Class 11 Physics - Chapter Unit and measurment NCERT Solutions | The Sun is a hot plasma (ionized matter)

State the number of significant figures in the following:

(a) 0.007 m²

(b) 2.64 x 10²⁴ kg

(c) 0.2370 g cm^-3

(d) 6.320 J

(e) 6.032 N m^-2

(f) 0.0006032 m²

Fill in the blanks by suitable conversion of units:

(a) 1 kg m²s^–2= ....g cm² s^–2

(b) 1 m =..... ly

(c) 3.0 m s^–2=.... km h^–2

(d) G = 6.67 × 10^–11 N m² (kg)^–2=.... (cm)3s^–2 g^–1.

A physical quantity P is related to four observables a, b, c and d as follows :

The percentage errors of measurement in a, b, c and d are 1%, 3%, 4% and 2%, respectively. What is the percentage error in the quantity P ? If the value of P calculated using the above relation turns out to be 3.763, to what value should you round off the result ?

The mass of a box measured by a grocer's balance is 2.300 kg. Two gold pieces of masses 20.15 g and 20.17 g are added to the box. What is

(a) the total mass of the box,

(b) the difference in the masses of the pieces to correct significant figures?

When the planet Jupiter is at a distance of 824.7 million kilometers from the Earth, its angular diameter is measured to be 35.72" of arc. Calculate the diameter of Jupiter.

The photograph of a house occupies an area of 1.75 cm² on a 35 mm slide. The slide is projected on to a screen, and the area of the house on the screen is 1.55 m². What is the linear magnification of the projector-screen arrangement?

It is a well known fact that during a total solar eclipse the disk of the moon almost completely covers the disk of the Sun. From this fact and from the information you can gather from examples 2.3 and 2.4, determine the approximate diameter of the moon.

Fill in the blanks

(a) The volume of a cube of side 1 cm is equal to.....m³

(b) The surface area of a solid cylinder of radius 2.0 cm and height 10.0 cm is equal to ... (mm)²

(c) A vehicle moving with a speed of 18 km h^–1covers....m in 1 s

(d) The relative density of lead is 11.3. Its density is ....g cm^–3 or . ...kg m^–3.

Explain this common observation clearly : If you look out of the window of a fast moving train, the nearby trees, houses etc. seem to move rapidly in a direction opposite to the train's motion, but the distant objects (hill tops, the Moon, the stars etc.) seem to be stationary. (In fact, since you are aware that you are moving, these distant objects seem to move with you).

Some of the most profound statements on the nature of science have come from Albert Einstein, one of the greatest scientists of all time. What do you think did Einstein mean when he said : “The most incomprehensible thing about the world is that it is comprehensible”?

The sign of work done by a force on a body is important to understand. State carefully if the following quantities are positive or negative:

(a) work done by a man in lifting a bucket out of a well by means of a rope tied to the bucket.

(b) work done by gravitational force in the above case,

(c) work done by friction on a body sliding down an inclined plane,

(d) work done by an applied force on a body moving on a rough horizontal plane with uniform velocity,

(e) work done by the resistive force of air on a vibrating pendulum in bringing it to rest.

A geyser heats water flowing at the rate of 3.0 litres per minute from 27 °C to 77 °C. If the geyser operates on a gas burner, what is the rate of consumption of the fuel if its heat of combustion is 4.0 x 10⁴ J/g?

Estimate the fraction of molecular volume to the actual volume occupied by oxygen gas at STP. Take the diameter of an oxygen molecule to be 3Å.

Establish the following vector inequalities geometrically or otherwise:

(a) |a + b| ≤ |a| + |b|

(b) |a + b| ≥ ||a| − |b||

(c) |a − b| ≤ |a| + |b|

(d) |a − b| ≥ ||a| − |b||

When does the equality sign above apply?

A bullet of mass 0.012 kg and horizontal speed 70 ms^-1strikes a block of wood of mass 0.4 kg and instantly comes to rest with respect to the block. The block is suspended from the ceiling by means of thin wires. Calculate the height to which the block rises. Also, estimate the amount of heat produced in the block.

A pipe 20 cm long is closed at one end. Which harmonic mode of the pipe is resonantly excited by a 430 Hz source? Will the same source be in resonance with the pipe if both ends are open? (Speed of sound in air is 340 m s^-1).

A wire stretched between two rigid supports vibrates in its fundamental mode with a frequency of 45 Hz. The mass of the wire is 3.5 x 10^-2 kg and its linear mass density is 4.0 x 10^-2 kg m^-1. What is

(a) the speed of a transverse wave on the string, and

(b) the tension in the string?

Two trains A and B of length 400 m each are moving on two parallel tracks with a uniform speed of 72 km h^–1 in the same direction, with A ahead of B. The driver of B decides to overtake A and accelerates by 1 m/s². If after 50 s, the guard of B just brushes past the driver of A, what was the original distance between them?

Suggest a suitable physical situation for each of the following graphs (Fig 3.22):

(a)

(Figure 3.22)

Figure 3.21 shows the x-t plot of one-dimensional motion of a particle. Is it correct to say from the graph that the particle moves in a straight line for t < 0 and on a parabolic path for t > 0? If not, suggest a suitable physical context for this graph.

A three-wheeler starts from rest, accelerates uniformly with 1 m s^–2 on a straight road for 10 s, and then moves with uniform velocity. Plot the distance covered by the vehicle during the nth second (n = 1,2,3….) versus n. What do you expect this plot to be during accelerated motion: a straight line or a parabola?

Ten one-rupee coins are put on top of each other on a table. Each coin has a mass m. Give the magnitude and direction of

(a) the force on the 7^th coin (counted from the bottom) due to all the coins on its top,

(b) the force on the 7^th coin by the eighth coin,

(c) the reaction of the 6^th coin on the 7^th coin.

The sign of work done by a force on a body is important to understand. State carefully if the following quantities are positive or negative:

(a) work done by a man in lifting a bucket out of a well by means of a rope tied to the bucket.

(b) work done by gravitational force in the above case,

(c) work done by friction on a body sliding down an inclined plane,

(d) work done by an applied force on a body moving on a rough horizontal plane with uniform velocity,

(e) work done by the resistive force of air on a vibrating pendulum in bringing it to rest.