Class 12 Chemistry - Chapter Alcohols Phenols and Ethers NCERT Solutions | Predict the major product of acid cataly

Explain the following with an example.

(i) Kolbe's reaction.

(ii) Reimer-Tiemann reaction.

(iii) Williamson ether synthesis.

(iv) Unsymmetrical ether.

How are the following conversions carried out?

(i) Propene → Propan-2-ol

(ii) Benzyl chloride → Benzyl alcohol

(iii) Ethyl magnesium chloride → Propan-1-ol.

(iv) Methyl magnesium bromide → 2-Methylpropan-2-ol.

Write the mechanism of acid-catalysed dehydration of ethanol to yield ethene.

Give the equations of reactions for the preparation of phenol from cumene.

Write equations of the following reactions:

(i) Friedel-Crafts reaction-alkylation of anisole.

(ii) Nitration of anisole.

(iii) Bromination of anisole in ethanoic acid medium.

(iv) Friedel-Craft's acetylation of anisole.

Explain why is ortho nitrophenol more acidic than ortho methoxyphenol?

Give two reactions that show the acidic nature of phenol. Compare acidity of phenol with that of ethanol.

Show how are the following alcohols prepared by the reaction of a suitable

Grignard reagent on methanal?

(i)

(ii)

Write the reactions of Williamson synthesis of 2-ethoxy-3-methylpentane starting from ethanol and 3-methylpentan-2-ol.

What is meant by hydroboration-oxidation reaction? Illustrate it with an example.

For the reaction R → P, the concentration of a reactant changes from 0.03 M to 0.02 M in 25 minutes. Calculate the average rate of reaction using units of time both in minutes and seconds.

Write the formulas for the following coordination compounds:

(i) Tetraamminediaquacobalt (III) chloride

(ii) Potassium tetracyanonickelate(II)

(iii) Tris(ethane-1,2-diamine) chromium(III) chloride

(iv) Amminebromidochloridonitrito-N-platinate(II)

(v) Dichloridobis(ethane-1,2-diamine)platinum(IV) nitrate

(vi) Iron(III) hexacyanoferrate(II)

(i) Write structures of different isomeric amines corresponding to the molecular formula, C4H11N

(ii) Write IUPAC names of all the isomers.

(iii) What type of isomerism is exhibited by different pairs of amines?

Why are solids rigid?

Write any two characteristics of Chemisorption.

Write the structures of the following compounds.

(i) α-Methoxypropionaldehyde

(ii) 3-Hydroxybutanal

(iii) 2-Hydroxycyclopentane carbaldehyde

(iv) 4-Oxopentanal

(v) Di-sec-butyl ketone

(vi) 4-Fluoroacetophenone

Which of the ores mentioned in Table 6.1 can be concentrated by magnetic separation method?

Why are pentahalides more covalent than trihalides?

Silver atom has completely filled d orbitals (4d10) in its ground state. How can you say that it is a transition element?

Glucose or sucrose are soluble in water but cyclohexane or benzene (simple six membered ring compounds) are insoluble in water. Explain.

Is it true that under certain conditions, Mg can reduce SiO₂ and Si can reduce MgO? What are those conditions?

Why do noble gases have comparatively large atomic sizes?

Arrange the following compounds in increasing order of their reactivity in nucleophilic addition reactions.

(i)Ethanal, Propanal, Propanone, Butanone.

(ii)Benzaldehyde, p-Tolualdehyde, p-Nitrobenzaldehyde, Acetophenone.

Hint:Consider steric effect and electronic effect.

In a reaction between A and B, the initial rate of reaction (r₀) was measured for different initial concentrations of A and B as given below:

What is the order of the reaction with respect to A and B?

What is the covalence of nitrogen in N₂O₅?

Why is glass considered a super cooled liquid?

The depression in freezing point of water observed for the same amount of acetic acid, trichloroacetic acid and trifluoroacetic acid increases in the order given above. Explain briefly.

Describe the preparation of potassium dichromate from iron chromite ore. What is the effect of increasing pH on a solution of potassium dichromate?

Why is adsorption always exothermic?

Consider a certain reaction A → Products with k = 2.0 x 10^-2 s^-1. Calculate the concentration of A remaining after 100 s if the initial concentration of A is 1.0 mol L^-1.