Class 12 Chemistry - Chapter General Principles and Processes of Isolation of Elements NCERT Solutions | Out of C and CO, which is a better reduc

What is the significance of leaching in the extraction of aluminium?

Write down the reactions taking place in different zones in the blast furnace during the extraction of iron.

Copper can be extracted by hydrometallurgy but not zinc. Explain.

Outline the principles of refining of metals by the following methods:

(i) Zone refining

(ii) Electrolytic refining

(iii) Vapour phase refining

Name the common elements present in the anode mud in electrolytic refining of copper. Why are they so present ?

The reaction,

      Cr₂O₃  +  2Al    →    Al₂O₃  + 2Cr            (ΔG_o = -421kJ)

is thermodynamically feasible as is apparent from the Gibbs energy value. Why does it not take place at room temperature?

How can you separate alumina from silica in bauxite ore associated with silica? Give equations, if any.

Why is the extraction of copper from pyrites more difficult than that from its oxide ore through reduction?

Write chemical reactions taking place in the extraction of zinc from zinc blende.

Describe a method for refining nickel.

For the reaction R → P, the concentration of a reactant changes from 0.03 M to 0.02 M in 25 minutes. Calculate the average rate of reaction using units of time both in minutes and seconds.

Write the formulas for the following coordination compounds:

(i) Tetraamminediaquacobalt (III) chloride

(ii) Potassium tetracyanonickelate(II)

(iii) Tris(ethane-1,2-diamine) chromium(III) chloride

(iv) Amminebromidochloridonitrito-N-platinate(II)

(v) Dichloridobis(ethane-1,2-diamine)platinum(IV) nitrate

(vi) Iron(III) hexacyanoferrate(II)

(i) Write structures of different isomeric amines corresponding to the molecular formula, C4H11N

(ii) Write IUPAC names of all the isomers.

(iii) What type of isomerism is exhibited by different pairs of amines?

Why are solids rigid?

Write any two characteristics of Chemisorption.

Write the structures of the following compounds.

(i) α-Methoxypropionaldehyde

(ii) 3-Hydroxybutanal

(iii) 2-Hydroxycyclopentane carbaldehyde

(iv) 4-Oxopentanal

(v) Di-sec-butyl ketone

(vi) 4-Fluoroacetophenone

Why are pentahalides more covalent than trihalides?

Silver atom has completely filled d orbitals (4d10) in its ground state. How can you say that it is a transition element?

Glucose or sucrose are soluble in water but cyclohexane or benzene (simple six membered ring compounds) are insoluble in water. Explain.

Write structures of the following compounds:

(i) 2-Chloro-3-methylpentane

(ii) 1-Chloro-4-ethylcyclohexane

(iii) 4-tert. Butyl-3-iodoheptane

(iv) 1,4-Dibromobut-2-ene

(v) 1-Bromo-4-sec. butyl-2-methylbenzene

What happens when H₃PO₃ is heated?

Define the term solution. How many types of solutions are formed? Write briefly about each type with an example.

Which acid of each pair shown here would you expect to be stronger?

(i) CH₃CO₂H or CH₂FCO₂H

(ii)CH₂FCO₂H or CH₂ClCO₂H

(iii) CH₂FCH₂CH₂CO₂H or CH₃CHFCH₂CO₂H

(iv)

In what way is the electronic configuration of the transition elements different from that of the non-transition elements?

Determine the osmotic pressure of a solution prepared by dissolving 25 mg of K₂SO₄ in 2 liter of water at 25° C, assuming that it is completely dissociated.

What are the different types of RNA found in the cell?

Calculate the mass percentage of benzene (C₆H₆) and carbon tetrachloride (CCl₄) if 22 g of benzene is dissolved in 122 g of carbon tetrachloride.

Calculate the efficiency of packing in case of a metal crystal for

(i) simple cubic

(ii) body-centred cubic

(iii) face-centred cubic (with the assumptions that atoms are touching each other).

Arrange each set of compounds in order of increasing boiling points.

(i) Bromomethane, Bromoform, Chloromethane, Dibromomethane.

(ii) 1-Chloropropane, Isopropyl chloride, 1-Chlorobutane.

Why are halogens strong oxidising agents?