Class 12 Chemistry - Chapter The p-Block Elements NCERT Solutions | What happens when H3PO3 is heated?

Why is helium used in diving apparatus?

Why are pentahalides more covalent than trihalides?

Give the formula and describe the structure of a noble gas species which is isostructural with:

(i) ICl^-₄

(ii) IBr^-₂

(iii) BrO^-₃

Why is H₂O a liquid and H₂S a gas?

How is O₃ estimated quantitatively?

What happens when sulphur dioxide is passed through an aqueous solution of Fe(III) salt?

Why is BiH3 the strongest reducing agent amongst all the hydrides of Group 15 elements?

Why are halogens strong oxidising agents?

Arrange the following in the order of property indicated for each set:

(i) F₂, Cl₂, Br₂, I₂- increasing bond dissociation enthalpy.

(ii) HF, HCl, HBr, HI - increasing acid strength.

(iii) NH₃, PH₃, AsH₃, SbH₃, BiH₃- increasing base strength.

Comment on the nature of two S-O bonds formed in SO₂ molecule. Are the two S-O bonds in this molecule equal?

For the reaction R → P, the concentration of a reactant changes from 0.03 M to 0.02 M in 25 minutes. Calculate the average rate of reaction using units of time both in minutes and seconds.

Write the formulas for the following coordination compounds:

(i) Tetraamminediaquacobalt (III) chloride

(ii) Potassium tetracyanonickelate(II)

(iii) Tris(ethane-1,2-diamine) chromium(III) chloride

(iv) Amminebromidochloridonitrito-N-platinate(II)

(v) Dichloridobis(ethane-1,2-diamine)platinum(IV) nitrate

(vi) Iron(III) hexacyanoferrate(II)

(i) Write structures of different isomeric amines corresponding to the molecular formula, C4H11N

(ii) Write IUPAC names of all the isomers.

(iii) What type of isomerism is exhibited by different pairs of amines?

Why are solids rigid?

Write any two characteristics of Chemisorption.

Write the structures of the following compounds.

(i) α-Methoxypropionaldehyde

(ii) 3-Hydroxybutanal

(iii) 2-Hydroxycyclopentane carbaldehyde

(iv) 4-Oxopentanal

(v) Di-sec-butyl ketone

(vi) 4-Fluoroacetophenone

Which of the ores mentioned in Table 6.1 can be concentrated by magnetic separation method?

Silver atom has completely filled d orbitals (4d10) in its ground state. How can you say that it is a transition element?

Glucose or sucrose are soluble in water but cyclohexane or benzene (simple six membered ring compounds) are insoluble in water. Explain.

Write structures of the following compounds:

(i) 2-Chloro-3-methylpentane

(ii) 1-Chloro-4-ethylcyclohexane

(iii) 4-tert. Butyl-3-iodoheptane

(iv) 1,4-Dibromobut-2-ene

(v) 1-Bromo-4-sec. butyl-2-methylbenzene

Is it true that under certain conditions, Mg can reduce SiO₂ and Si can reduce MgO? What are those conditions?

Benzene and toluene form ideal solution over the entire range of composition. The vapour pressure of pure benzene and toluene at 300 K are 50.71 mm Hg and 32.06 mm Hg respectively. Calculate the mole fraction of benzene in vapour phase if 80 g of benzene is mixed with 100 g of toluene.

What is meant by the chelate effect? Give an example.

Write the mechanism of the reaction of HI with methoxymethane.

Predict conditions under which Al might be expected to reduce MgO.

Calculate the depression in the freezing point of water when 10 g of CH₃CH₂CHClCOOH is added to 250 g of water. K_a = 1.4 x 10^-3, K_f = 1.86 K kg mol^-1.

The decomposition of dimethyl ether leads to the formation of CH₄, H₂and CO and the reaction rate is given by

Rate = k [CH₃OCH₃]^3/2

The rate of reaction is followed by increase in pressure in a closed vessel, so the rate can also be expressed in terms of the partial pressure of dimethyl ether, i.e.,

 Rate = k (P_CH3OCH3)^3/2

If the pressure is measured in bar andtime in minutes, then what are the units of rate and rate constants?

What are biodegradable and non-biodegradable detergents? Give one example of each.

What type of substances would make better permanent magnets, ferromagnetic or ferrimagnetic. Justify your answer.

Show how each of the following compounds can be converted to benzoic acid.

(i) Ethylbenzene        (ii) Acetophenone

(iii) Bromobenzene    (iv) Phenylethene (Styrene)