) Express this in percent by mass.

(ii) Determine the molality of chloroform in the water sample.

Calcium carbonate reacts with aqueous HCl to give CaCl₂ and CO₂ according to the reaction,

CaCO_3(s) + 2 HCl_(aq) → CaCl_2(aq) + CO_2(g) + H₂O_(l)

What mass of CaCO₃ is required to react completely with 25 mL of 0.75 M HCl?

Calculate the mass of sodium acetate (CH₃COONa) required to make 500 mL of 0.375 molar aqueous solution. Molar mass of sodium acetate is 82.0245 g mol^–1

A welding fuel gas contains carbon and hydrogen only. Burning a small sample of it in oxygen gives 3.38 g carbon dioxide, 0.690 g of water and no other products. A volume of 10.0 L (measured at STP) of this welding gas is found to weigh 11.6 g. Calculate

(i) empirical formula,

(ii) molar mass of the gas, and

(iii) molecular formula.

How many significant figures are present in the following?
(i) 0.0025
(ii) 208
(iii) 5005
(iv) 126,000
(v) 500.0
(vi) 2.0034

How do you account for the formation of ethane during chlorination of methane?

What are hybridisation states of each carbon atom in the following compounds ?

(i) CH₂=C=O,

(ii) CH₃CH=CH₂,

(iii) (CH₃)₂CO,

(iv) CH₂=CHCN,

(v) C₆H₆

What will be the minimum pressure required to compress 500 dm³ of air at 1 bar to 200 dm³ at 30°C?

What are the common physical and chemical features of alkali metals?

Assign oxidation number to the underlined elements in each of the following species:

(a) NaH₂PO₄

(b) NaHSO₄

(c) H₄P₂O₇

(d) K₂MnO₄

(e) CaO₂

(f) NaBH₄

(g) H₂S₂O₇

(h) KAl(SO₄)₂.12 H₂O

What is the basic theme of organisation in the periodic table?

Explain the formation of a chemical bond.

Choose the correct answer. A thermodynamic state function is a quantity
(i) used to determine heat changes
(ii) whose value is independent of path
(iii) used to determine pressure volume work
(iv) whose value depends on temperature only.

A liquid is in equilibrium with its vapour in a sealed container at a fixed temperature. The volume of the container is suddenly increased.
a) What is the initial effect of the change on vapour pressure?
b) How do rates of evaporation and condensation change initially?
c) What happens when equilibrium is restored finally and what will be the final vapour pressure?

Justify the position of hydrogen in the periodic table on the basis of its electronic configuration.

What is the significance of the terms - ‘isolated gaseous atom’ and ‘ground state’ while defining the ionization enthalpy and electron gain enthalpy? Hint: Requirements for comparison purposes.

What properties of water make it useful as a solvent? What types of compound can it (i) dissolve, and (ii) hydrolyse?

Find energy of each of the photons which

(i) correspond to light of frequency 3× 1015 Hz.

(ii) have wavelength of 0.50 Å.

The pH of 0.005M codeine (C₁₈H₂₁NO₃) solution is 9.95. Calculate its ionization constant and pKb.

Enthalpy of combustion of carbon to CO₂ is -393.5 kJ mol^-1. Calculate the heat released upon formation of 35.2 g of CO₂ from carbon and dioxygen gas.

The first (ΔiH1) and the second (ΔiH) ionization enthalpies (in kJ mol–1) and the (ΔegH) electron gain enthalpy (in kJ mol–1) of a few elements are given below:

Which of the above elements is likely to be :

(a) the least reactive element.

(b) the most reactive metal.

(c) the most reactive non-metal.

(d) the least reactive non-metal.

(e) the metal which can form a stable binary halide of the formula MX₂, (X=halogen).

(f) the metal which can form a predominantly stable covalent halide of the formula MX (X=halogen)?

Define the bond length.

How would you explain the fact that the first ionization enthalpy of sodium is lower than that of magnesium but its second ionization enthalpy is higher than that of magnesium?

The increasing order of reactivity among group 1 elements is Li < Na < K < Rb CI > Br > I. Explain.

Use Lewis symbols to show electron transfer between the following atoms to form cations and anions:

(a) K and S (b) Ca and O (c) Al and N.