Class 12 Chemistry - Chapter Coordination Compounds NCERT Solutions | Write the IUPAC names of the following c

[NiCl₄]^2- is paramagnetic while [Ni(CO)₄] is diamagnetic though both are tetrahedral. Why?

Explain on the basis of valence bond theory that [Ni(CN)₄]^2- ion with square planar structure is diamagnetic and the [Ni(CN)₄]^2- ion with tetrahedral geometry is paramagnetic.

Draw figure to show the splitting of d orbitals in an octahedral crystal field.

Write down the IUPAC name for each of the following complexes and indicate the oxidation state, electronic configuration and coordination number. Also give stereochemistry and magnetic moment of the complex:

(i) K[Cr(H₂O)₂(C₂O₄)₂].3H₂O

(ii) [Co(NH₃)₅Cl]Cl₂

(iii) CrCl₃(py)₃

(iv) Cs[FeCl₄]

(v) K₄[Mn(CN)₆]

The oxidation number of cobalt in K[Co(CO)₄] is

(i) +1

(ii) +3

(iii) -1

(iv) -3

[Cr(NH₃)₆]³⁺ is paramagnetic while [Ni(CN)₄]^2- is diamagnetic.  Explain why?

Discuss the nature of bonding in metal carbonyls.

Discuss the nature of bonding in the following coordination entities on the basis of valence bond theory:

(i) [Fe(CN)₆]^4-

(ii) [FeF₆]^3-

(iii) [Co(C₂O₄)3]^3-

(iv) [CoF₆]^3-

Write the formulas for the following coordination compounds:

(i) Tetraamminediaquacobalt (III) chloride

(ii) Potassium tetracyanonickelate(II)

(iii) Tris(ethane-1,2-diamine) chromium(III) chloride

(iv) Amminebromidochloridonitrito-N-platinate(II)

(v) Dichloridobis(ethane-1,2-diamine)platinum(IV) nitrate

(vi) Iron(III) hexacyanoferrate(II)

Predict the number of unpaired electrons in the square planar [Pt(CN)₄]^2- ion.

For the reaction R → P, the concentration of a reactant changes from 0.03 M to 0.02 M in 25 minutes. Calculate the average rate of reaction using units of time both in minutes and seconds.

(i) Write structures of different isomeric amines corresponding to the molecular formula, C4H11N

(ii) Write IUPAC names of all the isomers.

(iii) What type of isomerism is exhibited by different pairs of amines?

Why are solids rigid?

Write any two characteristics of Chemisorption.

Write the structures of the following compounds.

(i) α-Methoxypropionaldehyde

(ii) 3-Hydroxybutanal

(iii) 2-Hydroxycyclopentane carbaldehyde

(iv) 4-Oxopentanal

(v) Di-sec-butyl ketone

(vi) 4-Fluoroacetophenone

Which of the ores mentioned in Table 6.1 can be concentrated by magnetic separation method?

Why are pentahalides more covalent than trihalides?

Silver atom has completely filled d orbitals (4d10) in its ground state. How can you say that it is a transition element?

Glucose or sucrose are soluble in water but cyclohexane or benzene (simple six membered ring compounds) are insoluble in water. Explain.

Write structures of the following compounds:

(i) 2-Chloro-3-methylpentane

(ii) 1-Chloro-4-ethylcyclohexane

(iii) 4-tert. Butyl-3-iodoheptane

(iv) 1,4-Dibromobut-2-ene

(v) 1-Bromo-4-sec. butyl-2-methylbenzene

Vapour pressure of water at 293 Kis 17.535 mm Hg. Calculate the vapour pressure of water at 293 Kwhen 25 g of glucose is dissolved in 450 g of water.

19.5 g of CH₂FCOOH is dissolved in 500 g of water. The depression in the freezing point of water observed is 1.0°C. Calculate the van't Hoff factor and dissociation constant of fluoroacetic acid.

The experimental data for decomposition of N₂O₅

[2N₂O₅ → 4NO₂ + O₂]

in gas phase at 318K are given below:

(i) Plot [N₂O₅] against t.

(ii) Find the half-life period for the reaction.

(iii) Draw a graph between log[N₂O₅] and t.

(iv) What is the rate law ?

(v) Calculate the rate constant.

(vi) Calculate the half-life period from k and compare it with (ii).

A solution containing 30 g of non-volatile solute exactly in 90 g of water has a vapour pressure of 2.8 kPa at 298 K. Further, 18 g of water is then added to the solution and the new vapour pressure becomes 2.9 kPa at 298 K. Calculate:

1) Molar mass of the solute

2) Vapour pressure of water at 298 K.

Calculate the osmotic pressure in pascals exerted by a solution prepared by dissolving 1.0 g of polymer of molar mass 185,000 in 450 mL of water at 37°C.

Boiling point of water at 750 mm Hg is 99.63°C. How much sucrose is to be added to 500 g of water such that it boils at 100°C.Molal elevation constant for water is 0.52 K kg mol^-1.

Ionic solids conduct electricity in molten state but not in solid state. Explain.

Write the mechanism of hydration of ethene to yield ethanol.

Write the chemistry of recharging the lead storage battery, highlighting all the materials that are involved during recharging.

Determine the osmotic pressure of a solution prepared by dissolving 25 mg of K₂SO₄ in 2 liter of water at 25° C, assuming that it is completely dissociated.