Class 12 Chemistry - Chapter Polymers NCERT Solutions | Define the term polymerisation.

Write the names and structures of the monomers of the following polymers:

(i) Buna-S  (ii) Buna-N

(iii) Dacron  (iv) Neoprene

What is a biodegradable polymer? Give an example of a biodegradable aliphatic polyester.

Arrange the following polymers in increasing order of their intermolecular forces.
(i) Nylon 6, 6, Buna-S, Polythene.
(ii) Nylon 6, Neoprene, Polyvinyl chloride.

Explain the difference between Buna-N and Buna-S.

How are polymers classified on the basis of structure?

Define thermoplastics and thermosetting polymers with two examples of each.

Explain the term copolymerisation and give two examples.

Write the monomers used for getting the following polymers. (i) Polyvinyl chloride (ii) Teflon (iii) Bakelite

How do you explain the functionality of a monomer?

Identify the monomer in the following polymeric structures.

(i)

(ii)

For the reaction R → P, the concentration of a reactant changes from 0.03 M to 0.02 M in 25 minutes. Calculate the average rate of reaction using units of time both in minutes and seconds.

Write the formulas for the following coordination compounds:

(i) Tetraamminediaquacobalt (III) chloride

(ii) Potassium tetracyanonickelate(II)

(iii) Tris(ethane-1,2-diamine) chromium(III) chloride

(iv) Amminebromidochloridonitrito-N-platinate(II)

(v) Dichloridobis(ethane-1,2-diamine)platinum(IV) nitrate

(vi) Iron(III) hexacyanoferrate(II)

(i) Write structures of different isomeric amines corresponding to the molecular formula, C4H11N

(ii) Write IUPAC names of all the isomers.

(iii) What type of isomerism is exhibited by different pairs of amines?

Why are solids rigid?

Write any two characteristics of Chemisorption.

Write the structures of the following compounds.

(i) α-Methoxypropionaldehyde

(ii) 3-Hydroxybutanal

(iii) 2-Hydroxycyclopentane carbaldehyde

(iv) 4-Oxopentanal

(v) Di-sec-butyl ketone

(vi) 4-Fluoroacetophenone

Which of the ores mentioned in Table 6.1 can be concentrated by magnetic separation method?

Why are pentahalides more covalent than trihalides?

Silver atom has completely filled d orbitals (4d10) in its ground state. How can you say that it is a transition element?

Glucose or sucrose are soluble in water but cyclohexane or benzene (simple six membered ring compounds) are insoluble in water. Explain.

For a first order reaction, show that time required for 99% completion is twice the time required for the completion of 90% of reaction.

Compare the chemistry of the actinoids with that of lanthanoids with reference to:

(i) electronic configuration

(ii) oxidation states and

(iii) chemical reactivity.

Give structures of the products you would expect when each of the following alcohol reacts with (a) HCl-ZnCl₂ (b) HBr and (c) SOCl₂.

(i) Butan-1-ol

(ii) 2-Methylbutan-2-ol

Give four examples of heterogeneous catalysis.

Write IUPAC names of the following compounds and classify them into primary,secondary and tertiary amines.

(i) (CH₃)₂ CHNH₂

(ii) CH₃(CH₂)₂NH₂

(iii) CH₃NHCH(CH₃)₂

(iv) (CH₃)₃CNH₂

(v) C₆H₅NHCH₃

(vi) (CH₃CH₂)₂NCH₃

(vii) m-BrC₆H₄NH₂

What happens when H₃PO₃ is heated?

Is it true that under certain conditions, Mg can reduce SiO₂ and Si can reduce MgO? What are those conditions?

Benzene and toluene form ideal solution over the entire range of composition. The vapour pressure of pure benzene and toluene at 300 K are 50.71 mm Hg and 32.06 mm Hg respectively. Calculate the mole fraction of benzene in vapour phase if 80 g of benzene is mixed with 100 g of toluene.

Why is N2 less reactive at room temperature?

Give two examples to show the anomalous behaviour of fluorine.