Class 12 Chemistry - Chapter Surface Chemistry NCERT Solutions | Write any two characteristics of Chemiso

Explain what is observed

(i) When a beam of light is passed through a colloidal sol.

(ii) An electrolyte, NaCl is added to hydrated ferric oxide sol.

(iii) Electric current is passed through a colloidal sol?

Why is adsorption always exothermic?

What do you mean by activity and selectivity of catalysts?

What modification can you suggest in the Hardy-Schulze law?

Explain the following terms:

(i) Electrophoresis

(ii) Coagulation

(iii) Dialysis

(iv) Tyndall effect.

What is an adsorption isotherm? Describe Freundlich adsorption isotherm.

Explain the terms with suitable examples:

(i) Alcosol

(ii) Aerosol

(iii) Hydrosol

How are colloids classified on the basis of

(i) Physical states of components

(ii) Nature of dispersion medium and

(iii) Interaction between dispersed phase and dispersion medium?

Discuss the effect of pressure and temperature on the adsorption of gases on solids.

Why does physisorption decrease with the increase of temperature

For the reaction R → P, the concentration of a reactant changes from 0.03 M to 0.02 M in 25 minutes. Calculate the average rate of reaction using units of time both in minutes and seconds.

Write the formulas for the following coordination compounds:

(i) Tetraamminediaquacobalt (III) chloride

(ii) Potassium tetracyanonickelate(II)

(iii) Tris(ethane-1,2-diamine) chromium(III) chloride

(iv) Amminebromidochloridonitrito-N-platinate(II)

(v) Dichloridobis(ethane-1,2-diamine)platinum(IV) nitrate

(vi) Iron(III) hexacyanoferrate(II)

(i) Write structures of different isomeric amines corresponding to the molecular formula, C4H11N

(ii) Write IUPAC names of all the isomers.

(iii) What type of isomerism is exhibited by different pairs of amines?

Why are solids rigid?

Write the structures of the following compounds.

(i) α-Methoxypropionaldehyde

(ii) 3-Hydroxybutanal

(iii) 2-Hydroxycyclopentane carbaldehyde

(iv) 4-Oxopentanal

(v) Di-sec-butyl ketone

(vi) 4-Fluoroacetophenone

Which of the ores mentioned in Table 6.1 can be concentrated by magnetic separation method?

Why are pentahalides more covalent than trihalides?

Silver atom has completely filled d orbitals (4d10) in its ground state. How can you say that it is a transition element?

Glucose or sucrose are soluble in water but cyclohexane or benzene (simple six membered ring compounds) are insoluble in water. Explain.

Write structures of the following compounds:

(i) 2-Chloro-3-methylpentane

(ii) 1-Chloro-4-ethylcyclohexane

(iii) 4-tert. Butyl-3-iodoheptane

(iv) 1,4-Dibromobut-2-ene

(v) 1-Bromo-4-sec. butyl-2-methylbenzene

The chemistry of the actinoid elements is not so smooth as that of the Lanthanoids. Justify this statement by giving some examples from the oxidation state of these elements.

The molar conductivity of 0.025 mol L-1 methanoic acid is

46.1 S cm2 mol^-1.

Calculate its degree of dissociation and dissociation constant. Given λ⁰(H+)

= 349.6 S cm² mol^-1 and  λ⁰(HCOO^-) = 54.6 S cm² mol

Calculate the mass of a non-volatile solute (molar mass 40 g mol^-1) which should be dissolved in 114 g octane to reduce its vapour pressure to 80%.

Boiling point of water at 750 mm Hg is 99.63°C. How much sucrose is to be added to 500 g of water such that it boils at 100°C.Molal elevation constant for water is 0.52 K kg mol^-1.

Why is sulphuric acid not used during the reaction of alcohols with KI?

Write the formulas for the following coordination compounds:

(i) Tetraamminediaquacobalt (III) chloride

(ii) Potassium tetracyanonickelate(II)

(iii) Tris(ethane-1,2-diamine) chromium(III) chloride

(iv) Amminebromidochloridonitrito-N-platinate(II)

(v) Dichloridobis(ethane-1,2-diamine)platinum(IV) nitrate

(vi) Iron(III) hexacyanoferrate(II)

Give the IUPAC names of the following compounds:

(i) PhCH₂CH₂COOH         (ii) (CH₃)₂C=CHCOOH

(iii)             (iv)

100 g of liquid A (molar mass 140 g mol^-1) was dissolved in 1000 g of liquid B (molar mass 180 g mol^-1). The vapour pressure of pure liquid B was found to be 500 torr. Calculate the vapour pressure of pure liquid A and its vapour pressure in the solution if the total vapour pressure of the solution is 475 Torr.

Silver atom has completely filled d orbitals (4d10) in its ground state. How can you say that it is a transition element?

Write reactions of the final alkylation product of aniline with excess of methyl iodide in the presence of sodium carbonate solution.