Class 12 Chemistry - Chapter Chemistry in Everyday Life NCERT Solutions | What are the main constituents of dettol

Why do soaps not work in hard water?

Explain the following terms with suitable examples

(i) cationic detergents

(ii) anionic detergents and

(iii) non-ionic detergents.

What are food preservatives ?

Sleeping pills are recommended by doctors to the patients suffering from sleeplessness but it is not advisable to take its doses without consultation with the doctor, Why?

How do antiseptics differ from disinfectants ? Give one example of each. 

Why is use of aspartame limited to cold foods and drinks?

With reference to which classification has the statement, ranitidine is an antacid been given?

Write the chemical equation for preparing sodium soap from glyceryl oleate and glyceryl palmitate. Structural formulae of these compounds are given below.

(i) (C₁₅H₃₁COO)₃ C₃H₅ - Glyceryl palmitate

(ii)(C₁₇H₃₃COO)₃ C₃H₅ - Glyceryl oleate

Name a substance which can be used as an antiseptic as well as disinfectant.

What are artificial sweetening agents? Give two examples.

For the reaction R → P, the concentration of a reactant changes from 0.03 M to 0.02 M in 25 minutes. Calculate the average rate of reaction using units of time both in minutes and seconds.

Write the formulas for the following coordination compounds:

(i) Tetraamminediaquacobalt (III) chloride

(ii) Potassium tetracyanonickelate(II)

(iii) Tris(ethane-1,2-diamine) chromium(III) chloride

(iv) Amminebromidochloridonitrito-N-platinate(II)

(v) Dichloridobis(ethane-1,2-diamine)platinum(IV) nitrate

(vi) Iron(III) hexacyanoferrate(II)

(i) Write structures of different isomeric amines corresponding to the molecular formula, C4H11N

(ii) Write IUPAC names of all the isomers.

(iii) What type of isomerism is exhibited by different pairs of amines?

Why are solids rigid?

Write any two characteristics of Chemisorption.

Write the structures of the following compounds.

(i) α-Methoxypropionaldehyde

(ii) 3-Hydroxybutanal

(iii) 2-Hydroxycyclopentane carbaldehyde

(iv) 4-Oxopentanal

(v) Di-sec-butyl ketone

(vi) 4-Fluoroacetophenone

Which of the ores mentioned in Table 6.1 can be concentrated by magnetic separation method?

Why are pentahalides more covalent than trihalides?

Silver atom has completely filled d orbitals (4d10) in its ground state. How can you say that it is a transition element?

Glucose or sucrose are soluble in water but cyclohexane or benzene (simple six membered ring compounds) are insoluble in water. Explain.

Given the standard electrode potentials,

K⁺/ K = - 2.93V, 

Ag⁺/ Ag = 0.80V,

Hg²⁺ / Hg = 0.79V

Mg²⁺ / Mg = - 2.37 V,

Cr³⁺ / Cr = - 0.74V

Arrange these metals in their increasing order of reducing power.

Justify the placement of O, S, Se, Te and Po in the same group of the periodic table in terms of electronic configuration, oxidation state and hydride formation.

What is the two dimensional coordination number of a molecule in square close packed layer?

Which acid of each pair shown here would you expect to be stronger?

(i) CH₃CO₂H or CH₂FCO₂H

(ii)CH₂FCO₂H or CH₂ClCO₂H

(iii) CH₂FCH₂CH₂CO₂H or CH₃CHFCH₂CO₂H

(iv)

Consult the table of standard electrode potentials and suggest three substances that can oxidise ferrous ions under suitable conditions.

Name the reagents used in the following reactions:

(i) Oxidation of a primary alcohol to carboxylic acid.

(ii) Oxidation of a primary alcohol to aldehyde.

(iii) Bromination of phenol to 2,4,6-tribromophenol.

(iv) Benzyl alcohol to benzoic acid.

(v) Dehydration of propan-2-ol to propene.

(vi) Butan-2-one to butan-2-ol.

100 g of liquid A (molar mass 140 g mol^-1) was dissolved in 1000 g of liquid B (molar mass 180 g mol^-1). The vapour pressure of pure liquid B was found to be 500 torr. Calculate the vapour pressure of pure liquid A and its vapour pressure in the solution if the total vapour pressure of the solution is 475 Torr.

Compare the chemistry of the actinoids with that of lanthanoids with reference to:

(i) electronic configuration

(ii) oxidation states and

(iii) chemical reactivity.

In the series Sc (Z = 21) to Zn (Z = 30), the enthalpy of atomization of zinc is the lowest, i.e., 126 kJ mol−1. Why?

Use Hund's rule to derive the electronic configuration of Ce³⁺ ion and calculate its magnetic moment on the basis of 'spin-only' formula.