Class 12 Chemistry - Chapter Haloalkanes and Haloarenes NCERT Solutions | How the following conversions can be car

Arrange each set of compounds in order of increasing boiling points.

(i) Bromomethane, Bromoform, Chloromethane, Dibromomethane.

(ii) 1-Chloropropane, Isopropyl chloride, 1-Chlorobutane.

What happens when

(i) n-butyl chloride is treated with alcoholic KOH,

(ii) bromobenzene is treated with Mg in the presence of dry ether,

(iii) chlorobenzene is subjected to hydrolysis,

(iv) ethyl chloride is treated with aqueous KOH,

(v) methyl bromide is treated with sodium in the presence of dry ether,

(vi) methyl chloride is treated with KCN.

Among the isomeric alkanes of molecular formula C₅H₁₂, identify the one that on photochemical chlorination yields

(i) A single monochloride.

(ii) Three isomeric monochlorides.

(iii) Four isomeric monochlorides.

Write structures of different dihalogen derivatives of propane.

Arrange the compounds of each set in order of reactivity towards SN2 displacement:

(i) 2-Bromo-2-methylbutane, 1-Bromopentane, 2-Bromopentane

(ii) 1-Bromo-3-methylbutane, 2-Bromo-2-methylbutane, 3-Bromo-2- methylbutane

(iii) 1-Bromobutane, 1-Bromo-2,2-dimethylpropane, 1-Bromo-2-methylbutane, 1-Bromo-3-methylbutane.

The treatment of alkyl chlorides with aqueous KOH leads to the formation of alcohols but in the presence of alcoholic KOH, alkenes are major products. Explain.

Primary alkyl halide C₄H₉Br (a) reacted with alcoholic KOH to give compound (b).Compound (b) is reacted with HBr to give (c) which is an isomer of (a). When (a) is reacted with sodium metal it gives compound (d), C₈H₁₈ which is different from the compound formed when n-butyl bromide is reacted with sodium. Give the structural formula of (a) and write the equations for all the reactions.

Which one of the following has the highest dipole moment?

(i) CH₂Cl₂

(ii) CHCl₃

(iii) CCl₄

Why is sulphuric acid not used during the reaction of alcohols with KI?

In the following pairs of halogen compounds, which compound undergoes faster S_N1 reaction?

For the reaction R → P, the concentration of a reactant changes from 0.03 M to 0.02 M in 25 minutes. Calculate the average rate of reaction using units of time both in minutes and seconds.

Write the formulas for the following coordination compounds:

(i) Tetraamminediaquacobalt (III) chloride

(ii) Potassium tetracyanonickelate(II)

(iii) Tris(ethane-1,2-diamine) chromium(III) chloride

(iv) Amminebromidochloridonitrito-N-platinate(II)

(v) Dichloridobis(ethane-1,2-diamine)platinum(IV) nitrate

(vi) Iron(III) hexacyanoferrate(II)

(i) Write structures of different isomeric amines corresponding to the molecular formula, C4H11N

(ii) Write IUPAC names of all the isomers.

(iii) What type of isomerism is exhibited by different pairs of amines?

Why are solids rigid?

Write any two characteristics of Chemisorption.

Write the structures of the following compounds.

(i) α-Methoxypropionaldehyde

(ii) 3-Hydroxybutanal

(iii) 2-Hydroxycyclopentane carbaldehyde

(iv) 4-Oxopentanal

(v) Di-sec-butyl ketone

(vi) 4-Fluoroacetophenone

Which of the ores mentioned in Table 6.1 can be concentrated by magnetic separation method?

Why are pentahalides more covalent than trihalides?

Silver atom has completely filled d orbitals (4d10) in its ground state. How can you say that it is a transition element?

Glucose or sucrose are soluble in water but cyclohexane or benzene (simple six membered ring compounds) are insoluble in water. Explain.

What is the difference between physisorption and chemisorption?

Conductivity of 0.00241 M acetic acid is 7.896 × 10 ^{- 5} S cm ^{- 1}. Calculate its molar conductivity and if A_m^º for acetic acid is 390.5 S cm² mol ^{- 1}, what is its dissociation constant?

In which classes, the polymers are classified on the basis of molecular forces?

In a pseudo first order hydrolysis of ester in water, the following results were obtained:

(i) Calculate the average rate of reaction between the time interval 30 to 60 seconds.

(ii) Calculate the pseudo first order rate constant for the hydrolysis of ester.

Amongst the following compounds, identify which are insoluble, partially soluble and highly soluble in water?

(i) phenol  (ii) toluene  (iii) formic acid  (iv) ethylene glycol  (v) chloroform  (vi) pentanol.

In a reaction, 2A → Products, the concentration of A decreases from 0.5 mol L^-1 to 0.4 mol L^-1 in 10 minutes. Calculate the rate during this interval?

Why do solids have a definite volume?

Calculate the potential of hydrogen electrode in contact with a solution whose pH is 10.

Analysis shows that nickel oxide has the formula Ni_0.98 O_1.00. What fractions of nickel exist as Ni²⁺and Ni³⁺ions?

The rate of a reaction quadruples when the temperature changes from 293 K to 313 K. Calculate the energy of activation of the reaction assuming that it does not change with temperature.