Class 12 Chemistry - Chapter Chemical Kinetics NCERT Solutions | A reaction is first order in A and secon

The half-life for radioactive decay of ¹⁴C is 5730 years. An archaeological artifact containing wood had only 80% of the ¹⁴C found in a living tree. Estimate the age of the sample.

For a first order reaction, show that time required for 99% completion is twice the time required for the completion of 90% of reaction.

The rate of a reaction quadruples when the temperature changes from 293 K to 313 K. Calculate the energy of activation of the reaction assuming that it does not change with temperature.

A first order reaction takes 40 min for 30% decomposition. Calculate t_1/2.

In a reaction, 2A → Products, the concentration of A decreases from 0.5 mol L^-1 to 0.4 mol L^-1 in 10 minutes. Calculate the rate during this interval?

The conversion of molecules X to Y follows second order kinetics. If concentration of X is increased to three times how will it affect the rate of formation of Y?

During nuclear explosion, one of the products is ⁹⁰Sr with half-life of 28.1 years. If 1μg of ⁹⁰Sr was absorbed in the bones of a newly born baby instead of calcium, how much of it will remain after 10 years and 60 years if it is not lost metabolically.

Sucrose decomposes in acid solution into glucose and fructose according to the first order rate law, with t_1/2 = 3.00 hours. What fraction of sample of sucrose remains after 8 hours?

For the reaction R → P, the concentration of a reactant changes from 0.03 M to 0.02 M in 25 minutes. Calculate the average rate of reaction using units of time both in minutes and seconds.

The decomposition of A into product has value of k as 4.5 x 10³ s^-1 at 10°C and energy of activation 60 kJ mol^-1. At what temperature would k be 1.5 x 10⁴ s^-1?

Write the formulas for the following coordination compounds:

(i) Tetraamminediaquacobalt (III) chloride

(ii) Potassium tetracyanonickelate(II)

(iii) Tris(ethane-1,2-diamine) chromium(III) chloride

(iv) Amminebromidochloridonitrito-N-platinate(II)

(v) Dichloridobis(ethane-1,2-diamine)platinum(IV) nitrate

(vi) Iron(III) hexacyanoferrate(II)

(i) Write structures of different isomeric amines corresponding to the molecular formula, C4H11N

(ii) Write IUPAC names of all the isomers.

(iii) What type of isomerism is exhibited by different pairs of amines?

Why are solids rigid?

Write any two characteristics of Chemisorption.

Write the structures of the following compounds.

(i) α-Methoxypropionaldehyde

(ii) 3-Hydroxybutanal

(iii) 2-Hydroxycyclopentane carbaldehyde

(iv) 4-Oxopentanal

(v) Di-sec-butyl ketone

(vi) 4-Fluoroacetophenone

Which of the ores mentioned in Table 6.1 can be concentrated by magnetic separation method?

Why are pentahalides more covalent than trihalides?

Silver atom has completely filled d orbitals (4d10) in its ground state. How can you say that it is a transition element?

Glucose or sucrose are soluble in water but cyclohexane or benzene (simple six membered ring compounds) are insoluble in water. Explain.

Write structures of the following compounds:

(i) 2-Chloro-3-methylpentane

(ii) 1-Chloro-4-ethylcyclohexane

(iii) 4-tert. Butyl-3-iodoheptane

(iv) 1,4-Dibromobut-2-ene

(v) 1-Bromo-4-sec. butyl-2-methylbenzene

Why is the ester hydrolysis slow in the beginning and becomes faster after sometime?

What are the oxidation states of phosphorus in the following:

(i) H₃PO₃

(ii) PCl₃

(iii) Ca₃P₂

(iv) Na₃PO₄

(v) POF₃?

Explain how does the -OH group attached to a carbon of benzene ring activate it towards electrophilic substitution?

Define the term 'amorphous'. Give a few examples of amorphous solids.

What are lyophilic and lyophobic sols? Give one example of each type. Why are hydrophobic sols easily coagulated?

What may be the stable oxidation state of the transition element with the following d electron configurations in the ground state of their atoms :

3d³, 3d⁵, 3d⁸ and 3d⁴?

How would you account for the following:

(i) Of the d⁴ species, Cr²⁺ is strongly reducing while manganese (III) is strongly oxidising.

(ii) Cobalt (II) is stable in aqueous solution but in the presence of complexing reagents it is easily oxidised.

(iii) The d¹ configuration is very unstable in ions.

Mention the conditions required to maximise the yield of ammonia.

Arrange the following in the order of property indicated for each set:

(i) F₂, Cl₂, Br₂, I₂- increasing bond dissociation enthalpy.

(ii) HF, HCl, HBr, HI - increasing acid strength.

(iii) NH₃, PH₃, AsH₃, SbH₃, BiH₃- increasing base strength.

How are XeO₃ and XeOF₄ prepared?