Class 11 Chemistry - Chapter The s Block Elements NCERT Solutions | Beryllium and magnesium do not give colo

Compare the alkali metals and alkaline earth metals with respect to

(i) ionization enthalpy

(ii) basicity of oxides and

(iii) solubility of hydroxides.

Compare the solubility and thermal stability of the following compounds of the alkali metals with those of the alkaline earth metals.

(a) Nitrates (b) Carbonates (c) Sulphates.

Discuss the various reactions that occur in the Solvay process.

Comment on each of the following observations:

(a) The mobilities of the alkali metal ions in aqueous solution are Li⁺ <  Na⁺ <  K⁺ <  Rb⁺ < Cs⁺

(b) Lithium is the only alkali metal to form a nitride directly.

(c) E° for M²⁺(aq) (where M = Ca, Sr or Ba) is nearly constant.

Why are lithium salts commonly hydrated and those of the other alkali metal ions usually anhydrous?

State as to why

(a) a solution of Na₂CO₃ is alkaline ?

(b) alkali metals are prepared by electrolysis of their fused chlorides ?

(c) sodium is found to be more useful than potassium ?

When an alkali metal dissolves in liquid ammonia the solution can acquire different colours. Explain the reasons for this type of colour change.

In what ways lithium shows similarities to magnesium in its chemical behaviour?

Why is Li₂CO₃ decomposed at a lower temperature whereas Na₂CO₃ at higher temperature?

Find the oxidation state of sodium in Na₂O₂.

How do you account for the formation of ethane during chlorination of methane?

What are hybridisation states of each carbon atom in the following compounds ?

(i) CH₂=C=O,

(ii) CH₃CH=CH₂,

(iii) (CH₃)₂CO,

(iv) CH₂=CHCN,

(v) C₆H₆

What will be the minimum pressure required to compress 500 dm³ of air at 1 bar to 200 dm³ at 30°C?

Calculate the molecular mass of the following:
(i) H₂O
(ii) CO₂
(iii) CH₄

Assign oxidation number to the underlined elements in each of the following species:

(a) NaH₂PO₄

(b) NaHSO₄

(c) H₄P₂O₇

(d) K₂MnO₄

(e) CaO₂

(f) NaBH₄

(g) H₂S₂O₇

(h) KAl(SO₄)₂.12 H₂O

What is the basic theme of organisation in the periodic table?

Explain the formation of a chemical bond.

Choose the correct answer. A thermodynamic state function is a quantity
(i) used to determine heat changes
(ii) whose value is independent of path
(iii) used to determine pressure volume work
(iv) whose value depends on temperature only.

A liquid is in equilibrium with its vapour in a sealed container at a fixed temperature. The volume of the container is suddenly increased.
a) What is the initial effect of the change on vapour pressure?
b) How do rates of evaporation and condensation change initially?
c) What happens when equilibrium is restored finally and what will be the final vapour pressure?

Justify the position of hydrogen in the periodic table on the basis of its electronic configuration.

How do you count for the following observations?

(a) Though alkaline potassium permanganate and acidic potassium permanganate both are used as oxidants, yet in the manufacture of benzoic acid from toluene we use alcoholic potassium permanganate as an oxidant. Why? Write a balanced redox equation for the reaction.

(b) When concentrated sulphuric acid is added to an inorganic mixture containing chloride, we get colourless pungent smelling gas HCl, but if the mixture contains bromide then we get red vapour of bromine. Why?

Calculate the concentration of nitric acid in moles per litre in a sample which has a density, 1.41 g mL^–1 and the mass per cent of nitric acid in it being 69%.

(a) Classify following oxides as neutral, acidic, basic or amphoteric:

CO, B₂O₃, SiO₂, CO2, Al₂O₃, PbO₂, Tl₂O₃

(b) Write suitable chemical equations to show their nature.

Find energy of each of the photons which

(i) correspond to light of frequency 3× 1015 Hz.

(ii) have wavelength of 0.50 Å.

An alkene ‘A’ contains three C – C, eight C – H σ bonds and one C – C π bond. ‘A’ on ozonolysis gives two moles of an aldehyde of molar mass 44 u. Write IUPAC name of ‘A’.

What happens when

(a) Borax is heated strongly,

(b) Boric acid is added to water,

(c) Aluminium is treated with dilute NaOH,

(d) BF₃ is reacted with ammonia?

Give reasons:

(i) Conc. HNO₃ can be transported in aluminium container.

(ii) A mixture of dilute NaOH and aluminium pieces is used to open drain.

(iii) Graphite is used as lubricant.

(iv) Diamond is used as an abrasive.

(v) Aluminium alloys are used to make aircraft body.

(vi) Aluminium utensils should not be kept in water overnight.

(vii) Aluminium wire is used to make transmission cables.

A photon of wavelength 4 × 10^–7 m strikes on metal surface, the work function of the metal being 2.13 eV. Calculate

(i) the energy of the photon (eV),

(ii) the kinetic energy of the emission, and

(iii) the velocity of the photoelectron (1 eV= 1.6020 × 10^–19 J).

For the process to occur under adiabatic conditions, the correct condition is:
(i) ΔT = 0
(ii) Δp = 0
(iii) q = 0
(iv) w = 0

Following results are observed when sodium metal is irradiated with different wavelengths.

Calculate (a) threshold wavelength and, (b) Planck’s constant.