Describe the hybridisation in case of PCl5. Why are the axial bonds longer as compared to equatorial bonds?
Atomic number of Phosphorous is 15.
The Ground state configuration is
& the excited state configuration is
The 5 electrons present in valence shell form bond pairs with the electrons of five chlorine atoms. Phosphorus atom is sp3d hybridized in the excited state.
PCl5
The geometry of PCl5 is trigonal bipyramidal .The P atom lies in the centre of an equatorial triangle & three P-Cl bonds (equatorial bonds) are directed towards its three corners with 120° bond angle. The remaining two P-Cl bonds (axial bonds) lie above & below the plane of the triangle at bond angle 90° .
The axial bonds are longer than equatorial bonds because the axial Cl atoms suffer from more repulsion then the equatorial Cl atoms,as a result the axial Cl atoms tries to reside far away from the equatorial Cl atoms, & hence axial bond are longer than equatorial bonds.
What is meant by the term bond order? Calculate the bond order of: N2, O2,O2+,and O2-.
Use molecular orbital theory to explain why the Be2 molecule does not exist.
Explain the formation of H2 molecule on the basis of valence bond theory.
Compare the relative stability of the following species and indicate their magnetic properties:
O2,O2+,O2- (superoxide), O22-(peroxide)
Which out of NH3 and NF3 has higher dipole moment and why?
Explain why BeH2 molecule has a zero dipole moment although the Be–H bonds are polar.
Discuss the shape of the following molecules using the VSEPR model:
BeCl2, BCl3, SiCl4, AsF5, H2S, PH3
Write Lewis symbols for the following atoms and ions:
S and S2–; Al and Al3+; H and H–
Describe the change in hybridisation (if any) of the Al atom in the following reaction.
Draw the Lewis structures for the following molecules and ions: H2S, SiCl4, BeF2, , HCOOH
How do you account for the formation of ethane during chlorination of methane?
What are hybridisation states of each carbon atom in the following compounds ?
(i) CH2=C=O,
(ii) CH3CH=CH2,
(iii) (CH3)2CO,
(iv) CH2=CHCN,
(v) C6H6
What will be the minimum pressure required to compress 500 dm3 of air at 1 bar to 200 dm3 at 30°C?
What are the common physical and chemical features of alkali metals?
Calculate the molecular mass of the following:
(i) H2O
(ii) CO2
(iii) CH4
Assign oxidation number to the underlined elements in each of the following species:
(a) NaH2PO4
(b) NaHSO4
(c) H4P2O7
(d) K2MnO4
(e) CaO2
(f) NaBH4
(g) H2S2O7
(h) KAl(SO4)2.12 H2O
What is the basic theme of organisation in the periodic table?
Choose the correct answer. A thermodynamic state function is a quantity
(i) used to determine heat changes
(ii) whose value is independent of path
(iii) used to determine pressure volume work
(iv) whose value depends on temperature only.
A liquid is in equilibrium with its vapour in a sealed container at a fixed temperature. The volume of the container is suddenly increased.
a) What is the initial effect of the change on vapour pressure?
b) How do rates of evaporation and condensation change initially?
c) What happens when equilibrium is restored finally and what will be the final vapour pressure?
Justify the position of hydrogen in the periodic table on the basis of its electronic configuration.
Addition of HBr to propene yields 2-bromopropane, while in the presence of benzoyl peroxide, the same reaction yields 1-bromopropane. Explain and give mechanism.
What do you expect the nature of hydrides is, if formed by elements of atomic numbers 15, 19, 23 and 44 with dihydrogen? Compare their behaviour towards water.
Arrange the following set of compounds in order of their decreasing relative reactivity with an electrophile, E+
(a) Chlorobenzene, 2,4-dinitrochlorobenzene, p-nitrochlorobenzene
(b) Toluene, p-H3C-C6H4-NO2, p-O2N-C6H4-NO2.
How would you explain the following observations?
(i) BeO is almost insoluble but BeSO4 in soluble in water,
(ii) BaO is soluble but BaSO4 is insoluble in water,
(iii) LiI is more soluble than KI in ethanol.
In the alkane H3C – CH2 – C(CH3)2 – CH2 – CH(CH3)2, identify 1°,2°,3° carbon atoms and give the number of H atoms bonded to each one of these.
Why are lithium salts commonly hydrated and those of the other alkali metal ions usually anhydrous?
Describe the effect of :
a) addition of H2
b) addition of CH3OH
c) removal of CO
d) removal of CH3OH on the equilibrium of the reaction: 2H2(g) + CO (g) ↔ CH3OH (g)
Elements of group 14
(a) exhibit oxidation state of +4 only
(b) exhibit oxidation state of +2 and +4
(c) form M2-and M4+ion
(d) form M2+and M4+ions
In Milikan’s experiment, static electric charge on the oil drops has been obtained by shining X-rays.
If the static electric charge on the oil drop is –1.282 × 10–18C, calculate the number of electrons present on it.
The equilibrium constant for a reaction is 10. What will be the value of ΔG0 ? R = 8.314 JK–1 mol–1, T = 300 K.
Thanku
wrong config given... please correct
Orbital diagram of P atom
Formation of PCl5 molecule class11th
Define BMO and ABMO? How is it used to calculate bond order of the molecule???
Answer is right but electronic configuration is wrong because 3P have 3 degerated orbital and 3D have 5.
Answer is good but it electroni configuration is give wrong
Nice working with this answered
exelent...