Home
NCERT Soltions
Class 12
Chemistry
Electrochemistry
Why does the conductivity of a solution decrease with dilution?

Why does the conductivity of a solution | Class 12 Chemistry Chapter Electrochemistry, Electrochemistry NCERT Solutions

Welcome to the NCERT Solutions for Class 12 Chemistry - Chapter Electrochemistry. This page offers a step-by-step solution to the specific question from Exercise 1, Question 7: . With detailed answers and explanations for each chapter, students can strengthen their understanding and prepare confidently for exams. Ideal for CBSE and other board students, this resource will simplify your study experience.

Question 7:

Why does the conductivity of a solution decrease with dilution?

Answer:

The variation of conductivity with dilution can be explained on the basis of number of ions in solution.

In case of weak electrolyte, the number of ions furnished by an electrolyte in solution depends upon the degree of dissociation with dilution. With the increase in dilution, the degree of dissociation increases, as a result the molar conductance increases.

But for strong electrolyte, there is no increase in the number of ions with dilution because strong electrolytes are completely ionized in solution at all concentrations. However, in concentrated solutions of strong electrolytes there are strong forces of attraction between the ions of opposite charges called Interionic Forces. Due to these interionic forces the conducting ability of the ions is less in concentrated solutions. With dilution, the ions becomes far apart from each other and interionic forces decreases. As a result, molar conductance increases with dilution.

Other Questions of Chapter Electrochemistry

The resistance of a conductivity cell containing 0.001M KCl solution at 298 K is 1500 Ω. What is the cell constant if conductivity of 0.001M KCl solution at 298 K is 0.146 x 10^-3S cm^-1.

Predict the products of electrolysis in each of the following:

(i) An aqueous solution of AgNO₃ with silver electrodes.

(ii) An aqueous solution of AgNO₃with platinum electrodes.

(iii) A dilute solution of H₂SO₄with platinum electrodes.

(iv) An aqueous solution of CuCl₂ with platinum electrodes.

Can you store copper sulphate solutions in a zinc pot?

How much electricity is required in coulomb for the oxidation of

(i) 1 mol of H₂O to O₂.

(ii) 1 mol of FeO to Fe₂O₃.

If a current of 0.5 ampere flows through a metallic wire for 2 hours, then how many electrons would flow through the wire?

A solution of Ni(NO₃)₂ is electrolysed between platinum electrodes using a current of 5 amperes for 20 minutes. What mass of Ni is deposited at the cathode?

Calculate the potential of hydrogen electrode in contact with a solution whose pH is 10.

Arrange the following metals in the order in which they displace each other from the solution of their salts.

Al, Cu, Fe, Mg and Zn

Explain how rusting of iron is envisaged as setting up of an electrochemical cell.

In the button cells widely used in watches and other devices the following reaction takes place:

Zn(s) + Ag₂O(s) + H₂O(l) → Zn²⁺(aq) + 2Ag(s) + 2OH ^- (aq)

Determine and for the reaction.

Popular questions of class 12 Chemistry

How the following conversions can be carried out?

(i) Propene to propan-1-ol

(ii) Ethanol to but-1-yne

(iii) 1-Bromopropane to 2-bromopropane

(iv) Toluene to benzyl alcohol

(v) Benzene to 4-bromonitrobenzene

(vi) Benzyl alcohol to 2-phenylethanoic acid

(vii) Ethanol to propanenitrile

(viii) Aniline to chlorobenzene

(ix) 2-Chlorobutane to 3, 4-dimethylhexane

(x) 2-Methyl-1-propene to 2-chloro-2-methylpropane

(xi) Ethyl chloride to propanoic acid

(xii) But-1-ene to n-butyliodide

(xiii) 2-Chloropropane to 1-propanol

(xiv) Isopropyl alcohol to iodoform

(xv) Chlorobenzene to p-nitrophenol

(xvi) 2-Bromopropane to 1-bromopropane

(xvii) Chloroethane to butane

(xviii) Benzene to diphenyl

(xix) tert-Butyl bromide to isobutyl bromide

(xx) Aniline to phenylisocyanide

Give simple chemical tests to distinguish between the following pairs of compounds.

(i) Propanal and Propanone

(ii) Acetophenone and Benzophenone

(iii) Phenol and Benzoic acid

(iv) Benzoic acid and Ethyl benzoate

(v) Pentan-2-one and Pentan-3-one

(vi) Benzaldehyde and Acetophenone

(vii) Ethanal and Propanal

A 5% solution (by mass) of cane sugar in water has freezing point of 271 K. Calculate the freezing point of 5% glucose in water if freezing point of pure water is 273.15 K.

A solution of glucose in water is labelled as 10% w/w, what would be the molality and mole fraction of each component in the solution? If the density of solution is 1.2 g mL^-1, then what shall be the molarity of the solution?

Henry's law constant for CO₂ in water is 1.67 x 10⁸Pa at 298 K. Calculate the quantity of CO₂in 500 mL of soda water when packed under 2.5 atm CO₂pressure at 298 K.

Calculate the mass of a non-volatile solute (molar mass 40 g mol^-1) which should be dissolved in 114 g octane to reduce its vapour pressure to 80%.

The vapour pressure of pure liquids A and B are 450 and 700 mm Hg respectively, at 350 K. Find out the composition of the liquid mixture if total vapour pressure is 600 mm Hg. Also find the composition of the vapour phase.

Calculate the mole fraction of benzene in solution containing 30% by mass in carbon tetrachloride.

How many mL of 0.1 M HCl are required to react completely with 1 g mixture of Na₂CO₃ and NaHCO₃ containing equimolar amounts of both?

If NaCl is doped with 10^-3mol % of SrCl₂, what is the concentration of cation vacancies?

Recently Viewed Questions of Class 12 Chemistry

Henry's law constant for CO₂ in water is 1.67 x 10⁸Pa at 298 K. Calculate the quantity of CO₂in 500 mL of soda water when packed under 2.5 atm CO₂pressure at 298 K.

What are nucleic acids? Mention their two important functions.

What are the different oxidation states exhibited by the lanthanoids?

The reaction between A and B is first order with respect to A and zero order with respect to B. Fill in the blanks in the following table:

Experiment	A/ mol L^{- 1}	B/ mol L^{- 1}	Initial rate/mol L^{- 1} min^{- 1}
I	0.1	0.1	2.0 × 10^{- 2}
II	--	0.2	4.0 × 10^{- 2}
III	0.4	0.4	--
IV	--	0.2	2.0 × 10^{- 2}

Mention the conditions required to maximise the yield of ammonia.

Ionic solids conduct electricity in molten state but not in solid state. Explain.

Describe the oxidising action of potassium dichromate and write the ionicequations for its reaction with:

(i) iodide

(ii) iron

(II) solution and

(iii) H₂S

What type of solids are electrical conductors, malleable and ductile?

Write the structure of the major organic product in each of the following reactions:

Ferric oxide crystallises in a hexagonal close-packed array of oxide ions with two out of every three octahedral holes occupied by ferric ions. Derive the formula of the ferric oxide.

Study Tips for Answering NCERT Questions:

NCERT questions are designed to test your understanding of the concepts and theories discussed in the chapter. Here are some tips to help you answer NCERT questions effectively:

Read the question carefully and focus on the core concept being asked.
Reference examples and data from the chapter when answering questions about Electrochemistry.
Review previous year question papers to get an idea of how such questions may be framed in exams.
Practice answering questions within the time limit to improve your speed and accuracy.
Discuss your answers with your teachers or peers to get feedback and improve your understanding.

Latest Blog Posts

Stay updated with our latest educational content and study tips

Smart Questions to Ask in a Parent-Teacher Meeting | PTM Made Easy

Parent-Teacher Meetings (PTMs) are more than quick updates on marks — they’re a chance to build a real partnership between home and school. A good Parent-Teacher Meeting conversation helps parents see beyond grades. It opens up insights about a child’s strengths, struggles, emotions and even hidden talents. When parents participate actively, they don’t just track […]

The Secret to Smarter Learning — Building Strong Critical Thinking Skills

In today’s world of endless information , knowing how to think is more important than knowing what to think . From school projects to real – life decisions , critical thinking helps students question ideas , analyze facts and form logical conclusions . But what exactly does critical thinking mean ? Simply put , it’s […]

Study Smarter, Not Harder: Build Productive Habits That Stick

Every student dreams of better grades , stronger focus and more study time – but the real challenge isn’t starting, it’s staying consistent . Building productive study habits is not about studying all day , it’s about studying smart . In today’s fast – paced digital world, distractions are everywhere – from endless phone notifications […]

The Hidden Risks of Online Gaming for Children — Is your child safe while gaming online?

Online gaming has rapidly become one of the most popular pastimes among children. Whether it’s multiplayer mobile games , PC adventures or console challenges , kids are spending more time than ever in the virtual world . On the surface, gaming seems entertaining and even educational – improving hand- eye coordination , teamwork and problem […]

View All Blog Posts

Comments

LAURA JONAS CAMPBELL
Nov 29, 2020

THANKS FOR THE BEST SOLUTIONS...HELPED A LOT :)

Dhriti shamra
Nov 30, 2019

I didnt understand d concept!