Class 12 Chemistry - Chapter Solutions NCERT Solutions | At 300 K, 36 g of glucose present in a l

A 5% solution (by mass) of cane sugar in water has freezing point of 271 K. Calculate the freezing point of 5% glucose in water if freezing point of pure water is 273.15 K.

A solution of glucose in water is labelled as 10% w/w, what would be the molality and mole fraction of each component in the solution? If the density of solution is 1.2 g mL^-1, then what shall be the molarity of the solution?

Henry's law constant for CO₂ in water is 1.67 x 10⁸Pa at 298 K. Calculate the quantity of CO₂in 500 mL of soda water when packed under 2.5 atm CO₂ pressure at 298 K.

Calculate the mass of a non-volatile solute (molar mass 40 g mol^-1) which should be dissolved in 114 g octane to reduce its vapour pressure to 80%.

The vapour pressure of pure liquids A and B are 450 and 700 mm Hg respectively, at 350 K. Find out the composition of the liquid mixture if total vapour pressure is 600 mm Hg. Also find the composition of the vapour phase.

Calculate the mole fraction of benzene in solution containing 30% by mass in carbon tetrachloride.

How many mL of 0.1 M HCl are required to react completely with 1 g mixture of Na₂CO₃ and NaHCO₃ containing equimolar amounts of both?

H₂S, a toxic gas with rotten egg like smell, is used for the qualitative analysis. If the solubility of H₂S in water at STP is 0.195 m, calculate Henry's law constant.

Boiling point of water at 750 mm Hg is 99.63°C. How much sucrose is to be added to 500 g of water such that it boils at 100°C.Molal elevation constant for water is 0.52 K kg mol^-1.

An aqueous solution of 2% non-volatile solute exerts a pressure of 1.004 bar at the normal boiling point of the solvent. What is the molar mass of the solute?

For the reaction R → P, the concentration of a reactant changes from 0.03 M to 0.02 M in 25 minutes. Calculate the average rate of reaction using units of time both in minutes and seconds.

Write the formulas for the following coordination compounds:

(i) Tetraamminediaquacobalt (III) chloride

(ii) Potassium tetracyanonickelate(II)

(iii) Tris(ethane-1,2-diamine) chromium(III) chloride

(iv) Amminebromidochloridonitrito-N-platinate(II)

(v) Dichloridobis(ethane-1,2-diamine)platinum(IV) nitrate

(vi) Iron(III) hexacyanoferrate(II)

(i) Write structures of different isomeric amines corresponding to the molecular formula, C4H11N

(ii) Write IUPAC names of all the isomers.

(iii) What type of isomerism is exhibited by different pairs of amines?

Why are solids rigid?

Write any two characteristics of Chemisorption.

Write the structures of the following compounds.

(i) α-Methoxypropionaldehyde

(ii) 3-Hydroxybutanal

(iii) 2-Hydroxycyclopentane carbaldehyde

(iv) 4-Oxopentanal

(v) Di-sec-butyl ketone

(vi) 4-Fluoroacetophenone

Which of the ores mentioned in Table 6.1 can be concentrated by magnetic separation method?

Why are pentahalides more covalent than trihalides?

Silver atom has completely filled d orbitals (4d10) in its ground state. How can you say that it is a transition element?

Glucose or sucrose are soluble in water but cyclohexane or benzene (simple six membered ring compounds) are insoluble in water. Explain.

Low level of noradrenaline is the cause of depression. What type of drugs are needed to cure this problem ? Name two drugs.

Describe a method for refining nickel.

Discuss the main purpose of vulcanisation of rubber.

Complete the following acid-base reactions and name the products:

(i) CH₃CH₂CH₂NH₂ + HCl →

(ii) (C₂H₅)₃N + HCl →

Write balanced equations for the following:

(i) NaCl is heated with sulphuric acid in the presence of MnO₂.

(ii) Chlorine gas is passed into a solution of NaI in water.

Describe some features of catalysis by zeolites.

Write the name and structure of one of the common initiators used in free radical addition polymerisation.

Arrange the following:

(i) In decreasing order of the pK_bvalues:

C₂H₅NH₂, C₆H₅NHCH₃, (C₂H₅)₂NH and C₆H₅NH₂

(ii) In increasing order of basic strength:

C₆H₅NH₂, C₆H₅N(CH₃)₂, (C₂H₅)₂NH and CH₃NH₂

(iii) In increasing order of basic strength:

(a) Aniline, p-nitroaniline and p-toluidine

(b) C₆H₅NH₂, C₆H₅NHCH₃, C₆H₅CH₂NH₂.

(iv) In decreasing order of basic strength in gas phase:

C₂H₅NH₂, (C₂H₅)₂NH, (C₂H₅)₃N and NH₃

(v) In increasing order of boiling point:

C₂H₅OH, (CH₃)₂NH, C₂H₅NH₂

(vi) In increasing order of solubility in water:

C₆H₅NH₂, (C₂H₅)₂NH, C₂H₅NH₂.

How are colloids classified on the basis of

(i) Physical states of components

(ii) Nature of dispersion medium and

(iii) Interaction between dispersed phase and dispersion medium?

Name the oxometal anions of the first series of the transition metals in which the metal exhibits the oxidation state equal to its group number.