Class 12 Chemistry - Chapter The Solid State NCERT Solutions | What type of defect can arise when a sol

If NaCl is doped with 10^-3mol % of SrCl₂, what is the concentration of cation vacancies?

A cubic solid is made of two elements P and Q. Atoms of Q are at the corners of the cube and P at the body-centre. What is the formula of the compound? What are the coordination numbers of P and Q?

An element with molar mass 2.7 x 10^-2kg mol^-1 forms a cubic unit cell with edge length 405 pm. If its density is 2.7 x 10³ kg m^-3, what is the nature of the cubic unit cell?

Copper crystallises into a fcc lattice with edge length 3.61 x 10^-8cm. Show that the calculated density is in agreement with its measured value of 8.92 g cm^-3.

A compound is formed by two elements M and N. The element N forms ccp and atoms of M occupy 1/3^rd of tetrahedral voids. What is the formula of the compound?

Aluminium crystallises in a cubic close-packed structure. Its metallic radius is 125 pm.

(i) What is the length of the side of the unit cell?

(ii) How many unit cells are there in 1.00 cm3of aluminium?

Analysis shows that nickel oxide has the formula Ni_0.98 O_1.00. What fractions of nickel exist as Ni²⁺and Ni³⁺ions?

Distinguish between

(i)Hexagonal and monoclinic unit cells

(ii) Face-centred and end-centred unit cells.

Solid A is a very hard electrical insulator in solid as well as in molten state and melts at extremely high temperature. What type of solid is it?

Ionic solids, which have anionic vacancies due to metal excess defect, develop colour. Explain with the help of a suitable example.

For the reaction R → P, the concentration of a reactant changes from 0.03 M to 0.02 M in 25 minutes. Calculate the average rate of reaction using units of time both in minutes and seconds.

Write the formulas for the following coordination compounds:

(i) Tetraamminediaquacobalt (III) chloride

(ii) Potassium tetracyanonickelate(II)

(iii) Tris(ethane-1,2-diamine) chromium(III) chloride

(iv) Amminebromidochloridonitrito-N-platinate(II)

(v) Dichloridobis(ethane-1,2-diamine)platinum(IV) nitrate

(vi) Iron(III) hexacyanoferrate(II)

(i) Write structures of different isomeric amines corresponding to the molecular formula, C4H11N

(ii) Write IUPAC names of all the isomers.

(iii) What type of isomerism is exhibited by different pairs of amines?

Write any two characteristics of Chemisorption.

Write the structures of the following compounds.

(i) α-Methoxypropionaldehyde

(ii) 3-Hydroxybutanal

(iii) 2-Hydroxycyclopentane carbaldehyde

(iv) 4-Oxopentanal

(v) Di-sec-butyl ketone

(vi) 4-Fluoroacetophenone

Which of the ores mentioned in Table 6.1 can be concentrated by magnetic separation method?

Why are pentahalides more covalent than trihalides?

Silver atom has completely filled d orbitals (4d10) in its ground state. How can you say that it is a transition element?

Glucose or sucrose are soluble in water but cyclohexane or benzene (simple six membered ring compounds) are insoluble in water. Explain.

Write structures of the following compounds:

(i) 2-Chloro-3-methylpentane

(ii) 1-Chloro-4-ethylcyclohexane

(iii) 4-tert. Butyl-3-iodoheptane

(iv) 1,4-Dibromobut-2-ene

(v) 1-Bromo-4-sec. butyl-2-methylbenzene

Calculate the half-life of a first order reaction from their rate constants given below:

(i) 200 s^-1

(ii) 2 min^-1

(iii) 4 years^-1

Write the reactions of (i) aromatic and (ii) aliphatic primary amines with nitrous acid.

Give the disproportionation reaction of H₃PO₃.

Write IUPAC names of the following compounds and classify them into primary,secondary and tertiary amines.

(i) (CH₃)₂ CHNH₂

(ii) CH₃(CH₂)₂NH₂

(iii) CH₃NHCH(CH₃)₂

(iv) (CH₃)₃CNH₂

(v) C₆H₅NHCH₃

(vi) (CH₃CH₂)₂NCH₃

(vii) m-BrC₆H₄NH₂

A solution of glucose in water is labelled as 10% w/w, what would be the molality and mole fraction of each component in the solution? If the density of solution is 1.2 g mL^-1, then what shall be the molarity of the solution?

Why does R₃P=O exist but R₃N=O does not (R = alkyl group)?

Low level of noradrenaline is the cause of depression. What type of drugs are needed to cure this problem ? Name two drugs.

Classify the following as addition and condensation polymers: Terylene, Bakelite, Polyvinyl chloride, Polythene.

The rate constant for a first order reaction is 60 s^-1. How much time will it take to reduce the initial concentration of the reactant to its 1/16^th value?

What happens when sulphur dioxide is passed through an aqueous solution of Fe(III) salt?