Class 12 Chemistry - Chapter General Principles and Processes of Isolation of Elements NCERT Solutions | Why copper matte is put in silica lined

What is the significance of leaching in the extraction of aluminium?

Write down the reactions taking place in different zones in the blast furnace during the extraction of iron.

Copper can be extracted by hydrometallurgy but not zinc. Explain.

Outline the principles of refining of metals by the following methods:

(i) Zone refining

(ii) Electrolytic refining

(iii) Vapour phase refining

Name the common elements present in the anode mud in electrolytic refining of copper. Why are they so present ?

The reaction,

      Cr₂O₃  +  2Al    →    Al₂O₃  + 2Cr            (ΔG_o = -421kJ)

is thermodynamically feasible as is apparent from the Gibbs energy value. Why does it not take place at room temperature?

How can you separate alumina from silica in bauxite ore associated with silica? Give equations, if any.

Why is the extraction of copper from pyrites more difficult than that from its oxide ore through reduction?

Write chemical reactions taking place in the extraction of zinc from zinc blende.

Describe a method for refining nickel.

For the reaction R → P, the concentration of a reactant changes from 0.03 M to 0.02 M in 25 minutes. Calculate the average rate of reaction using units of time both in minutes and seconds.

Write the formulas for the following coordination compounds:

(i) Tetraamminediaquacobalt (III) chloride

(ii) Potassium tetracyanonickelate(II)

(iii) Tris(ethane-1,2-diamine) chromium(III) chloride

(iv) Amminebromidochloridonitrito-N-platinate(II)

(v) Dichloridobis(ethane-1,2-diamine)platinum(IV) nitrate

(vi) Iron(III) hexacyanoferrate(II)

(i) Write structures of different isomeric amines corresponding to the molecular formula, C4H11N

(ii) Write IUPAC names of all the isomers.

(iii) What type of isomerism is exhibited by different pairs of amines?

Why are solids rigid?

Write any two characteristics of Chemisorption.

Write the structures of the following compounds.

(i) α-Methoxypropionaldehyde

(ii) 3-Hydroxybutanal

(iii) 2-Hydroxycyclopentane carbaldehyde

(iv) 4-Oxopentanal

(v) Di-sec-butyl ketone

(vi) 4-Fluoroacetophenone

Why are pentahalides more covalent than trihalides?

Silver atom has completely filled d orbitals (4d10) in its ground state. How can you say that it is a transition element?

Glucose or sucrose are soluble in water but cyclohexane or benzene (simple six membered ring compounds) are insoluble in water. Explain.

Write structures of the following compounds:

(i) 2-Chloro-3-methylpentane

(ii) 1-Chloro-4-ethylcyclohexane

(iii) 4-tert. Butyl-3-iodoheptane

(iv) 1,4-Dibromobut-2-ene

(v) 1-Bromo-4-sec. butyl-2-methylbenzene

How is ammonia manufactured industrially?

Refractive index of a solid is observed to have the same value along all directions. Comment on the nature of this solid. Would it show cleavage property?

Mention the conditions required to maximise the yield of ammonia.

[NiCl₄]^2- is paramagnetic while [Ni(CO)₄] is diamagnetic though both are tetrahedral. Why?

A solution is obtained by mixing 300 g of 25% solution and 400 g of 40% solution by mass. Calculate the mass percentage of the resulting solution.

Consider the reaction:

Cr₂ O₇^2- + 14H⁺ + 6e^- → Cr³⁺ + 8H₂O 

What is the quantity of electricity in coulombs needed to reduce 1 mol of Cr₂ O₇^2-?

The rate constant for the decomposition of N₂O₅ at various temperatures is given below:

Draw a graph between ln k and 1/T and calculate the values of A and E_a.

Predict the rate constant at 30 º and 50 ºC.

Arrange the following:

(i) In decreasing order of the pK_bvalues:

C₂H₅NH₂, C₆H₅NHCH₃, (C₂H₅)₂NH and C₆H₅NH₂

(ii) In increasing order of basic strength:

C₆H₅NH₂, C₆H₅N(CH₃)₂, (C₂H₅)₂NH and CH₃NH₂

(iii) In increasing order of basic strength:

(a) Aniline, p-nitroaniline and p-toluidine

(b) C₆H₅NH₂, C₆H₅NHCH₃, C₆H₅CH₂NH₂.

(iv) In decreasing order of basic strength in gas phase:

C₂H₅NH₂, (C₂H₅)₂NH, (C₂H₅)₃N and NH₃

(v) In increasing order of boiling point:

C₂H₅OH, (CH₃)₂NH, C₂H₅NH₂

(vi) In increasing order of solubility in water:

C₆H₅NH₂, (C₂H₅)₂NH, C₂H₅NH₂.

In a reaction between A and B, the initial rate of reaction (r₀) was measured for different initial concentrations of A and B as given below:

What is the order of the reaction with respect to A and B?

What is the basic structural difference between starch and cellulose?