Class 12 Chemistry - Chapter Chemical Kinetics NCERT Solutions | Time required to decompose SO2Cl2to half

The half-life for radioactive decay of ¹⁴C is 5730 years. An archaeological artifact containing wood had only 80% of the ¹⁴C found in a living tree. Estimate the age of the sample.

For a first order reaction, show that time required for 99% completion is twice the time required for the completion of 90% of reaction.

The rate of a reaction quadruples when the temperature changes from 293 K to 313 K. Calculate the energy of activation of the reaction assuming that it does not change with temperature.

A first order reaction takes 40 min for 30% decomposition. Calculate t_1/2.

In a reaction, 2A → Products, the concentration of A decreases from 0.5 mol L^-1 to 0.4 mol L^-1 in 10 minutes. Calculate the rate during this interval?

The conversion of molecules X to Y follows second order kinetics. If concentration of X is increased to three times how will it affect the rate of formation of Y?

During nuclear explosion, one of the products is ⁹⁰Sr with half-life of 28.1 years. If 1μg of ⁹⁰Sr was absorbed in the bones of a newly born baby instead of calcium, how much of it will remain after 10 years and 60 years if it is not lost metabolically.

Sucrose decomposes in acid solution into glucose and fructose according to the first order rate law, with t_1/2 = 3.00 hours. What fraction of sample of sucrose remains after 8 hours?

The decomposition of A into product has value of k as 4.5 x 10³ s^-1 at 10°C and energy of activation 60 kJ mol^-1. At what temperature would k be 1.5 x 10⁴ s^-1?

For the reaction R → P, the concentration of a reactant changes from 0.03 M to 0.02 M in 25 minutes. Calculate the average rate of reaction using units of time both in minutes and seconds.

Write the formulas for the following coordination compounds:

(i) Tetraamminediaquacobalt (III) chloride

(ii) Potassium tetracyanonickelate(II)

(iii) Tris(ethane-1,2-diamine) chromium(III) chloride

(iv) Amminebromidochloridonitrito-N-platinate(II)

(v) Dichloridobis(ethane-1,2-diamine)platinum(IV) nitrate

(vi) Iron(III) hexacyanoferrate(II)

(i) Write structures of different isomeric amines corresponding to the molecular formula, C4H11N

(ii) Write IUPAC names of all the isomers.

(iii) What type of isomerism is exhibited by different pairs of amines?

Why are solids rigid?

Write any two characteristics of Chemisorption.

Write the structures of the following compounds.

(i) α-Methoxypropionaldehyde

(ii) 3-Hydroxybutanal

(iii) 2-Hydroxycyclopentane carbaldehyde

(iv) 4-Oxopentanal

(v) Di-sec-butyl ketone

(vi) 4-Fluoroacetophenone

Which of the ores mentioned in Table 6.1 can be concentrated by magnetic separation method?

Why are pentahalides more covalent than trihalides?

Silver atom has completely filled d orbitals (4d10) in its ground state. How can you say that it is a transition element?

Glucose or sucrose are soluble in water but cyclohexane or benzene (simple six membered ring compounds) are insoluble in water. Explain.

Write structures of the following compounds:

(i) 2-Chloro-3-methylpentane

(ii) 1-Chloro-4-ethylcyclohexane

(iii) 4-tert. Butyl-3-iodoheptane

(iv) 1,4-Dibromobut-2-ene

(v) 1-Bromo-4-sec. butyl-2-methylbenzene

What type of solids are electrical conductors, malleable and ductile?

Predict the products of the following reactions:

(i)

(ii)

(iii)

(iv)

p-Dichlorobenzene has higher m.p. and lower solubility than those of o- and m-isomers. Discuss.

Describe the preparation of potassium permanganate. How does the acidifiedpermanganate solution react with

(i) iron

(II) ions 

(ii) SO₂ and

(iii) oxalic acid?

Write the ionic equations for the reactions.

For M²⁺/M and M³⁺/M²⁺ systems, the E^⊖  values for some metals are as follows:

Cr²⁺/Cr -0.9V

Cr³/Cr²⁺ -0.4 V

Mn²⁺/Mn -1.2V

Mn³⁺/Mn²⁺ +1.5 V

Fe²⁺/Fe -0.4V

Fe³⁺/Fe²⁺ +0.8 V

Use this data to comment upon:

(i) The stability of Fe³⁺in acid solution as compared to that of Cr³⁺or Mn³⁺ and

(ii) The ease with which iron can be oxidised as compared to a similar process for either chromium or manganese metal.

Explain briefly how +2 state becomes more and more stable in the first half of the first row transition elements with increasing atomic number?

What are polymers?

What happens when white phosphorus is heated with concentrated NaO Hsolution in an inert atmosphere of CO₂?

What type of defect can arise when a solid is heated? Which physical property is affected by it and in what way?

Giving examples, differentiate between 'roasting' and 'calcination'.