Class 12 Chemistry - Chapter Surface Chemistry NCERT Solutions | What is the difference between physisorp

Explain what is observed

(i) When a beam of light is passed through a colloidal sol.

(ii) An electrolyte, NaCl is added to hydrated ferric oxide sol.

(iii) Electric current is passed through a colloidal sol?

Why is adsorption always exothermic?

What do you mean by activity and selectivity of catalysts?

What modification can you suggest in the Hardy-Schulze law?

Explain the following terms:

(i) Electrophoresis

(ii) Coagulation

(iii) Dialysis

(iv) Tyndall effect.

What is an adsorption isotherm? Describe Freundlich adsorption isotherm.

Explain the terms with suitable examples:

(i) Alcosol

(ii) Aerosol

(iii) Hydrosol

How are colloids classified on the basis of

(i) Physical states of components

(ii) Nature of dispersion medium and

(iii) Interaction between dispersed phase and dispersion medium?

Discuss the effect of pressure and temperature on the adsorption of gases on solids.

Why does physisorption decrease with the increase of temperature

For the reaction R → P, the concentration of a reactant changes from 0.03 M to 0.02 M in 25 minutes. Calculate the average rate of reaction using units of time both in minutes and seconds.

Write the formulas for the following coordination compounds:

(i) Tetraamminediaquacobalt (III) chloride

(ii) Potassium tetracyanonickelate(II)

(iii) Tris(ethane-1,2-diamine) chromium(III) chloride

(iv) Amminebromidochloridonitrito-N-platinate(II)

(v) Dichloridobis(ethane-1,2-diamine)platinum(IV) nitrate

(vi) Iron(III) hexacyanoferrate(II)

(i) Write structures of different isomeric amines corresponding to the molecular formula, C4H11N

(ii) Write IUPAC names of all the isomers.

(iii) What type of isomerism is exhibited by different pairs of amines?

Why are solids rigid?

Write the structures of the following compounds.

(i) α-Methoxypropionaldehyde

(ii) 3-Hydroxybutanal

(iii) 2-Hydroxycyclopentane carbaldehyde

(iv) 4-Oxopentanal

(v) Di-sec-butyl ketone

(vi) 4-Fluoroacetophenone

Which of the ores mentioned in Table 6.1 can be concentrated by magnetic separation method?

Why are pentahalides more covalent than trihalides?

Silver atom has completely filled d orbitals (4d10) in its ground state. How can you say that it is a transition element?

Glucose or sucrose are soluble in water but cyclohexane or benzene (simple six membered ring compounds) are insoluble in water. Explain.

Write structures of the following compounds:

(i) 2-Chloro-3-methylpentane

(ii) 1-Chloro-4-ethylcyclohexane

(iii) 4-tert. Butyl-3-iodoheptane

(iv) 1,4-Dibromobut-2-ene

(v) 1-Bromo-4-sec. butyl-2-methylbenzene

Give structures of the products you would expect when each of the following alcohol reacts with (a) HCl-ZnCl₂ (b) HBr and (c) SOCl₂.

(i) Butan-1-ol

(ii) 2-Methylbutan-2-ol

You are given benzene, conc. H₂SO₄ and NaOH. Write the equations for the preparation of phenol using these reagents.

For M²⁺/M and M³⁺/M²⁺ systems, the E^⊖  values for some metals are as follows:

Cr²⁺/Cr -0.9V

Cr³/Cr²⁺ -0.4 V

Mn²⁺/Mn -1.2V

Mn³⁺/Mn²⁺ +1.5 V

Fe²⁺/Fe -0.4V

Fe³⁺/Fe²⁺ +0.8 V

Use this data to comment upon:

(i) The stability of Fe³⁺in acid solution as compared to that of Cr³⁺or Mn³⁺ and

(ii) The ease with which iron can be oxidised as compared to a similar process for either chromium or manganese metal.

How much electricity in terms of Faraday is required to produce

(i) 20.0 g of Ca from molten CaCl₂.

(ii) 40.0 g of Al from molten Al₂O₃.

What are the oxidation states of phosphorus in the following:

(i) H₃PO₃

(ii) PCl₃

(iii) Ca₃P₂

(iv) Na₃PO₄

(v) POF₃?

Discuss the main purpose of vulcanisation of rubber.

If a current of 0.5 ampere flows through a metallic wire for 2 hours, then how many electrons would flow through the wire?

(i) What is meant by the term 'coordination number'?

(ii) What is the coordination number of atoms:

(a) in a cubic close-packed structure?

(b) in a body-centred cubic structure?

Why are halogens coloured?

In the button cells widely used in watches and other devices the following reaction takes place:

Zn(s) + Ag₂O(s) + H₂O(l)  → Zn²⁺(aq) + 2Ag(s) + 2OH ^- (aq)

Determine and for the reaction.