Class 12 Chemistry - Chapter Surface Chemistry NCERT Solutions | What is the role of desorption in the pr

Explain what is observed

(i) When a beam of light is passed through a colloidal sol.

(ii) An electrolyte, NaCl is added to hydrated ferric oxide sol.

(iii) Electric current is passed through a colloidal sol?

Why is adsorption always exothermic?

What do you mean by activity and selectivity of catalysts?

What modification can you suggest in the Hardy-Schulze law?

Explain the following terms:

(i) Electrophoresis

(ii) Coagulation

(iii) Dialysis

(iv) Tyndall effect.

What is an adsorption isotherm? Describe Freundlich adsorption isotherm.

Explain the terms with suitable examples:

(i) Alcosol

(ii) Aerosol

(iii) Hydrosol

How are colloids classified on the basis of

(i) Physical states of components

(ii) Nature of dispersion medium and

(iii) Interaction between dispersed phase and dispersion medium?

Discuss the effect of pressure and temperature on the adsorption of gases on solids.

Why does physisorption decrease with the increase of temperature

For the reaction R → P, the concentration of a reactant changes from 0.03 M to 0.02 M in 25 minutes. Calculate the average rate of reaction using units of time both in minutes and seconds.

Write the formulas for the following coordination compounds:

(i) Tetraamminediaquacobalt (III) chloride

(ii) Potassium tetracyanonickelate(II)

(iii) Tris(ethane-1,2-diamine) chromium(III) chloride

(iv) Amminebromidochloridonitrito-N-platinate(II)

(v) Dichloridobis(ethane-1,2-diamine)platinum(IV) nitrate

(vi) Iron(III) hexacyanoferrate(II)

(i) Write structures of different isomeric amines corresponding to the molecular formula, C4H11N

(ii) Write IUPAC names of all the isomers.

(iii) What type of isomerism is exhibited by different pairs of amines?

Why are solids rigid?

Write the structures of the following compounds.

(i) α-Methoxypropionaldehyde

(ii) 3-Hydroxybutanal

(iii) 2-Hydroxycyclopentane carbaldehyde

(iv) 4-Oxopentanal

(v) Di-sec-butyl ketone

(vi) 4-Fluoroacetophenone

Which of the ores mentioned in Table 6.1 can be concentrated by magnetic separation method?

Why are pentahalides more covalent than trihalides?

Silver atom has completely filled d orbitals (4d10) in its ground state. How can you say that it is a transition element?

Glucose or sucrose are soluble in water but cyclohexane or benzene (simple six membered ring compounds) are insoluble in water. Explain.

Write structures of the following compounds:

(i) 2-Chloro-3-methylpentane

(ii) 1-Chloro-4-ethylcyclohexane

(iii) 4-tert. Butyl-3-iodoheptane

(iv) 1,4-Dibromobut-2-ene

(v) 1-Bromo-4-sec. butyl-2-methylbenzene

Name a substance which can be used as an antiseptic as well as disinfectant.

Write IUPAC names of the following compounds and classify them into primary,secondary and tertiary amines.

(i) (CH₃)₂ CHNH₂

(ii) CH₃(CH₂)₂NH₂

(iii) CH₃NHCH(CH₃)₂

(iv) (CH₃)₃CNH₂

(v) C₆H₅NHCH₃

(vi) (CH₃CH₂)₂NCH₃

(vii) m-BrC₆H₄NH₂

If a current of 0.5 ampere flows through a metallic wire for 2 hours, then how many electrons would flow through the wire?

Conductivity of 0.00241 M acetic acid is 7.896 × 10 ^{- 5} S cm ^{- 1}. Calculate its molar conductivity and if A_m^º for acetic acid is 390.5 S cm² mol ^{- 1}, what is its dissociation constant?

Alcohols are comparatively more soluble in water than hydrocarbons of comparable molecular masses. Explain this fact.

p-Dichlorobenzene has higher m.p. and lower solubility than those of o- and m-isomers. Discuss.

How many ions are produced from the complex Co(NH₃)₆Cl₂ in solution?

(i) 6

(ii) 4

(iii) 3

(iv) 2

Give the disproportionation reaction of H₃PO₃.

Illustrate with examples the limitations of Williamson synthesis for the preparation of certain types of ethers.

What are the characteristics of the transition elements and why are they called transition elements? Which of the d-block elements may not be regarded as the transition elements?