Class 12 Chemistry - Chapter Polymers NCERT Solutions | Define thermoplastics and thermosetting

Write the names and structures of the monomers of the following polymers:

(i) Buna-S  (ii) Buna-N

(iii) Dacron  (iv) Neoprene

What is a biodegradable polymer? Give an example of a biodegradable aliphatic polyester.

Arrange the following polymers in increasing order of their intermolecular forces.
(i) Nylon 6, 6, Buna-S, Polythene.
(ii) Nylon 6, Neoprene, Polyvinyl chloride.

Explain the difference between Buna-N and Buna-S.

How are polymers classified on the basis of structure?

Explain the term copolymerisation and give two examples.

Write the monomers used for getting the following polymers. (i) Polyvinyl chloride (ii) Teflon (iii) Bakelite

How do you explain the functionality of a monomer?

Identify the monomer in the following polymeric structures.

(i)

(ii)

What are the monomeric repeating units of Nylon-6 and Nylon-6, 6?

For the reaction R → P, the concentration of a reactant changes from 0.03 M to 0.02 M in 25 minutes. Calculate the average rate of reaction using units of time both in minutes and seconds.

Write the formulas for the following coordination compounds:

(i) Tetraamminediaquacobalt (III) chloride

(ii) Potassium tetracyanonickelate(II)

(iii) Tris(ethane-1,2-diamine) chromium(III) chloride

(iv) Amminebromidochloridonitrito-N-platinate(II)

(v) Dichloridobis(ethane-1,2-diamine)platinum(IV) nitrate

(vi) Iron(III) hexacyanoferrate(II)

(i) Write structures of different isomeric amines corresponding to the molecular formula, C4H11N

(ii) Write IUPAC names of all the isomers.

(iii) What type of isomerism is exhibited by different pairs of amines?

Why are solids rigid?

Write any two characteristics of Chemisorption.

Write the structures of the following compounds.

(i) α-Methoxypropionaldehyde

(ii) 3-Hydroxybutanal

(iii) 2-Hydroxycyclopentane carbaldehyde

(iv) 4-Oxopentanal

(v) Di-sec-butyl ketone

(vi) 4-Fluoroacetophenone

Which of the ores mentioned in Table 6.1 can be concentrated by magnetic separation method?

Why are pentahalides more covalent than trihalides?

Silver atom has completely filled d orbitals (4d10) in its ground state. How can you say that it is a transition element?

Glucose or sucrose are soluble in water but cyclohexane or benzene (simple six membered ring compounds) are insoluble in water. Explain.

Bond angle in PH⁺₄ is higher than that in PH₃. Why?

What makes a glass different from a solid such as quartz? Under what conditions could quartz be converted into glass?

Calculate the mass percentage of aspirin (C₉H₈O₄) in acetonitrile (CH₃CN) when 6.5 g of C₉H₈O₄ is dissolved in 450 g of acetonitrile (CH₃CN).

Describe the preparation of potassium dichromate from iron chromite ore. What is the effect of increasing pH on a solution of potassium dichromate?

The E^θ(M²⁺/M) value for copper is positive (+0.34V). What is possibly the reason for this? (Hint: consider its high Δ_aHV and low Δ_hydHV)

Write chemical reactions taking place in the extraction of zinc from zinc blende.

How are the following conversions carried out?

(i) Propene → Propan-2-ol

(ii) Benzyl chloride → Benzyl alcohol

(iii) Ethyl magnesium chloride → Propan-1-ol.

(iv) Methyl magnesium bromide → 2-Methylpropan-2-ol.

Justify the placement of O, S, Se, Te and Po in the same group of the periodic table in terms of electronic configuration, oxidation state and hydride formation.

Give the equations of reactions for the preparation of phenol from cumene.

The reaction,

      Cr₂O₃  +  2Al    →    Al₂O₃  + 2Cr            (ΔG_o = -421kJ)

is thermodynamically feasible as is apparent from the Gibbs energy value. Why does it not take place at room temperature?