Class 12 Chemistry - Chapter Biomolecules NCERT Solutions | Why cannot vitamin C be stored in our bo

What happens when D-glucose is treated with the following reagents? (i)HI (ii)Bromine water (iii)HNO₃

How do you explain the absence of aldehyde group in the pentaacetate of D-glucose?

Glucose or sucrose are soluble in water but cyclohexane or benzene (simple six membered ring compounds) are insoluble in water. Explain.

The melting points and solubility in water of amino acids are generally higher than that of the corresponding halo acids. Explain.

Define the following as related to proteins 

(i) Peptide linkage  (ii) Primary structure  (iii) Denaturation.

What products would be formed when a nucleotide from DNA containing thymine is hydrolysed?

The two strands in DNA are not identical but are complementary. Explain.

What are nucleic acids? Mention their two important functions.

Enumerate the reactions of D-glucose which cannot be explained by its open chain structure.

Where does the water present in the egg go after boiling the egg?

For the reaction R → P, the concentration of a reactant changes from 0.03 M to 0.02 M in 25 minutes. Calculate the average rate of reaction using units of time both in minutes and seconds.

Write the formulas for the following coordination compounds:

(i) Tetraamminediaquacobalt (III) chloride

(ii) Potassium tetracyanonickelate(II)

(iii) Tris(ethane-1,2-diamine) chromium(III) chloride

(iv) Amminebromidochloridonitrito-N-platinate(II)

(v) Dichloridobis(ethane-1,2-diamine)platinum(IV) nitrate

(vi) Iron(III) hexacyanoferrate(II)

(i) Write structures of different isomeric amines corresponding to the molecular formula, C4H11N

(ii) Write IUPAC names of all the isomers.

(iii) What type of isomerism is exhibited by different pairs of amines?

Why are solids rigid?

Write any two characteristics of Chemisorption.

Write the structures of the following compounds.

(i) α-Methoxypropionaldehyde

(ii) 3-Hydroxybutanal

(iii) 2-Hydroxycyclopentane carbaldehyde

(iv) 4-Oxopentanal

(v) Di-sec-butyl ketone

(vi) 4-Fluoroacetophenone

Which of the ores mentioned in Table 6.1 can be concentrated by magnetic separation method?

Why are pentahalides more covalent than trihalides?

Silver atom has completely filled d orbitals (4d10) in its ground state. How can you say that it is a transition element?

Write structures of the following compounds:

(i) 2-Chloro-3-methylpentane

(ii) 1-Chloro-4-ethylcyclohexane

(iii) 4-tert. Butyl-3-iodoheptane

(iv) 1,4-Dibromobut-2-ene

(v) 1-Bromo-4-sec. butyl-2-methylbenzene

The depression in freezing point of water observed for the same amount of acetic acid, trichloroacetic acid and trifluoroacetic acid increases in the order given above. Explain briefly.

How will you prepare the following compounds from benzene? You may use any inorganic reagent and any organic reagent having not more than one carbon atom

(i) Methyl benzoate             (ii) m-Nitrobenzoic acid

(iii) p-Nitrobenzoic acid        (iv) Phenylacetic acid

(v) p-Nitrobenzaldehyde.

In the series Sc (Z = 21) to Zn (Z = 30), the enthalpy of atomization of zinc is the lowest, i.e., 126 kJ mol−1. Why?

Mention the factors that affect the rate of a chemical reaction.

In a reaction between A and B, the initial rate of reaction (r₀) was measured for different initial concentrations of A and B as given below:

What is the order of the reaction with respect to A and B?

Why is zinc not extracted from zinc oxide through reduction using CO?

Why cannot aromatic primary amines be prepared by Gabriel phthalimide synthesis?

Solid A is a very hard electrical insulator in solid as well as in molten state and melts at extremely high temperature. What type of solid is it?

For the decomposition of azoisopropane to hexane and nitrogen at 543 K, the following data are obtained.

Calculate the rate constant

What are the factors which influence the adsorption of a gas on a solid?