Class 12 Chemistry - Chapter General Principles and Processes of Isolation of Elements NCERT Solutions | What is meant by the term "chromato

What is the significance of leaching in the extraction of aluminium?

Write down the reactions taking place in different zones in the blast furnace during the extraction of iron.

Copper can be extracted by hydrometallurgy but not zinc. Explain.

Outline the principles of refining of metals by the following methods:

(i) Zone refining

(ii) Electrolytic refining

(iii) Vapour phase refining

Name the common elements present in the anode mud in electrolytic refining of copper. Why are they so present ?

The reaction,

      Cr₂O₃  +  2Al    →    Al₂O₃  + 2Cr            (ΔG_o = -421kJ)

is thermodynamically feasible as is apparent from the Gibbs energy value. Why does it not take place at room temperature?

How can you separate alumina from silica in bauxite ore associated with silica? Give equations, if any.

Why is the extraction of copper from pyrites more difficult than that from its oxide ore through reduction?

Write chemical reactions taking place in the extraction of zinc from zinc blende.

Describe a method for refining nickel.

For the reaction R → P, the concentration of a reactant changes from 0.03 M to 0.02 M in 25 minutes. Calculate the average rate of reaction using units of time both in minutes and seconds.

Write the formulas for the following coordination compounds:

(i) Tetraamminediaquacobalt (III) chloride

(ii) Potassium tetracyanonickelate(II)

(iii) Tris(ethane-1,2-diamine) chromium(III) chloride

(iv) Amminebromidochloridonitrito-N-platinate(II)

(v) Dichloridobis(ethane-1,2-diamine)platinum(IV) nitrate

(vi) Iron(III) hexacyanoferrate(II)

(i) Write structures of different isomeric amines corresponding to the molecular formula, C4H11N

(ii) Write IUPAC names of all the isomers.

(iii) What type of isomerism is exhibited by different pairs of amines?

Why are solids rigid?

Write any two characteristics of Chemisorption.

Write the structures of the following compounds.

(i) α-Methoxypropionaldehyde

(ii) 3-Hydroxybutanal

(iii) 2-Hydroxycyclopentane carbaldehyde

(iv) 4-Oxopentanal

(v) Di-sec-butyl ketone

(vi) 4-Fluoroacetophenone

Why are pentahalides more covalent than trihalides?

Silver atom has completely filled d orbitals (4d10) in its ground state. How can you say that it is a transition element?

Glucose or sucrose are soluble in water but cyclohexane or benzene (simple six membered ring compounds) are insoluble in water. Explain.

Write structures of the following compounds:

(i) 2-Chloro-3-methylpentane

(ii) 1-Chloro-4-ethylcyclohexane

(iii) 4-tert. Butyl-3-iodoheptane

(iv) 1,4-Dibromobut-2-ene

(v) 1-Bromo-4-sec. butyl-2-methylbenzene

Vapour pressure of water at 293 Kis 17.535 mm Hg. Calculate the vapour pressure of water at 293 Kwhen 25 g of glucose is dissolved in 450 g of water.

 Name the macromolecules that are chosen as drug targets.

Consider a certain reaction A → Products with k = 2.0 x 10^-2 s^-1. Calculate the concentration of A remaining after 100 s if the initial concentration of A is 1.0 mol L^-1.

The rate of a reaction quadruples when the temperature changes from 293 K to 313 K. Calculate the energy of activation of the reaction assuming that it does not change with temperature.

What is demulsification? Name two demulsifiers.

The air is a mixture of a number of gases. The major components are oxygen and nitrogen with approximate proportion of 20% is to 79% by volume at 298 K. The water is in equilibrium with air at a pressure of 10 atm. At 298 Kif the Henry's law constants for oxygen and nitrogen are 3.30 x 10⁷ mm and 6.51 x 10⁷mm respectively, calculate the composition of these gases in water.

A group 14 element is to be converted into n-type semiconductor by doping it with a suitable impurity. To which group should this impurity belong?

Write any two characteristics of Chemisorption.

Why does NH₃ form hydrogen bond but PH₃ does not?

Predict the products formed when cyclohexanecarbaldehyde reacts with following reagents.

(i) PhMgBr and then H₃O⁺

(ii)Tollens' reagent

(iii) Semicarbazide and weak acid

(iv)Excess ethanol and acid

(v) Zinc amalgam and dilute hydrochloric acid