Class 12 Chemistry - Chapter Electrochemistry NCERT Solutions | Depict the galvanic cell in which the re

If a current of 0.5 ampere flows through a metallic wire for 2 hours, then how many electrons would flow through the wire?

Calculate the emf of the cell in which the following reaction takes place:

Ni_(s) + 2Ag⁺ (0.002 M) → Ni²⁺ (0.160 M) + 2Ag_(s)

Given that E^ø_cell = 1.05 V

Calculate the standard cell potentials of galvanic cells in which the following reactions take place:

(i) 2Cr(s) + 3Cd²⁺(aq) → 2Cr³⁺(aq) + 3Cd

(ii) Fe²⁺(aq) + Ag+(aq) → Fe³⁺(aq) + Ag(s)

Calculate the ΔrG^ø¸ and equilibrium constant of the reactions.

Write the Nernst equation and emf of the following cells at 298 K:

(i) Mg(s) | Mg²⁺(0.001M) || Cu²⁺(0.0001 M) | Cu(s)

(ii) Fe(s) | Fe²⁺(0.001M) || H⁺(1M)|H₂(g)(1bar) | Pt(s)

(iii) Sn(s) | Sn²⁺(0.050 M) || H⁺(0.020 M) | H₂(g) (1 bar) | Pt(s)

(iv) Pt(s) | Br₂(l) | Br^-(0.010 M) || H⁺(0.030 M) | H₂(g) (1 bar) | Pt(s).

Define conductivity and molar conductivity for the solution of an electrolyte. Discuss their variation with concentration.

How would you determine the standard electrode potential of the system Mg²⁺ | Mg?

Predict the products of electrolysis in each of the following:

(i) An aqueous solution of AgNO₃ with silver electrodes.

(ii) An aqueous solution of AgNO₃with platinum electrodes.

(iii) A dilute solution of H₂SO₄with platinum electrodes.

(iv) An aqueous solution of CuCl₂ with platinum electrodes.

A solution of Ni(NO₃)₂ is electrolysed between platinum electrodes using a current of 5 amperes for 20 minutes. What mass of Ni is deposited at the cathode?

The resistance of a conductivity cell containing 0.001M KCl solution at 298 K is 1500 Ω. What is the cell constant if conductivity of 0.001M KCl solution at 298 K is 0.146 x 10^-3 S cm^-1.

Conductivity of 0.00241 M acetic acid is 7.896 × 10 ^{- 5} S cm ^{- 1}. Calculate its molar conductivity and if A_m^º for acetic acid is 390.5 S cm² mol ^{- 1}, what is its dissociation constant?

For the reaction R → P, the concentration of a reactant changes from 0.03 M to 0.02 M in 25 minutes. Calculate the average rate of reaction using units of time both in minutes and seconds.

Write the formulas for the following coordination compounds:

(i) Tetraamminediaquacobalt (III) chloride

(ii) Potassium tetracyanonickelate(II)

(iii) Tris(ethane-1,2-diamine) chromium(III) chloride

(iv) Amminebromidochloridonitrito-N-platinate(II)

(v) Dichloridobis(ethane-1,2-diamine)platinum(IV) nitrate

(vi) Iron(III) hexacyanoferrate(II)

(i) Write structures of different isomeric amines corresponding to the molecular formula, C4H11N

(ii) Write IUPAC names of all the isomers.

(iii) What type of isomerism is exhibited by different pairs of amines?

Why are solids rigid?

Write any two characteristics of Chemisorption.

Write the structures of the following compounds.

(i) α-Methoxypropionaldehyde

(ii) 3-Hydroxybutanal

(iii) 2-Hydroxycyclopentane carbaldehyde

(iv) 4-Oxopentanal

(v) Di-sec-butyl ketone

(vi) 4-Fluoroacetophenone

Which of the ores mentioned in Table 6.1 can be concentrated by magnetic separation method?

Why are pentahalides more covalent than trihalides?

Silver atom has completely filled d orbitals (4d10) in its ground state. How can you say that it is a transition element?

Glucose or sucrose are soluble in water but cyclohexane or benzene (simple six membered ring compounds) are insoluble in water. Explain.

What is the two dimensional coordination number of a molecule in square close packed layer?

Boiling point of water at 750 mm Hg is 99.63°C. How much sucrose is to be added to 500 g of water such that it boils at 100°C.Molal elevation constant for water is 0.52 K kg mol^-1.

An antifreeze solution is prepared from 222.6 g of ethylene glycol (C₂H₆O₂) and 200 g of water. Calculate the molality of the solution. If the density of the solution is 1.072 g mL^-1, then what shall be the molarity of the solution?

Predict the products formed when cyclohexanecarbaldehyde reacts with following reagents.

(i) PhMgBr and then H₃O⁺

(ii)Tollens' reagent

(iii) Semicarbazide and weak acid

(iv)Excess ethanol and acid

(v) Zinc amalgam and dilute hydrochloric acid

Use Hund's rule to derive the electronic configuration of Ce³⁺ ion and calculate its magnetic moment on the basis of 'spin-only' formula.

Specify the oxidation numbers of the metals in the following coordination entities:

(i) [Co(H₂O)(CN)(en)₂]²⁺

(ii) [CoBr₂(en)₂]⁺

(iii) [PtCl₄]^2-

(iv) K₃[Fe(CN)₆]

(v) [Cr(NH₃)₃Cl₃]

What is demulsification? Name two demulsifiers.

(i) What is meant by the term 'coordination number'?

(ii) What is the coordination number of atoms:

(a) in a cubic close-packed structure?

(b) in a body-centred cubic structure?

In terms of band theory, what is the difference

(i) Between a conductor and an insulator

(ii) Between a conductor and a semiconductor

How the following conversions can be carried out?

(i) Propene to propan-1-ol

(ii) Ethanol to but-1-yne

(iii) 1-Bromopropane to 2-bromopropane

(iv) Toluene to benzyl alcohol

(v) Benzene to 4-bromonitrobenzene

(vi) Benzyl alcohol to 2-phenylethanoic acid

(vii) Ethanol to propanenitrile

(viii) Aniline to chlorobenzene

(ix) 2-Chlorobutane to 3, 4-dimethylhexane

(x) 2-Methyl-1-propene to 2-chloro-2-methylpropane

(xi) Ethyl chloride to propanoic acid

(xii) But-1-ene to n-butyliodide

(xiii) 2-Chloropropane to 1-propanol

(xiv) Isopropyl alcohol to iodoform

(xv) Chlorobenzene to p-nitrophenol

(xvi) 2-Bromopropane to 1-bromopropane

(xvii) Chloroethane to butane

(xviii) Benzene to diphenyl

(xix) tert-Butyl bromide to isobutyl bromide

(xx) Aniline to phenylisocyanide