Write the name and structure of one of the common initiators used in free radical addition polymerisation.
For polymerization reaction, an initiator is required. The initiator may be an cation, anion or free radical. So the type of polymerization in which free radical is used as an initiator is known as free radical addition polymerization. The common free radical initiator used is benzoyl chloride.
The structure of benzoyl chloride is as follows:
Write the names and structures of the monomers of the following polymers:
(i) Buna-S (ii) Buna-N
(iii) Dacron (iv) Neoprene
What is a biodegradable polymer? Give an example of a biodegradable aliphatic polyester.
Arrange the following polymers in increasing order of their intermolecular forces.
(i) Nylon 6, 6, Buna-S, Polythene.
(ii) Nylon 6, Neoprene, Polyvinyl chloride.
Explain the difference between Buna-N and Buna-S.
How are polymers classified on the basis of structure?
Define thermoplastics and thermosetting polymers with two examples of each.
Explain the term copolymerisation and give two examples.
Write the monomers used for getting the following polymers. (i) Polyvinyl chloride (ii) Teflon (iii) Bakelite
How do you explain the functionality of a monomer?
Identify the monomer in the following polymeric structures.
(i)
(ii)
For the reaction R → P, the concentration of a reactant changes from 0.03 M to 0.02 M in 25 minutes. Calculate the average rate of reaction using units of time both in minutes and seconds.
Write the formulas for the following coordination compounds:
(i) Tetraamminediaquacobalt (III) chloride
(ii) Potassium tetracyanonickelate(II)
(iii) Tris(ethane-1,2-diamine) chromium(III) chloride
(iv) Amminebromidochloridonitrito-N-platinate(II)
(v) Dichloridobis(ethane-1,2-diamine)platinum(IV) nitrate
(vi) Iron(III) hexacyanoferrate(II)
(i) Write structures of different isomeric amines corresponding to the molecular formula, C4H11N
(ii) Write IUPAC names of all the isomers.
(iii) What type of isomerism is exhibited by different pairs of amines?
Why are solids rigid?
Write any two characteristics of Chemisorption.
Write the structures of the following compounds.
(i) α-Methoxypropionaldehyde
(ii) 3-Hydroxybutanal
(iii) 2-Hydroxycyclopentane carbaldehyde
(iv) 4-Oxopentanal
(v) Di-sec-butyl ketone
(vi) 4-Fluoroacetophenone
Which of the ores mentioned in Table 6.1 can be concentrated by magnetic separation method?
Why are pentahalides more covalent than trihalides?
Silver atom has completely filled d orbitals (4d10) in its ground state. How can you say that it is a transition element?
Glucose or sucrose are soluble in water but cyclohexane or benzene (simple six membered ring compounds) are insoluble in water. Explain.
Which of the following compounds would undergo aldol condensation, which the Cannizzaro reaction and which neither? Write the structures of the expected products of aldol condensation and Cannizzaro reaction.
(i) Methanal (ii) 2-Methylpentanal
(iii) Benzaldehyde (iv) Benzophenone
(v) Cyclohexanone (vi) 1-Phenylpropanone
(vii) Phenylacetaldehyde (viii) Butan-1-ol
(ix) 2, 2-Dimethylbutanal
Write two uses of ClO2.
Why are halogens coloured?
Write the reactions of F2 and Cl2 with water.
How can you prepare Cl2 from HCl and HCl from Cl2? Write reactions only.
What inspired N. Bartlett for carrying out reaction between Xe and PtF6?
What are the oxidation states of phosphorus in the following:
(i) H3PO3
(ii) PCl3
(iii) Ca3P2
(iv) Na3PO4
(v) POF3?
Write balanced equations for the following:
(i) NaCl is heated with sulphuric acid in the presence of MnO2.
(ii) Chlorine gas is passed into a solution of NaI in water.
How are xenon fluorides XeF2, XeF4 and XeF6 obtained?
With what neutral molecule is ClO- isoelectronic? Is that molecule a Lewis base?
This is very helpful for us
This structure is Benozoyl peroxide
That is the structure of benzoic peroxide
I think it is a structure of benzyl peroxide not benzyl chloride
But why only benzoyl peroxide is used??
Isn't this the structure of Benzoyl Peroxide?
Helpful. ..